参数资料
型号: EM260-BBRD-128K-USART-R
厂商: Silicon Laboratories Inc
文件页数: 21/50页
文件大小: 0K
描述: EM260 BREAKOUT BOARD
标准包装: 12
类型: 收发器,802.15.4/Zigbee
频率: 2.4GHz
适用于相关产品: EM260
其它名称: 636-1026
EM260
register. The value contained in this register could be used to seed a software-generated random number. The
EmberZNet PRO stack utilizes these random numbers to seed the Random MAC Backoff and Encryption Key
Generators.
4.13 Watchdog Timer
The EM260 contains an internal watchdog timer clocked from the internal oscillator. If the timer reaches its
time-out value of approximately 2 seconds, it will reset the EM260. This reset signal cannot be routed
externally to the Host.
The EM260 firmware will periodically restart the watchdog timer while the firmware is running normally. The
Host cannot effect or configure the watchdog timer.
4.14 Sleep Timer
The 16-bit sleep timer is contained in the always-powered digital block. The clock source for the sleep timer
is a calibrated 1kHz clock. The frequency is slowed down with a 2 N prescaler to generate a final timer
resolution of 1ms. With a 1ms tick and a 16-bit timer, the timer wraps about every 65.5 seconds. The
EmberZNet PRO stack appropriately handles timer wraps allowing the Host to order a theoretical maximum
sleep delay of 4 million seconds.
4.15 Power Management
The EM260 supports four different power modes: active, idle, deep sleep, and power down.
Active mode is the normal, operating state of the EM260.
While in idle mode, code execution halts until any interrupt occurs. All modules of the EM260 including the
radio continue to operate normally. The EmberZNet PRO stack automatically invokes idle as appropriate.
Deep sleep mode and power down mode both power off most of the EM260, including the radio, and leave only
the critical chip functions powered. The internal regulator is disabled and VREG_OUT is turned off. All output
signals are maintained in a frozen state. Upon waking from deep sleep or power down mode, the internal
regulator is re-enabled. Deep sleep and power down result in the same sleep current consumption. The two
sleep modes differ as follows: the EM260 can wake on both an internal timer and an external signal from deep
sleep mode; power down mode can only wake on an external signal.
Page 21
120-0260-000M Rev 1.1
相关PDF资料
PDF描述
EM35X-NCP-ADD-ON-S EM35X ADD ON KIT
EM6J1T2R MOSFET 2P-CH 20V 200MA EMT6
EM6K6T2R MOSFET 2N-CH 20V 300MA EMT6
EM6K7T2R MOSFET 2N-CH 20V 200MA EMT6
EM6M1T2R MOSFET N/P-CH 30V .1A EMT6
相关代理商/技术参数
参数描述
EM260-DEV 功能描述:KIT DEV FOR EM260 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:InSight 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
EM260-RCM-USART-R 功能描述:EM260 RCM BOARD RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
EM260-RTR 功能描述:IC ZIGBEE SYSTEM-ON-CHIP 40-QFN RoHS:是 类别:RF/IF 和 RFID >> RF 收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:30 系列:- 频率:4.9GHz ~ 5.9GHz 数据传输率 - 最大:54Mbps 调制或协议:* 应用:* 功率 - 输出:-3dBm 灵敏度:- 电源电压:2.7 V ~ 3.6 V 电流 - 接收:* 电流 - 传输:* 数据接口:PCB,表面贴装 存储容量:- 天线连接器:PCB,表面贴装 工作温度:-25°C ~ 85°C 封装/外壳:68-TQFN 裸露焊盘 包装:管件
EM260-RTY 功能描述:IC ZIGBEE SYSTEM-ON-CHIP 40-QFN RoHS:是 类别:RF/IF 和 RFID >> RF 收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:30 系列:- 频率:4.9GHz ~ 5.9GHz 数据传输率 - 最大:54Mbps 调制或协议:* 应用:* 功率 - 输出:-3dBm 灵敏度:- 电源电压:2.7 V ~ 3.6 V 电流 - 接收:* 电流 - 传输:* 数据接口:PCB,表面贴装 存储容量:- 天线连接器:PCB,表面贴装 工作温度:-25°C ~ 85°C 封装/外壳:68-TQFN 裸露焊盘 包装:管件
EM260-USART-JMP-R 功能描述:KIT JUMP START FOR EM260 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:JumpStart 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796