- 您现在的位置：买卖IC网 > PDF目录80580 > M30102F3TFP 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP48 PDF资料下载
参数资料
| 型号： | M30102F3TFP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP48 |
| 封装： | 7 X 7 MM, 0.50 MM PITCH, PLASTIC, LQFP-48 |
| 文件页数： | 18/166页 |
| 文件大小： | 2060K |
| 代理商： | M30102F3TFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页第161页第162页第163页第164页第165页第166页
Under
development
Tentative Specifications REV.E1
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M30100/M30102 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
A-D Converter
111
A-D Converter
The A-D converter consists of one 10-bit successive approximation A-D converter circuit with a capacitive
coupling amplifier. Pins P00 to P07, P10 to P13, P40 and P41 also function as the analog signal input pins.
The direction registers of these pins for A-D conversion must therefore be set to input. The Vref connect bit
(bit 5 at address 00D716) can be used to isolate the resistance ladder of the A-D converter from the refer-
ence voltage input pin (VREF) when the A-D converter is not used. Doing so stops any current flowing into
the resistance ladder from VREF, reducing the power dissipation. When using the A-D converter, start A-D
conversion only after connecting to VREF.
The result of A-D conversion is stored in the A-D registers. When set to 10-bit precision, the low 8 bits are
stored in the even addresses and the high 2 bits in the odd addresses. When set to 8-bit precision, the low
8 bits are stored in the even addresses.
Table 1.16.1 shows the performance of the A-D converter. Figure 1.16.1 shows the block diagram of the A-
D converter, and Figures 1.16.2 and 1.16.3 show the A-D converter-related registers.
Table 1.16.1. Performance of A-D converter
Item
Performance
Method of A-D conversion Successive approximation (capacitive coupling amplifier)
Analog input voltage (Note 1) 0V to VCC
Operating clock
φAD (Note 2) VCC = 5V
fAD, divide-by-2 of fAD, divide-by-4 of fAD, fAD=f(XIN)
VCC = 3V
divide-by-2 of fAD, divide-by-4 of fAD, fAD=f(XIN)
Resolution
8-bit or 10-bit (selectable)
Absolute precision
VCC = 5V
Without sample and hold function
±3LSB
With sample and hold function (8-bit resolution)
±2LSB
With sample and hold function (10-bit resolution)
AN0 to AN11 input :
±3LSB
ANEX0 and ANEX1 input (including mode in which external
operation amp is connected) :
±7LSB
VCC = 3V
Without sample and hold function (8-bit resolution)
±2LSB
Operating modes
One-shot mode and repeat mode (Note 3)
Analog input pins
12 pins (AN0 to AN11) + 2 pins (ANEX0 to ANEX1)
A-D conversion start condition Software trigger
A-D conversion starts when the A-D conversion start flag changes to “1”
Conversion speed per pin Without sample and hold function
8-bit resolution: 49
φAD cycles, 10-bit resolution: 59 φAD cycles
With sample and hold function
8-bit resolution: 28
φAD cycles, 10-bit resolution: 33 φAD cycles
Note 1: Does not depend on use of sample and hold function.
Note 2: Divide fAD if (XIN) exceeds 10MHz, and make
φAD equal to or lower than 10MHz. Also if Vcc is less
than 4.2V or an external RC circuit is used for the main clock, divide fAD and make
φAD equal to or
lower than fAD/2.
Without sample and hold function, set the
φAD frequency to 250kHz min.
With the sample and hold function, set the
φAD frequency to 1MHz min.
Note 3: In repeat mode, only 8-bit mode can be used.
相关PDF资料 |
PDF描述 |
|---|---|
| M37481M8-XXXFP | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP44 |
| M37481M8T-XXXSP | 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PDIP42 |
| MB96F356ASAPMC-GE2 | 16-BIT, FLASH, 56 MHz, MICROCONTROLLER, PQFP64 |
| MB96F356RWAPMC1-GSE2 | 16-BIT, FLASH, 56 MHz, MICROCONTROLLER, PQFP64 |
| MB95F204KP-G-SH-SNE2 | 8-BIT, FLASH, 16.25 MHz, MICROCONTROLLER, PDIP24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M30102T-PTC | 制造商:Renesas Electronics Corporation 功能描述:DEV 48PIN .5MM QFP CNVTR FOR M30100T-PRB - Bulk |
| M30-1050046 | 功能描述:集管和线壳 FML CRIMP CONTACT 1.25MM,AWG 26-30, RL RoHS:否 产品种类:1.0MM Rectangular Connectors 产品类型:Headers - Pin Strip 系列:DF50 触点类型:Pin (Male) 节距:1 mm 位置/触点数量:16 排数:1 安装风格:SMD/SMT 安装角:Right 端接类型:Solder 外壳材料:Liquid Crystal Polymer (LCP) 触点材料:Brass 触点电镀:Gold 制造商:Hirose Connector |
| M30-1060046 | 功能描述:集管和线壳 FML CRIMP CONTACT 1.25MM,AWG 26-30,LSE RoHS:否 产品种类:1.0MM Rectangular Connectors 产品类型:Headers - Pin Strip 系列:DF50 触点类型:Pin (Male) 节距:1 mm 位置/触点数量:16 排数:1 安装风格:SMD/SMT 安装角:Right 端接类型:Solder 外壳材料:Liquid Crystal Polymer (LCP) 触点材料:Brass 触点电镀:Gold 制造商:Hirose Connector |
| M3010A | 制造商:Honeywell Sensing and Control 功能描述:GENERAL MARKET VRS |
| M3010A25 | 制造商:Honeywell Sensing and Control 功能描述:GENERAL MARKET VRS |
发布紧急采购，3分钟左右您将得到回复。