- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3839EUH#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 32-QFN PDF资料下载
参数资料
| 型号： | LTC3839EUH#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 18/50页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 32-QFN |
| 标准包装： | 73 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
LTC3839
APPLICATIONS INFORMATION
Inductor Core Selection
Once the value for L is known, the type of inductor must
be selected. The two basic types are iron powder and fer-
rite. The iron powder types have a soft saturation curve
which means they do not saturate hard like ferrites do.
However, iron powder type inductors have higher core
losses. Ferrite designs have very low core loss and are
preferred at high switching frequencies, so design goals
can concentrate on copper loss and preventing saturation.
Core loss is independent of core size for a fixed inductor
value, but it is very dependent on inductance selected. As
inductance increases, core losses go down. Unfortunately,
increased inductance requires more turns of wire and
therefore copper losses will increase.
Ferrite core material saturates hard , which means that in-
ductance collapses abruptly when the peak design current
is exceeded. This results an abrupt increase in inductor
ripple current and consequent output voltage ripple. Do
not allow the core to saturate!
A variety of inductors designed for high current, low volt-
age applications are available from manufacturers such as
Sumida, Panasonic, Coiltronics, Coilcraft, Toko, Vishay,
Pulse and Würth.
Current Sense Pins
Inductor current is sensed through voltage between
SENSE + and SENSE – pins, the inputs of the internal current
comparators. The input voltage range of the SENSE pins is
–0.5V to 5.5V. Care must be taken not to float these pins
during normal operation. The SENSE + pins are quasi-high
impedance inputs. There is no bias current into a SENSE +
pin when its corresponding channel’s SENSE – pin ramps
up from below 1.1V and stays below 1.4V. But there is a
small (~1μA) current flowing into a SENSE + pin when its
corresponding SENSE – pin ramps down from 1.4V and
stays above 1.1V. Such currents also exist on SENSE – pins.
But in addition, each SENSE – pin has an internal 500k
resistor to SGND. The resulted current (V OUT /500k) will
dominate the total current flowing into the SENSE – pins.
SENSE + and SENSE – pin currents have to be taken into
account when designing either R SENSE or DCR inductor
current sensing.
Current Limit Programming
The current sense comparators’ maximum trip voltage
between SENSE + and SENSE – (or “sense voltage”), when
ITH is clamped at its maximum 2.4V, is set by the voltage
applied to the V RNG pin and is given by:
V SENSE(MAX) = 0.05V RNG
The valley current mode control loop does not allow the
inductor current valley to exceed 0.05V RNG . Note that ITH
is close to 2.4V when in current limit.
An external resistive divider from INTV CC can be used to set
the voltage on a V RNG pin between 0.6V and 2V, resulting
in a maximum sense voltage between 30mV and 100mV.
Such wide voltage range allows for variety of applications.
The V RNG pin can also be tied to either SGND or INTV CC
to force internal defaults. When V RNG is tied to SGND, the
device has an equivalent V RNG of 0.6V. When the V RNG pin
is tied to INTV CC , the device has an equivalent V RNG of 2V.
Sufficient margin should be allowed to account for IC
and external component tolerances. The Electrical Char-
acteristics (EC) table gives the maximum valley current
sense threshold, V SENSE(MAX)1,2 , which is the guaranteed
specification over the operating junction temperature range
for either of the two channels of LTC3839. When designing
an application, the maximum value in the EC table should
always be used to assure that the maximum possible
current in a single channel does not exceed the rating of
the external components, such as power MOSFETs and
inductors, in a worse case fault condition.
To ensure a multiphase single-output application can deliver
its desired full load current, the minimum output current
capability of the application can be determined from the
lower limits of V SENSE(MAX) . For LTC3839, this can be done
using either worst-case or statistical tolerancing. Worst-
case tolerancing is the most conservative and is calculated
from the minimum value of the single channel V SENSE(MAX)
in the EC table, multiplied by the number of phases (e.g.,
2x in a 2-phase application). Statistical tolerancing takes
into consideration the distribution of both current limit
channels to predict the effective statistical limits of the sum
of multiple channels’ V SENSE(MAX) . Based on distributions
over temperature of the 2-channel-sum [V SENSE(MAX)1 +
V SENSE(MAX)2 ] from the characterization LTC3839, the
3839fa
18
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3850IGN-2#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3850IGN#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3851EGN#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC3851EMSE-1#PBF | IC REG CTRLR BUCK PWM CM 16-MSOP |
| LTC3852EUDD#PBF | IC REG CTRLR DOUBLER PWM 24-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3839IUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3839IUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3850EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3850EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3850EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。