- 您现在的位置：买卖IC网 > PDF目录15273 > LTC3731CG#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 36-SSOP PDF资料下载
参数资料
| 型号： | LTC3731CG#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/34页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 36-SSOP |
| 标准包装： | 2,000 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 750kHz |
| 占空比： | 98.5% |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 36-SSOP（0.209"，5.30mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
LTC3731
OPERATION
Main Control Loop
(Refer to Functional Diagram)
Low Current Operation
The IC uses a constant frequency, current mode step-down
architecture. During normal operation, each top MOSFET
is turned on each cycle when the oscillator sets the RS
latch, and turned off when the main current comparator, I 1 ,
resets each RS latch. The peak inductor current at which I 1
resets the RS latch is controlled by the voltage on the I TH
pin, which is the output of the error amplifier EA. The EAIN
pin receives a portion of output voltage feedback signal via
the DIFFOUT pin through the external resistive divider and
is compared to the internal reference voltage. When the
load current increases, it causes a slight decrease in the
EAIN pin voltage relative to the 0.6V reference, which in
turn causes the I TH voltage to increase until each inductor’s
average current matches one third of the new load current
(assuming all three current sensing resistors are equal).
In Burst Mode operation and Stage Shedding mode, after
each top MOSFET has turned off, the bottom MOSFET is
turned on until either the inductor current starts to reverse,
as indicated by current comparator I 2 , or the beginning
of the next cycle.
The top MOSFET drivers are biased from floating bootstrap
capacitor C B , which is normally recharged through an
external Schottky diode when the top FET is turned off.
When V IN decreases to a voltage close to V OUT , however,
the loop may enter dropout and attempt to turn on the
top MOSFET continuously. The dropout detector counts
the number of oscillator cycles that the bottom MOSFET
remains off and periodically forces a brief on period to
allow C B to recharge.
The main control loop is shut down by pulling the RUN/
SS pin low. Releasing RUN/SS allows an internal 1.5μA
current source to charge soft-start capacitor C SS . When
C SS reaches 1.5V, the main control loop is enabled and the
internally buffered I TH voltage is clamped but allowed to
ramp as the voltage on C SS continues to ramp. This “soft-
start” clamping prevents abrupt current from being drawn
from the input power source. When the RUN/SS pin is low,
all functions are kept in a controlled state. The RUN/SS
pin is pulled low when the supply input voltage is below
4V, when the undervoltage lockout pin (UVADJ) is below
1.2V, or when the IC die temperature rises above 150°C.
The FCB pin is a logic input to select between three modes
of operation.
A) Burst Mode Operation
When the FCB pin voltage is below 0.6V, the controller
performs as a continuous, PWM current mode synchro-
nous switching regulator. The top and bottom MOSFETs
are alternately turned on to maintain the output voltage
independent of direction of inductor current. When the
FCB pin is below V CC –?1.5V but greater than 0.6V, the
controller performs as a Burst Mode switching regulator.
Burst Mode operation sets a minimum output current
level before turning off the top switch and turns off the
synchronous MOSFET(s) when the inductor current goes
negative. This combination of requirements will, at low
current, force the I TH pin below a voltage threshold that
will temporarily shut off both output MOSFETs until the
output voltage drops slightly. There is a burst comparator
having 60mV of hysteresis tied to the I TH pin. This hysteresis
results in output signals to the MOSFETs that turn them on
for several cycles, followed by a variable “sleep” interval
depending upon the load current. The resultant output
voltage ripple is held to a very small value by having the
hysteretic comparator after the error amplifier gain block.
B) Stage Shedding Operation
When the FCB pin is tied to the V CC pin, Burst Mode
operation is disabled and the forced minimum inductor
current requirement is removed. This provides constant
frequency, discontinuous current operation over the
widest possible output current range. At approximately
10% of maximum designed load current, the second and
third output stages are shut off and the phase 1 control-
ler alone is active in discontinuous current mode. This
“stage shedding” optimizes efficiency by eliminating the
gate charging losses and switching losses of the other
two output stages. Additional cycles will be skipped when
the output load current drops below 1% of maximum
designed load current in order to maintain the output
voltage. This stage shedding operation is not as efficient
as Burst Mode operation at very light loads, but does
provide lower noise, constant frequency operating mode
down to very light load conditions.
3731fc
11
相关PDF资料 |
PDF描述 |
|---|---|
| VI-J5J-EW-F4 | CONVERTER MOD DC/DC 36V 100W |
| VI-J5J-EW-F2 | CONVERTER MOD DC/DC 36V 100W |
| LTC3736EGN-1 | IC REG CTRLR BUCK PWM CM 24-SSOP |
| VI-J5J-EW-F1 | CONVERTER MOD DC/DC 36V 100W |
| VI-J54-EW-F4 | CONVERTER MOD DC/DC 48V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3731CUH | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CUH#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BUCK, 600KHZ, 240A, QFN |
| LTC3731CUH#TR | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。