收藏本站
参数资料
型号： ST72E734J6D0
厂商： STMICROELECTRONICS
元件分类： 微控制器/微处理器
英文描述： 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CDIP42
封装： CERAMIC, SDIP-42
文件页数： 70/144页
文件大小： 1280K
代理商： ST72E734J6D0
ST72774/ST727754/ST72734
31/144
I/O PORTS (Cont’d)
4.1.4 Port B
The alternate functions are the I/O pins of the on-
chip DDC SCLD & SCDAD for PB0:1, the I/O pins
of the on-chip I2C SCLI & SCDAI for PB2:3, and 4
bits of port B bit can be used as the Analog source
to the Analog to Digital Converter.
Only one I/O line must be configured as an analog
input at any time. The user must avoid any
situation in which more than one I/O pin is selected
as an analog input simultaneously to avoid device
malfunction.
When the analog function is selected for an I/O pin,
the pull-up of the respective pin of Port B is
disconnected and the digital input is off.
All unused I/O lines should be tied to an
appropriate logic level (either VDD or VSS)
Since the ADC is on the same chip as the
microprocessor, the user should not switch heavily
loaded signals during conversion, if high precision
is required. Such switching will affect the supply
voltages used as analog references. the accuracy
of the conversion depends on the quality of the
power supplies (VDD and VSS). The user must take
special care to ensure that a well regulated
reference voltage is present on the VDD and VSS
pins (power supply variations must be less than
5V/ms). This implies, in particular, that a suitable
decoupling capacitor is used at the VDD pin.
Table 9. Port B Description
PORT B
I/O
Alternate Function
Input*
Output
Signal
Condition
PB0
Without pull-up
Open-drain
SCLD (input with CMOS schmitt trigger or
open drain output)
DDC enable
PB1
Without pull-up
Open-drain
SDAD (input with CMOS schmitt trigger or
open drain output)
DDC enable
PB2
Without pull-up
Open-drain
SCLI (input with CMOS schmitt trigger or
open drain output)
I2C enable
PB3
Without pull-up
Open-drain
SDAI (input with CMOS schmitt trigger or
open drain output)
I2C enable
PB4
With pull-up
Push-pull
Analog input (ADC) (without pull-up)
CH[2:0]=000 (ADCCSR)
PB5
With pull-up
Push-pull
Analog input (ADC) (without pull-up)
CH[2:0]=001 (ADCCSR)
PB6
With pull-up
Push-pull
Analog input (ADC) (without pull-up)
CH[2:0]=010 (ADCCSR)
10-bit output 1 (PWM)
OE0=1 (PWMOE)
PB7
With pull-up
Push-pull
Analog input (ADC) (without pull-up)
CH[2:0]=011 (ADCCSR)
10-bit output 2 (PWM)
OE1=1 (PWMOE)
*Reset state
相关PDF资料
PDF描述
ST72T774S9T1 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP44
ST7294C6B6 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PDIP28
ST72T94C6M6 8-BIT, OTPROM, MICROCONTROLLER, PDSO28
ST72C171K2B6 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDIP32
ST72E85A5G0 8-BIT, UVPROM, 4.332 MHz, MICROCONTROLLER, CQFP80
相关代理商/技术参数
参数描述
ST72F260G1B5 功能描述:8位微控制器 -MCU Flask 4K SPI RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ST72F260G1M6 功能描述:8位微控制器 -MCU Flash 4K SPI/I2C/SCI RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ST72F260G1M6/TR 功能描述:8位微控制器 -MCU 8B MCU FLASH OR ROM MEMORY RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ST72F262G1B5 功能描述:8位微控制器 -MCU Flask 4K SPI RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ST72F262G1B6 功能描述:8位微控制器 -MCU 8B MCU RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*