参数资料
型号: EM250-RCM-R
厂商: Silicon Laboratories Inc
文件页数: 25/124页
文件大小: 0K
描述: EM250 RCM BOARD
标准包装: 12
类型: 收发器,802.15.4/Zigbee
频率: 2.4GHz
适用于相关产品: EM250
其它名称: 636-1023
EM250
4.11.3 Internal RC Oscillator
The EM250 has a low-power, low-frequency RC oscillator that runs all the time. Its nominal frequency is
10kHz.
The RC oscillator has a coarse analog trim control, which is first adjusted to get the frequency as close to
10kHz as possible. This raw clock is used by the chip management block. It is also divided down to 1kHz using
a variable divider to allow software to accurately calibrate it. This calibrated clock is available to the sleep
timer.
Timekeeping accuracy depends on temperature fluctuations the chip is exposed to, power supply impedance,
and the calibration interval, but in general it will be better than 150ppm (including crystal error of 40ppm). If
this tolerance is accurate enough for the application, then there is no need to use an external 32.768kHz
crystal oscillator. By removing the 32.768kHz oscillator, the external component count further decreases as
does the Bill of Material cost.
Note:
If the 32.768kHz crystal is not needed, then OSC32A and OSC32B pins should be left open or not
connected.
Table 14 lists the specifications of the RC oscillator.
Table 14. RC Oscillator Specifications
Parameter
Test Conditions
Min.
Typ.
Max.
Unit
Frequency
Analog trim steps
10
1
kHz
kHz
Frequency variation with supply
For a voltage drop from 3.6V to 3.1V or 2.6V
0.75
1.5
%
to 2.1V
4.12 Random Number Generator
The EM250 allows for the generation of random numbers by exposing a randomly generated bit from the RX
ADC. Analog noise current is passed through the RX path, sampled by the receive ADC, and stored in a
register. The value contained in this register could be used to seed a software-generated random number. The
EmberZNet PRO stack utilizes these random numbers to seed the Random MAC Backoff and Encryption Key
Generators.
4.13 Watchdog Timer
The EM250 contains a watchdog timer clocked from the internal oscillator. The watchdog is disabled by
default, but can be enabled or disabled by software.
If the timer reaches its time-out value of approximately 2 seconds, it will generate a reset signal to the chip.
When software is running properly, the application can periodically restart this timer to prevent the reset
signal from being generated.
The watchdog will generate a low watermark interrupt in advance of actually resetting the chip. This low
watermark interrupt occurs approximately 1.75 seconds after the timer has been restarted. This interrupt can
be used to assist during application debug.
Page 25
120-0082-000V Rev 1.1
相关PDF资料
PDF描述
EK42552-02 BOARD EVAL FOR 42552 REV 02
TC25V3A32K7680 OSCILLATOR 32.7680 KHZ 1.5V SMD
7020-01040-0 TRANSFORMER CURRENT 200A
SI1000DK DEVELOPMENT KIT SI101X
7020-01038-0 TRANSFORMER CURRENT 100A
相关代理商/技术参数
参数描述
EM250-RTR 功能描述:IC ZIGBEE SYSTEM-ON-CHIP 48-QFN RoHS:是 类别:RF/IF 和 RFID >> RF 收发器 系列:EM250 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:30 系列:- 频率:4.9GHz ~ 5.9GHz 数据传输率 - 最大:54Mbps 调制或协议:* 应用:* 功率 - 输出:-3dBm 灵敏度:- 电源电压:2.7 V ~ 3.6 V 电流 - 接收:* 电流 - 传输:* 数据接口:PCB,表面贴装 存储容量:- 天线连接器:PCB,表面贴装 工作温度:-25°C ~ 85°C 封装/外壳:68-TQFN 裸露焊盘 包装:管件
EM250-STACK-R 制造商:Silicon Laboratories Inc 功能描述:EM250 BOARD STACK (RCM + BREAKOUT) - Boxed Product (Development Kits) 制造商:Silicon Laboratories Inc 功能描述:BOARD STACK EM250 RCM & BREAKOUT
EM25-12V-DC 制造商:ECLIPSE MAGNETICS 功能描述:HOLDING ELECTRO MAGNET
EM2513N/11560 制造商:ebm-papst Inc 功能描述:- Bulk
EM2524N/11560 制造商:ebm-papst Inc 功能描述:- Bulk