- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3839EUH#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 32-QFN PDF资料下载
参数资料
| 型号： | LTC3839EUH#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 20/50页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 32-QFN |
| 标准包装： | 73 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
LTC3839
APPLICATIONS INFORMATION
filter placed near the IC has been traditionally used to
reduce the effects of capacitive and inductive noise coupled
in the sense traces on the PCB. A typical filter consists of
two series 10Ω resistors connected to a parallel 1000pF
V SENSE
capacitor, resulting in a time constant of 20ns.
This same RC filter, with minor modifications, can be
used to extract the resistive component of the current
20mV/DIV
V ESL(STEP)
500ns/DIV
sense signal in the presence of parasitic inductance.
For example, Figure 4a illustrates the voltage waveform
across a 2mΩ sense resistor with a 2010 footprint for a
1.2V/15A converter operating at 100% load. The waveform
is the superposition of a purely resistive component and a
purely inductive component. It was measured using two
scope probes and waveform math to obtain a differential
measurement. Based on additional measurements of the
inductor ripple current and the on-time and off-time of
the top switch, the value of the parasitic inductance was
determined to be 0.5nH using the equation:
3839 F04a
Figure 4a. Voltage Waveform Measured
Directly Across the Sense Resistor
V SENSE
20mV/DIV
V ESL(STEP) t ON ? t OFF
Δ I L
t ON + t OFF
500ns/DIV
ESL=
?
3839 F04b
Figure 4b. Voltage Waveform Measured After the
where V ESL(STEP) is the voltage step caused by the ESL
and shown in Figure 4a, and t ON and t OFF are top MOSFET
on-time and off-time respectively. If the RC time constant
is chosen to be close to the parasitic inductance divided by
the sense resistor (L/R), the resulting waveform looks re-
sistive again, as shown in Figure 4b. For applications using
low V SENSE(MAX) , check the sense resistor manufacturer’s
data sheet for information about parasitic inductance. In
the absence of data, measure the voltage drop directly
across the sense resistor to extract the magnitude of the
ESL step and use the equation above to determine the ESL.
However, do not over filter. Keep the RC time constant less
than or equal to the inductor time constant to maintain a
high enough ripple voltage on V RSENSE .
Note that the SENSE1 – and SENSE2 – pins are also used
for sensing the output voltage for the adjustment of top
gate on time, t ON . For this purpose, there is an additional
internal 500k resistor from each SENSE – pin to SGND,
therefore there is an impedance mismatch with their cor-
responding SENSE + pins. The voltage drop across the
R F causes an offset in sense voltage. For example, with
R F = 100Ω, at V OUT = V SENSE– = 5V, the sense-voltage
Sense Resistor Filter. C F = 1000pF, R F = 100Ω
offset V SENSE(OFFSET) = V SENSE– ? R F /500k = 1mV. Such
small offset may seem harmless for current limit, but
could be significant for current reversal detection (I REV ),
causing excess negative inductor current at discontinuous
mode. Also, at V SENSE(MAX) = 30mV, a mere 1mV offset
will cause a significant shift of zero-current ITH voltage
by (2.4V – 0.8V) ? 1mV/30mV = 53mV. Too much shift
may not allow the output voltage to return to its regulated
value after the output is shorted due to ITH foldback.
Therefore, when a larger filter resistor R F value is used,
it is recommended to use an external 500k resistor from
each SENSE + pin to SGND, to balance the internal 500k
resistor at its corresponding SENSE – pin.
The previous discussion generally applies to high density/
high current applications where I OUT(MAX) > 10A and low
inductor values are used. For applications where I OUT(MAX)
< 10A, set R F to 10Ω and C F to 1000pF. This will provide
a good starting point.
The filter components need to be placed close to the IC.
The positive and negative sense traces need to be routed
3839fa
20
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3850IGN-2#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3850IGN#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3851EGN#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC3851EMSE-1#PBF | IC REG CTRLR BUCK PWM CM 16-MSOP |
| LTC3852EUDD#PBF | IC REG CTRLR DOUBLER PWM 24-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3839IUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3839IUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3850EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3850EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3850EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。