- 您现在的位置：买卖IC网 > PDF目录7463 > SFPA8192Q1BO2TO-I-QT-223-STD (Swissbit NA Inc)FLASH SSD SMART UDMA 2.5" 8GB PDF资料下载
参数资料
| 型号： | SFPA8192Q1BO2TO-I-QT-223-STD |
| 厂商： | Swissbit NA Inc |
| 文件页数： | 10/76页 |
| 文件大小： | 0K |
| 描述： | FLASH SSD SMART UDMA 2.5" 8GB |
| 视频文件： | Swissbit Manufacturing Overview |
| RoHS指令信息： | Environment Protection Declaration |
| 标准包装： | 4 |
| 系列： | P-120 |
| 存储容量： | 8GB |
| 存储器类型： | FLASH |
| 其它名称： | 1052-1025 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页
Signal description
Pin
Type
Signal
Name
Pin Num
Signal
Name
Pin
Type
Signal description
This internally pulled up signal is
used to configure the drives as the
This is IORDY from the card
from the drive to the host
O
IORDY
-
DDMARDY
DSTROBE
27
28
CSEL
I
Primary or the Secondary device.
When the pin is grounded, the
device is configured as the Primary
device (master).
When the pin is open, the device is
configured as a Secondary device
(slave).
Not used.
I
-DMACK
29
30
GND
Ground
This is an interrupt request
from the drive to the host,
asking for service. This signal
O
INTRQ
31
32
(IOCS16)
O
Not used.
is the active high Interrupt
Request to the host.
After an Executive diagnostic
command to indicate that the
The address lines A1 and A0
are used to select one of eight
registers in the controller Task
File.
I
I
A1
A0
33
35
34
36
-PDIAG
A2
I/O
I
Primary device has passed its
diagnostics, this bi-directional
open drain signal is asserted by the
Secondary device.
The address line A2 is used to select
one of eight
registers in the controller Task File.
The chip select signal used to
select the Task File register.
I
-CS0
37
38
-CS1
I
The chip select signal used to select
the Alternate Status register and
the Device Control register.
This input/output is the Disk
Active/Secondary Present
signal in the Primary/
O
-DASP
39
40
GND
Ground
Secondary handshake
protocol.
5V Power Supply
Ground
VCC
GND
41
43
42
44
VCC
NC
5V Power Supply
5.2 Master-Slave configuration
The SSD can be configured as IDE Master or Slave Device with a Jumper beside the 44-pin connector
(pins A, B, C, and D).
Table 12: Master Slave configuration
Jumper
No Jumper
A to C
C to D
A to B
B to D
Device configuration
Master
Slave
Cable Select*
*) The Device is master, if it is connected at the end,
or slave, if it is connected at the middle connector of a standard IDE cable
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.00
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
P-120_data_sheet_PA-QxBO_Rev100.doc
Page 10 of 76
相关PDF资料 |
PDF描述 |
|---|---|
| 3-1437653-5 | CONN BARRIER STRIP 10CIRC .375 |
| 6432.0153.15 | MOD PWR IN/OUT/SW/1PL QC 1.5 PNL |
| 4306R-102-391 | RES ARRAY 390 OHM 3 RES 6-SIP |
| SFSA8192V1BR4TO-I-DT-226-STD | FLASH SLC UDMA/MDMA/PIO 8GB |
| 6432.0151.15 | MOD PWR IN/OUT/SW/1PL SLD 1.5PNL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SFPA8192Q1BO2TO-I-QT-243 | 制造商:Swissbit 功能描述: |
| SFPA8192Q1BO2TO-I-QT-243-STD | 制造商:SWISSBIT NA INC 功能描述:FLASH 制造商:SWISSBIT 功能描述:SSD PATA 8GB 2.5" IND P-120 制造商:SWISSBIT 功能描述:SSD, PATA, 8GB, 2.5", IND, P-120 |
| SFPAB13202 | 制造商:Panasonic Industrial Company 功能描述:KNOB |
| SFPAB17206 | 制造商:Panasonic Industrial Company 功能描述:KNOB |
| SFPAB18201K | 制造商:Panasonic Industrial Company 功能描述:PLATE |
发布紧急采购，3分钟左右您将得到回复。