- 您现在的位置：买卖IC网 > PDF目录367933 > PH28F128L18T85 (INTEL CORP) StrataFlash Wireless Memory PDF资料下载
参数资料
| 型号： | PH28F128L18T85 |
| 厂商： | INTEL CORP |
| 元件分类： | PROM |
| 英文描述： | StrataFlash Wireless Memory |
| 中文描述： | 8M X 16 FLASH 1.8V PROM, 85 ns, PBGA56 |
| 封装： | 0.75 MM PITCH, LEAD FREE, VFBGA-56 |
| 文件页数： | 64/106页 |
| 文件大小： | 1272K |
| 代理商： | PH28F128L18T85 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页当前第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页
Intel StrataFlash Wireless Memory (L18)
April 2005
64
Intel StrataFlash Wireless Memory (L18)
Order Number: 251902, Revision: 009
Datasheet
12.0
Erase Operations
Flash erasing is performed on a block basis. An entire block is erased each time an erase command
sequence is issued, and only one block is erased at a time. When a block is erased, all bits within
that block read as logical ones. The following sections describe block erase operations in detail.
12.1
Block Erase
Block erase operations are initiated by writing the Block Erase Setup command to the address of
the block to be erased (see
Section 9.2, “Device Commands” on page 47
). Next, the Block Erase
Confirm command is written to the address of the block to be erased. Erasing can occur in only one
partition at a time; all other partitions must be in a read state. If the device is placed in standby
(CE# deasserted) during an erase operation, the device completes the erase operation before
entering standby.V
PP
must be above V
PPLK
and the block must be unlocked
(see
Figure 43, “Block
Erase Flowchart” on page 89
).
During a block erase, the Write State Machine (WSM) executes a sequence of internally-timed
events that conditions, erases, and verifies all bits within the block. Erasing the flash memory array
changes “zeros” to “ones.” Memory array bits that are ones can be changed to zeros only by
programming the block (see
Section 11.0, “Programming Operations” on page 58
).
The Status Register can be examined for block erase progress and errors by reading any address
within the partition that is being erased. The partition remains in the Read Status Register state
until another command is written to that partition. Issuing the Read Status Register command to
another partition address sets that partition to the Read Status Register state, allowing erase
progress to be monitored at that partition’s address. SR[0] indicates whether the addressed partition
or another partition is erasing. The partition’s Status Register bit SR[7] is set upon erase
completion.
Status Register bit SR[7] indicates block erase status while the sequence executes. When the erase
operation has finished, Status Register bit SR[5] indicates an erase failure if set. SR[3] set would
indicate that the WSM could not perform the erase operation because V
PP
was outside of its
acceptable limits. SR[1] set indicates that the erase operation attempted to erase a locked block,
causing the operation to abort.
Before issuing a new command, the Status Register contents should be examined and then cleared
using the Clear Status Register command. Any valid command can follow once the block erase
operation has completed.
12.2
Erase Suspend
Issuing the Erase Suspend command while erasing suspends the block erase operation. This allows
data to be accessed from memory locations other than the one being erased. The Erase Suspend
command can be issued to any device address; the corresponding partition is not affected. A block
erase operation can be suspended to perform a word or buffer program operation, or a read
operation within any block except the block that is erase suspended (see
Figure 40, “Program
Suspend/Resume Flowchart” on page 86
).
相关PDF资料 |
PDF描述 |
|---|---|
| PH28F256L18B85 | StrataFlash Wireless Memory |
| PH28F256L18T85 | StrataFlash Wireless Memory |
| PH28F640L18B85 | StrataFlash Wireless Memory |
| PH28F640L18T85 | StrataFlash Wireless Memory |
| PH2907A | PNP switching transistor |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PH28F128W18BD60A | 制造商:Micron Technology Inc 功能描述:NOR Flash Parallel 1.8V 128Mbit 8M x 16bit 60ns 56-Pin VFBGA Tray |
| PH28F160C3BD70A | 制造商:Micron Technology Inc 功能描述:MM#865392FLASH 28F160C3BD 70 VF-PBGA46 C |
| PH28F256L18B85 | 制造商:INTEL 制造商全称:Intel Corporation 功能描述:StrataFlash Wireless Memory |
| PH28F256L18B85A | 制造商:Micron Technology Inc 功能描述:MM#875138FLASH 28F256L18B 85 VF-PBGA79 S |
| PH28F256L18T85 | 制造商:INTEL 制造商全称:Intel Corporation 功能描述:StrataFlash Wireless Memory |
发布紧急采购，3分钟左右您将得到回复。