参数资料
型号: SI3015-F-FS
厂商: Silicon Laboratories Inc
文件页数: 20/94页
文件大小: 0K
描述: IC ISOMODEM LINE-SIDE DAA 16SOIC
标准包装: 48
系列: ISOmodem®
数据格式: V.90
波特率: 2.4k
电源电压: 3.3V,5V
安装类型: 表面贴装
封装/外壳: 16-SOIC(0.154",3.90mm 宽)
供应商设备封装: 16-SOIC N
包装: 管件
Si2400
Rev. 1.3
27
checksum does not match, the Si2400 echoes “e” (error).
Additionally, if the Si2400 detects an abort (seven or more
contiguous ones), then it will echo an “A”.
When the “G”, “e”, or “A” (referred to as a frame result
word) is sent, the Si2400 raises the EOFR (end of frame
receive) pin (see Figure 10B). The GPIO1 pin must be
configured as EOFR by setting SE4[3] (GPE) =
1b. In
addition to using the EOFR pin to indicate that the byte is a
frame result word, if in 9-bit data mode (set S15[0] (NBE) =
1b), the ninth bit will be raised if the byte is a frame result
word. To program this mode, set S0C[3] (9BF) =
1b and
SE0[3] (ND) =
1b.
3. When the next frame of data is detected, EOFR is lowered
and the process repeats at step 1.
To summarize, the host will begin receiving data
asynchronously from the Si2400. When each byte is
received, the host should check the EOFR pin (or the
ninth bit). If the EOFR pin (or the ninth bit) is low, then
the data is valid frame data. If the EOFR pin (or the
ninth bit) is high, then the data is a frame result word.
5.15. Fast Connect
In modem applications that require fast connection
times, it is possible to reduce the length of the
handshake.
If the Si2400 is set up as an answering modem, the
answer tone transmitted by the Si2400 may be
shortened by setting S1E (TATL) = 0x00 and setting
S34 (TASL) to the desired answer tone length. For the
most robust operation, it is recommended that the
answer tone sent by the answering modem be at least
10 msec (S34 (TASL) = 0x06).
If the Si2400 is configured as an originating modem,
setting the No Answer Tone bit (S33[1] [NAT] = 1b)
forces the Si2400 to recognize a short answer tone,
thereby reducing the overall connection sequence.
Additional modem handshaking control can be adjusted
through
the
registers
shown
in
These
registers are most useful if the user has control of both
the originating and answer modems.
Figure 11. HDLC Timing
B. Fram e Receive
A. Fram e Transm it
TXD
RX D
Start
Stop
Start
Host begins frame N
Frame N
Start
Stop
Host finished sending frame N
Host begins frame N + 1
CTS
Frame N + 1
C RC Byte 2
Stop
Start
Stop
Receive Data
EO FR
(or bit 9)
Si2400 ready for byte 1 of frame N
Note: Figure not to scale.
(CTS used as normal flow control.)
Si2400 detects end of frame N.
Si2400 ready for byte 1
of frame N + 1.
CRC Byte 1
Frame Result W ord
相关PDF资料
PDF描述
SI3050-E1-FM IC VOICE DAA SYSTEM SIDE 24QFN
JBXEA2G07FSSDS CONN RCPT 7POS DOUBLE NUT SOLDER
VE-J6V-IY-B1 CONVERTER MOD DC/DC 5.8V 50W
VE-J6T-IY-B1 CONVERTER MOD DC/DC 6.5V 50W
VE-2NX-IX-F1 CONVERTER MOD DC/DC 5.2V 75W
相关代理商/技术参数
参数描述
SI3015-F-FSR 制造商:Silicon Laboratories Inc 功能描述:Modem Chip Chipset 2.4Kbps 16-Pin SOIC T/R 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 2.4KBPS 16SOIC - Tape and Reel 制造商:Silicon Laboratories 功能描述:Modem Chip Chipset 2.4Kbps 16-Pin SOIC T/R
SI3015-FS 功能描述:IC ISOMODEM LINE-SIDE DAA 16SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 调制解调器 - IC 和模块 系列:ISOmodem® 标准包装:25 系列:- 数据格式:V.21,V.22,V.23,V.29,V.32,V.34,V.90,V.92,Bell 103,Bell 212A 波特率:33.6k 电源电压:3.3V 安装类型:- 封装/外壳:- 供应商设备封装:- 包装:托盘 配用:591-1013-ND - KIT DEV SOCKETMODEM PARALLEL591-1009-ND - KIT DEV SRL SOCKETMODEM UNIVERSL 其它名称:MT5656SMI-P-V-34.R2-SPMT5656SMI-P-V-34.R2-SP-NDQ4711574
SI3015-FSR 制造商:Silicon Laboratories Inc 功能描述:SI2403 ISOMODEM LINE-SIDE LEAD-FREE SOIC 0 TO 70 DEG. C - Tape and Reel
SI3015-KS 功能描述:电信线路管理 IC SI2400 Line Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray
SI3015-KSR 功能描述:电信线路管理 IC SI2400 Line Side RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray