- 您现在的位置：买卖IC网 > PDF目录10908 > SI3015-F-FS (Silicon Laboratories Inc)IC ISOMODEM LINE-SIDE DAA 16SOIC PDF资料下载
参数资料
| 型号： | SI3015-F-FS |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 18/94页 |
| 文件大小： | 0K |
| 描述： | IC ISOMODEM LINE-SIDE DAA 16SOIC |
| 标准包装： | 48 |
| 系列： | ISOmodem® |
| 数据格式： | V.90 |
| 波特率： | 2.4k |
| 电源电压： | 3.3V，5V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC N |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页
Si2400
Rev. 1.3
25
5.12. Analog Codec
The Si2400 features an on-chip, voice quality codec.
The codec consists of a digital to analog converter
(DAC) and an analog to digital converter (ADC). The
sample rate for the codec is set to 9.6 kHz. When the
codec is powered on (SE4[1] [APO] = 1b), the output of
the DAC is always present on the Si2400 AOUT pin.
When the codec is powered off (APO = 0b), a PWM
output is present on the AOUT pin instead. In order to
use the ADC, one of the four GPIO pins must be
selected as an analog input (AIN) by programming SE2
(GPIO).
Figure 10 shows the various signal routing modes for
the Si2400 voice codec, which are programmed through
register SE4[5:4] (DRT). Figure 10A shows the data
routing for data mode. This is the default mode used for
modem data formats. In this configuration, AOUT
produces a mixed sum of the DSPOUT and DSPIN
signals and is typically used for call progress monitoring
through an external speaker. The relative levels of the
DSPOUT and DSPIN signals that are output on the
AOUT pin can be set through SF4[1:0] (ATL) and
SF4[3:2] (ARL).
Figure 10B shows the format for sending analog voice
across the DAA to the PSTN. AIN is routed directly
across
the
DAA
to
the
telephone
line.
In
this
configuration, AOUT produces a mixed sum of the
DSPOUT and DSPIN signals. The relative levels of the
DSPOUT and DSPIN signals that are output on the
AOUT pin can be set through registers ATL and ARL.
The DSP may process these signals if it is not in PCM
data mode. Thus, the DSP may be used in this
configuration, for example, to decode DTMF tones. This
is the mode used with the “!0” and “A0” commands.
Figure 10C shows the loopback format, which can be
used for in-circuit testing.
Figure 10D shows the codec mode. This format is
useful, for example, in voice prompting, speaker
phones,
or
any
systems
involving
digital
signal
processing. In this mode, DSPOUT is routed to both the
AOUT pin and to the telephone line, and AIN is routed
directly to DSPIN.
In all the DRT formats, the DSP must be in PCM mode
in order to pass DSPIN and DSPOUT directly to and
from TXD and RXD.
5.13. V.23 Operation/V.23 Reversing
The Si2400 supports full V.23 operation including the
V.23 reversing procedure. V.23 operation is enabled by
setting
S07
(MF1) = xx10xx00b or xx01xx10b. If
S07[5] (V23R) = 1b, then the Si2400 will transmit data at
75 bps and receive data at either 600 or 1200 bps. If
S07[4] (V23T) = 1b, then the Si2400 will receive data at
75 bps and transmit data at either 600 or 1200 bps.
S07[2] (BAUD) is the 1200 or 600 bps indicator.
BAUD = 1b will enable the 1200/600 V.23 channel to run
at 1200 bps while BAUD = 0b will enable 600 bps
operation.
When a V.23 connection is successfully established, the
modem will respond with a “c” character if the
connection is made with the modem transmitting at
1200/600 bps and receiving at 75 bps. The modem will
respond with a “v” character if a V.23 connection is
established with the modem transmitting at 75 bps and
receiving at 1200/600 bps.
The Si2400 supports the V.23 turnaround procedure.
This allows a modem that is transmitting at 75 bps to
initiate a “turnaround” procedure so that it can begin
transmitting data at 1200/600 bps and receiving data at
75 bps. The modem is defined as being in V.23 master
mode if it is transmitting at 75 bps and it is defined as
being in slave mode if the modem is transmitting at
1200/600 bps. The following paragraphs give a detailed
description of the V.23 turnaround procedure.
5.13.1. Modem in master mode
To perform a direct turnaround once a modem
connection is established, the master host goes into
online-command-mode
by
sending
an
escape
command (Escape pin activation, TIES, or ninth bit
escape) to the master modem. (Note that the host can
initiate a turnaround only if the Si2400 is the master.)
The host then sends the ATRO command to the Si2400
to initiate a V.23 turnaround and to go back to the online
(data) mode.
The Si2400 will then change its carrier frequency (from
390 Hz to 1300 Hz), and wait to detect a 390 Hz carrier
for 440 ms. If the modem detects more than 40 ms of a
390 Hz carrier in a time window of 440 ms, it will echo
the “c” response character. If the modem does not
detect more than 40 ms of a 390 Hz carrier in a time
window of 440 ms, it will hang up and echo the “N” (no
carrier) character as a response
相关PDF资料 |
PDF描述 |
|---|---|
| SI3050-E1-FM | IC VOICE DAA SYSTEM SIDE 24QFN |
| JBXEA2G07FSSDS | CONN RCPT 7POS DOUBLE NUT SOLDER |
| VE-J6V-IY-B1 | CONVERTER MOD DC/DC 5.8V 50W |
| VE-J6T-IY-B1 | CONVERTER MOD DC/DC 6.5V 50W |
| VE-2NX-IX-F1 | CONVERTER MOD DC/DC 5.2V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI3015-F-FSR | 制造商:Silicon Laboratories Inc 功能描述:Modem Chip Chipset 2.4Kbps 16-Pin SOIC T/R 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 2.4KBPS 16SOIC - Tape and Reel 制造商:Silicon Laboratories 功能描述:Modem Chip Chipset 2.4Kbps 16-Pin SOIC T/R |
| SI3015-FS | 功能描述:IC ISOMODEM LINE-SIDE DAA 16SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 调制解调器 - IC 和模块 系列:ISOmodem® 标准包装:25 系列:- 数据格式:V.21，V.22，V.23，V.29，V.32，V.34，V.90，V.92，Bell 103，Bell 212A 波特率:33.6k 电源电压:3.3V 安装类型:- 封装/外壳:- 供应商设备封装:- 包装:托盘 配用:591-1013-ND - KIT DEV SOCKETMODEM PARALLEL591-1009-ND - KIT DEV SRL SOCKETMODEM UNIVERSL 其它名称:MT5656SMI-P-V-34.R2-SPMT5656SMI-P-V-34.R2-SP-NDQ4711574 |
| SI3015-FSR | 制造商:Silicon Laboratories Inc 功能描述:SI2403 ISOMODEM LINE-SIDE LEAD-FREE SOIC 0 TO 70 DEG. C - Tape and Reel |
| SI3015-KS | 功能描述:电信线路管理 IC SI2400 Line Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| SI3015-KSR | 功能描述:电信线路管理 IC SI2400 Line Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。