- 您现在的位置：买卖IC网 > PDF目录1832 > LTC3839EUH#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 32-QFN PDF资料下载
参数资料
| 型号： | LTC3839EUH#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/50页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 32-QFN |
| 标准包装： | 73 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
LTC3839
OPERATION (Refer to Functional Diagram)
Power Good and Fault Protection
The PGOOD pin is connected to an internal open-drain
N-channel MOSFET. An external resistor or current
source can be used to pull this pin up to 6V (e.g., V OUT
or DRV CC ). Overvoltage or undervoltage comparators
(OV, UV) turn on the MOSFET and pull the PGOOD pin low
when the feedback voltage is outside the ±7.5% window
of the 0.6V reference voltage. The PGOOD pin is also
pulled low when the RUN pin is below the 1.2V threshold
(hysteresis applies), or in undervoltage lockout (UVLO).
Note that feedback voltage is sensed differentially through
V OUTSENSE+ with respect to V OUTSENSE– .
When the feedback voltage is within the ±7.5% window,
the open-drain NMOS is turned off and the pin is pulled
up by the external source. The PGOOD pin will indicate
power good immediately after the feedback is within the
window. But when a feedback voltage of a channel goes
out of the window, there is an internal 50μs delay before
its PGOOD is pulled low. In an overvoltage (OV) condition,
M T is turned off and M B is turned on immediately without
delay and held on until the overvoltage condition clears.
Foldback current limiting is provided if the output is below
one-half of the regulated voltage, such as being shorted to
ground. As the feedback approaches 0V, the internal clamp
voltage for the ITH pin drops from 2.4V to around 1.3V,
which reduces the inductor valley current level to about
30% of its maximum value. Foldback current limiting is
disabled at start-up.
Frequency Selection and External Clock
Synchronization
An internal oscillator (clock generator) provides phase-
interleaved internal clock signals for individual channels
to lock up to. The switching frequency and phase of each
switching channel are independently controlled by adjust-
ing the top MOSFET turn-on time (on-time) through the
one-shot timer. This is achieved by sensing the phase
relationship between a top MOSFET turn-on signal and
its internal reference clock through a phase detector, and
the time interval of the one-shot timer is adjusted on a
cycle-by-cycle basis, so that the rising edge of the top
MOSFET turn-on is always trying to synchronize to the
internal reference clock signal for the respective channel.
The frequency of the internal oscillator can be programmed
from 200kHz to 2MHz by connecting a resistor, R T , from the
RT pin to signal ground (SGND). The RT pin is regulated
to 1.2V internally.
For applications with stringent frequency or interference
requirements, an external clock source connected to the
MODE/PLLIN pin can be used to synchronize the internal
clock signals through a clock phase-locked loop (Clock
PLL). The LTC3839 operates in forced continuous mode
of operation when it is synchronized to the external clock.
The external clock frequency has to be within ±30% of the
internal oscillator frequency for successful synchroniza-
tion. The clock input levels should be no less than 2V for
“high” and no greater than 0.5V for “low”. The MODE/
PLLIN pin has an internal 600k pull-down resistor.
3839fa
14
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3850IGN-2#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3850IGN#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3851EGN#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC3851EMSE-1#PBF | IC REG CTRLR BUCK PWM CM 16-MSOP |
| LTC3852EUDD#PBF | IC REG CTRLR DOUBLER PWM 24-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3839IUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3839IUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3850EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3850EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3850EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。