参数资料
型号: LTC3731CG#TRPBF
厂商: Linear Technology
文件页数: 9/34页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 36-SSOP
标准包装: 2,000
系列: PolyPhase®
PWM 型: 电流模式
输出数: 1
频率 - 最大: 750kHz
占空比: 98.5%
电源电压: 4 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: 0°C ~ 70°C
封装/外壳: 36-SSOP(0.209",5.30mm 宽)
包装: 带卷 (TR)
LTC3731
PIN FUNCTIONS
BG1 to BG3: High Current Gate Drives for Bottom N-Channel
MOSFETs. Voltage swing at these pins is from ground to
V CC .
BOOST1 to BOOST3: Positive Supply Pins to the Topside
Floating Drivers. Bootstrapped capacitors, charged with
external Schottky diodes and a boost voltage source, are
connected between the BOOST and SW pins. Voltage swing
at the BOOST pins is from boost source voltage (typically
V CC ) to this boost source voltage + V IN (where V IN is the
external MOSFET supply rail).
CLKOUT: Output clock signal available to synchronize
other controller ICs for additional MOSFET stages/phases.
DIFFOUT: Output of the Remote Output Voltage Sensing
Differential Amplifier.
EAIN: This is the input to the error amplifier that compares
the feedback voltage to the internal 0.6V reference voltage.
FCB: Forced Continuous Control Input. The voltage ap-
plied to this pin sets the operating mode of the controller.
The forced continuous current mode is active when the
applied voltage is less than 0.6V. Burst Mode operation
will be active when the pin is allowed to float and a Stage
Shedding mode will be active if the pin is tied to the V CC
pin. (Do not apply voltage directly to this pin prior to the
application of voltage on the V CC pin.)
PGOOD: This open-drain output is pulled low when the
output voltage has been outside the PGOOD tolerance
window for the V PGDLY delay of approximately 100μs.
IN + , IN – : Inputs to a precision, unity-gain differential
amplifier with internal precision resistors. This provides
true remote sensing of both the positive and negative load
terminals for precise output voltage control.
I TH : Error Amplifier Output and Switching Regulator Com-
pensation Point. All three current comparator’s thresholds
increase with this control voltage.
PGND: Driver Power Ground. This pin connects directly to the
sources of the bottom N-channel external MOSFETs and the
(–) terminals of C IN .
PHASMD: This pin determines the phase shift between the
first controller’s rising TG signal and the rising edge of
the CLKOUT signal. Logic 0 yields 30 degrees and Logic?1
yields 60 degrees.
Note: the PHASMD and PGOOD functions are internally
tied together in the LTC3731 UH package.
PLLIN: Synchronization Input to Phase Detector. This pin is
internally terminated to SGND with 50kΩ. The phase-locked
loop will force the rising top gate signal of controller 1 to
be synchronized with the rising edge of the PLLIN signal.
PLLFLTR: The phase-locked loop’s lowpass filter is tied
to this pin. Alternatively, this pin can be driven with an AC
or DC voltage source to vary the frequency of the internal
oscillator. (Do not apply voltage directly to this pin prior
to the application of voltage on the V CC pin.)
RUN/SS: Combination of Soft-Start, Run Control Input
and Short-Circuit Detection Timer. A capacitor to ground
at this pin sets the ramp time to full current output as well
as the time delay prior to an output voltage short-circuit
shutdown. A minimum value of 0.01μF is recommended
on this pin.
SENSE1 + , SENSE2 + , SENSE3 + , SENSE1 – , SENSE2 – ,
SENSE3 – : The Inputs to Each Differential Current Com-
parator. The I TH pin voltage and built-in offsets between
SENSE – and SENSE + pins, in conjunction with R SENSE , set
the current trip threshold level.
SGND: Signal Ground. This pin must be routed separately
under the IC to the PGND pin and then to the main ground
plane. The exposed pad on the LTC3731 UH package is
SGND and must be soldered to the PCB.
SW1 to SW3: Switch Node Connections to Inductors.
Voltage swing at these pins is from a Schottky diode
(external) voltage drop below ground to V IN (where V IN
is the external MOSFET supply rail).
TG1 to TG3: High Current Gate Drives for Top N-channel
MOSFETs. These are the outputs of floating drivers with
a voltage swing equal to the boost voltage source super-
imposed on the switch node voltage SW.
UVADJ: Input to the Undervoltage Shutdown Compara-
tor. When the applied input voltage is less than 1.2V, this
comparator turns off the output MOSFET driver stages
and discharges the RUN/SS capacitor.
3731fc
9
相关PDF资料
PDF描述
VI-J5J-EW-F4 CONVERTER MOD DC/DC 36V 100W
VI-J5J-EW-F2 CONVERTER MOD DC/DC 36V 100W
LTC3736EGN-1 IC REG CTRLR BUCK PWM CM 24-SSOP
VI-J5J-EW-F1 CONVERTER MOD DC/DC 36V 100W
VI-J54-EW-F4 CONVERTER MOD DC/DC 48V 100W
相关代理商/技术参数
参数描述
LTC3731CUH 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3731CUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3731CUH#PBF 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BUCK, 600KHZ, 240A, QFN
LTC3731CUH#TR 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3731CUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX