参数资料
型号: NCP1910GEVB
厂商: ON Semiconductor
文件页数: 34/37页
文件大小: 0K
描述: BOARD DEMO NCP1910DEMO-B-TLS
设计资源: NCP1910 Schematic
NCP1910GEVB BOM
标准包装: 1
主要目的: DC/DC,步降
输出及类型: 1,非隔离
输出电压: 最低可调至 0.8V
电流 - 输出: 3A
输入电压: 3 ~ 5.5 V
稳压器拓扑结构: 降压
频率 - 开关: 1MHz
板类型: 完全填充
已供物品:
已用 IC / 零件: NCP1910
其它名称: NCP1910GEVBOS
NCP1910
LLC High ? Voltage Driver
The NCP1910 includes a high ? voltage driver allowing a
direct connection to the upper side MOSFET of LLC
converter. This device also incorporates an upper UVLO
circuitry that makes sure enough gate voltage is available for
the upper side MOSFET. The bias of the floating driver
section is provided by C boot capacitor between V boot pin and
HB pin that is refilled by external booststrap diode. The
floating portion can go up to 600 Vdc and makes the IC
perfectly suitable for offline applications featuring a 400 V
PFC front ? end stage.
Combo Management Section
Start ? up and Stop Delay of LLC and Pgout signal
(t DEL1 and t DEL2 )
To ensure the proper operation of LLC, LLC cannot start
if the PFC is not ready.
As depicted in the “PFCok signal” section, the internal
PFCok signal is asserted high when V bulk is above 95% of
normal bulk voltage. After PFCok signal is high, a timer
(t DEL1 ) starts to ensure PFC stage is fully stable before LLC
starts. When t DEL1 is elapsed, PG out pin is grounded and
LLC starts its driver outputs (ML and MU pins).
another timer (t DEL2 ) starts. Once the t DEL2 is elapsed, LLC
stops its drivers (ML and MU pins).
Figure 61 depicts the start ? up and stop delay of LLC and
PG out .
Once the PFC is ready (PFCok is asserted high), t DEL1
(20 ms typically) is started. Once this delay is elapsed:
? PG out pin is asserted low
? LLC drivers (ML and MU pins) can start to operate.
As shutdown by unplug ac input, V bulk decreases:
? When it reaches the PG signal, which is adjusted by
PG adj pin, PG out pin is released open.
? If V bulk reaches the LLC stop level (BO level adjusted
by BO adj pin), the LLC stops; or if V bulk drops slowly,
e.g. light load, LLC drivers (ML and MU pins) will
stop 5 ms after PG out pin is released (t DEL2 ).
As shutdown by line brown ? out situation, PFCok signal will
be pulled down:
? PG out pin is released open once this internal PFCok
signal is low.
? LLC drivers (ML and MU pins) will stop 5 ms after
PG out pin is released open (t DEL2 ).
In case of shutdown by unplugging ac input or line brown
out situation, PG out signal is released open. And then
V bulk
95%
PG level
t DEL1
BO level
20 ms
PG out
t DEL2
LLC works
off
5 ms
Figure 61. The Timing for t DEL1 and t DEL2
off
time
Remote on/off (on/off pin)
NCP1910 reserves one dedicated pin for remote control
feature at on/off pin:
? When the on/off pin is pulled below 1 V, the PFC starts
operation. 20 ms after V bulk is above 95% of target
level, LLC starts.
? When the on/off pin is above 3 V, the device stops both
PFC and LLC immediately and keeps low
consumption. Figure 62 depicts the relationship
between the operation mode and on/off pin.
http://onsemi.com
34
相关PDF资料
PDF描述
NCP3418BMNR2G IC MOSFET DRIVER DUAL 12V 10-DFN
NCP3418DR2 IC MOSFET DRIVER DUAL 12V 8-SOIC
NCP3420DR2G IC MOSFET DRIVER DUAL 12V 8-SOIC
NCP3488DR2G IC MOSFET DRVR DUAL 12V 8-SOIC
NCP5007SNT1 IC LED DRIVR WHT COMPACT 5TSOP
相关代理商/技术参数
参数描述
NCP1927DR2G 功能描述:功率因数校正 IC PFC AND FLYBACK CONTROLER RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
NCP1937A1DR2G 制造商:ON Semiconductor 功能描述:COMBO PFC & QUAZI FLYBACK - Tape and Reel 制造商:ON Semiconductor 功能描述:REEL / COMBO PFC & QUAZI FLYBACK
NCP1937B1DR2G 制造商:ON Semiconductor 功能描述:COMBO PFC & QUAZI FLYBACK - Tape and Reel
NCP1937BADAPGEVB 制造商:ON Semiconductor 功能描述:ADPTR 90W PFC+QR<10MW - Bulk 制造商:ON Semiconductor 功能描述:BOARD EVAL FOR NCP1937 制造商:ON Semiconductor 功能描述:Power Management IC Development Tools 90 W Adapter PFC+QR 10 MW Eval Brd
NCP21WB333 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:for Surface Mounting Application