参数资料
型号: LTC3839EUH#PBF
厂商: Linear Technology
文件页数: 10/50页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 73
系列: PolyPhase®
PWM 型: 电流模式
输出数: 1
频率 - 最大: 2MHz
电源电压: 4.5 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 管件
LTC3839
PIN FUNCTIONS
PGOOD (Pin 13): Power Good Indicator Output. This
open-drain logic output is pulled to ground when the
output voltage goes out of a ±7.5% window around the
regulation point, after a 50μs power-bad-masking delay.
Returning to the regulation point, there is a 20μs delay to
power good, and a hysteresis of around 2% on both sides
of the voltage window.
BOOST1, BOOST2 (Pin 14, Pin 27): Boosted Floating
Supplies for Top MOSFET Drivers. The (+) terminal of the
bootstrap capacitor, C B , connects to this pin. The BOOST
pins swing by a V IN between a diode drop below DRV CC ,
or (DRV CC – V D ) and (V IN + DRV CC – V D ).
TG1, TG2 (Pin 15, Pin 26): Top Gate Driver Outputs. The
TG pins drive the gates of the top N-channel power MOSFET
with a voltage swing of V DRVCC between SW and BOOST.
SW1, SW2 (Pin 16, Pin 25): Switch Node Connection to
Inductors. Voltage swings are from a diode voltage below
ground to V IN . The (–) terminal of the bootstrap capacitor,
C B , connects to this node.
BG1, BG2 (Pin 17, Pin 24): Bottom Gate Driver Outputs.
The BG pins drive the gates of the bottom N-channel power
MOSFET between PGND and DRV CC .
DRV CC1 , DRV CC2 (Pin 18, Pin 23): Supplies of Bottom
Gate Drivers. DRV CC1 is also the output of an internal 5.3V
regulator. DRV CC2 is also the output of the EXTV CC switch.
Normally the two DRV CC pins are shorted together on the
PCB, and decoupled to PGND with a minimum of 4.7μF
ceramic capacitor, C DRVCC .
V IN (Pin 19): Input Voltage Supply. The supply voltage
can range from 4.5V to 38V. For increased noise immunity
decouple this pin to SGND with an RC filter. Voltage at this
pin is also used to adjust top gate on-time, therefore it
is recommended to tie this pin to the main power input
supply through an RC filter.
PGND (Pin 20, Exposed Pad Pin 33): Power Ground.
Connect this pin as close as practical to the source of
C DRVCC and the (–) terminal of C IN . Connect the exposed
pad and PGND pin to SGND pin using a single PCB trace
under the IC. The exposed pad must be soldered to the
circuit board ground for electrical connection and rated
thermal performance.
INTV CC (Pin 21): Supply Input for Internal Circuitry (Not
Including Gate Drivers). Normally powered from the DRV CC
pins through a decoupling RC filter to SGND (typically
2Ω and 1μF).
EXTV CC (Pin 22): External Power Input. When EXTV CC
exceeds the switchover voltage (typically 4.6V), an internal
switch connects this pin to DRV CC2 and shuts down the
internal regulator so that INTV CC and gate drivers draw
power from EXTV CC . The V IN pin still needs to be powered
up but draws minimum current.
RUN (Pin 28): Run Control Inputs. An internal propor-
tional-to-absolute-temperature (PTAT) pull-up current
source (~2.5μA at 25°C) is constantly connected to this
pin. Taking the RUN pin below a threshold voltage (~0.8V
at 25°C) shuts down all bias of INTV CC and DRV CC and
places the LTC3839 into micropower shutdown mode.
Allowing the RUN pin to rise above this threshold would
turn on the internal bias supply and the circuitry. When
the RUN pin rises above 1.2V, both channels’ TG and BG
drivers are turned on and an additional 10μA temperature-
independent pull-up current is connected internally to the
RUN pin. The RUN pin can sink up to 100μA, or be forced
no higher than 6V.
V RNG (Pin 32): Current Sense Voltage Range Input. When
programmed between 0.6V and 2V, the voltage applied to
V RNG is twenty times (20 × ) the maximum sense voltage
between SENSE1,2 + and SENSE1,2 – , i.e., for either chan-
nel, (V SENSE+ – V SENSE– ) = 0.05 ? V RNG . If a V RNG is tied
to SGND, the channel operates with a maximum sense
voltage of 30mV, equivalent to a V RNG of 0.6V; If tied to
INTV CC , a maximum sense voltage of 50mV, equivalent
to a V RNG of 1V.
the bottom N-channel power MOSFET, the (–) terminal of
3839fa
10
相关PDF资料
PDF描述
LTC3850IGN-2#TRPBF IC REG CTRLR BUCK PWM CM 28-SSOP
LTC3850IGN#PBF IC REG CTRLR BUCK PWM CM 28-SSOP
LTC3851EGN#PBF IC REG CTRLR BUCK PWM CM 16-SSOP
LTC3851EMSE-1#PBF IC REG CTRLR BUCK PWM CM 16-MSOP
LTC3852EUDD#PBF IC REG CTRLR DOUBLER PWM 24-QFN
相关代理商/技术参数
参数描述
LTC3839IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3839IUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3850EGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3850EGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3850EGN-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)