- 您现在的位置：买卖IC网 > PDF目录7463 > SFPA8192Q1BO2TO-I-QT-223-STD (Swissbit NA Inc)FLASH SSD SMART UDMA 2.5" 8GB PDF资料下载
参数资料
| 型号： | SFPA8192Q1BO2TO-I-QT-223-STD |
| 厂商： | Swissbit NA Inc |
| 文件页数： | 25/76页 |
| 文件大小： | 0K |
| 描述： | FLASH SSD SMART UDMA 2.5" 8GB |
| 视频文件： | Swissbit Manufacturing Overview |
| RoHS指令信息： | Environment Protection Declaration |
| 标准包装： | 4 |
| 系列： | P-120 |
| 存储容量： | 8GB |
| 存储器类型： | FLASH |
| 其它名称： | 1052-1025 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页
e) The host shall negate -CS0, -CS1, DA2, DA1, and DA0. The host shall keep -CS0, -CS1, DA2, DA1, and
DA0 negated until after negating -DMACK at the end of the burst.
f)
Steps (c), (d), and (e) shall have occurred at least t ACK before the host asserts -DMACK. The host shall
keep -DMACK asserted until the end of an Ultra DMA burst.
g) The device may negate -DDMARDY t ZIORDY after the host has asserted -DMACK. Once the device has
negated -DDMARDY, the device shall not release -DDMARDY until after the host has negated DMACK
at the end of an Ultra DMA burst.
h) The host shall negate STOP within t ENV after asserting -DMACK. The host shall not assert STOP until
after the first negation of HSTROBE.
i)
j)
The device shall assert -DDMARDY within t LI after the host has negated STOP. After asserting DMARQ
and -DDMARDY the device shall not negate either signal until after the first negation of HSTROBE by
the host.
The host shall drive the first word of the data transfer onto D[15:00]. This step may occur any time
during Ultra DMA burst initiation.
k) To transfer the first word of data: the host shall negate HSTROBE no sooner than t UI after the device
has asserted -DDMARDY. The host shall negate HSTROBE no sooner than t DVS after the driving the first
word of data onto D[15:00].
Figure 8: Ultra DMA Data-Out Burst Initiation Timing
Note: The definitions for the STOP, DDMARDY, and HSTROBE signal lines are not in effect until DMARQ
and DMACK are asserted.
6.3.2.4.7 Sustaining an Ultra DMA Data-Out Burst
An Ultra DMA Data-Out burst is sustained by following the steps lettered below. The timing diagram is
shown in
Figure 9: Sustained Ultra DMA Data-Out Burst Timing. The associated timing parameters are specified in
Table 22: Ultra DMA Data Burst Timing Requirements and are described in Table 23: Ultra DMA Data Burst
The following steps shall occur in the order they are listed unless otherwise specifically allowed:
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.00
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
P-120_data_sheet_PA-QxBO_Rev100.doc
Page 25 of 76
相关PDF资料 |
PDF描述 |
|---|---|
| 3-1437653-5 | CONN BARRIER STRIP 10CIRC .375 |
| 6432.0153.15 | MOD PWR IN/OUT/SW/1PL QC 1.5 PNL |
| 4306R-102-391 | RES ARRAY 390 OHM 3 RES 6-SIP |
| SFSA8192V1BR4TO-I-DT-226-STD | FLASH SLC UDMA/MDMA/PIO 8GB |
| 6432.0151.15 | MOD PWR IN/OUT/SW/1PL SLD 1.5PNL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SFPA8192Q1BO2TO-I-QT-243 | 制造商:Swissbit 功能描述: |
| SFPA8192Q1BO2TO-I-QT-243-STD | 制造商:SWISSBIT NA INC 功能描述:FLASH 制造商:SWISSBIT 功能描述:SSD PATA 8GB 2.5" IND P-120 制造商:SWISSBIT 功能描述:SSD, PATA, 8GB, 2.5", IND, P-120 |
| SFPAB13202 | 制造商:Panasonic Industrial Company 功能描述:KNOB |
| SFPAB17206 | 制造商:Panasonic Industrial Company 功能描述:KNOB |
| SFPAB18201K | 制造商:Panasonic Industrial Company 功能描述:PLATE |
发布紧急采购，3分钟左右您将得到回复。