- 您现在的位置：买卖IC网 > PDF目录98202 > TDA8757AHL/21 (NXP SEMICONDUCTORS) 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP144 PDF资料下载
参数资料
| 型号： | TDA8757AHL/21 |
| 厂商： | NXP SEMICONDUCTORS |
| 元件分类： | ADC |
| 英文描述： | 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP144 |
| 封装： | PLASTIC, HLQFP-144 |
| 文件页数： | 5/37页 |
| 文件大小： | 908K |
| 代理商： | TDA8757AHL/21 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
Philips Semiconductors
TDA8757A
Triple 8-bit ADC 205 Msps
Preliminary data
Rev. 01 — 22 March 2002
13 of 37
9397 750 09549
Koninklijke Philips Electronics N.V. 2002. All rights reserved.
8.2.1
Variable gain ampliers
Three independent variable gain ampliers are used to provide, for each channel, a
full-scale input signal to the 8-bit ADC. The gain adjustment range is designed so that
for an input range varying from 0.4 to 1.2 V (p-p), the output signal corresponds to the
ADC full-scale input of 1 V (p-p).
To ensure that the gain does not vary over the whole operating temperature range a
reference voltage Vref = 2.5 V (DC), with a maximum variation of 100 ppm/°C, is
supplied externally on pin VREF.
The calibration of the gains is done using the following principle. On the incoming of a
pulse supplied to pin HSYNC, an internal multiplexer switches from the RGB video
signals to a reference voltage (1
16Vref). The ADCs inputs become this reference
signal and the three corresponding outputs are compared to pre-set values loaded in
three 7-bit registers: COARSER, COARSEG and COARSEB. Depending on the
result of the comparisons, the three gains are adjusted such that the ADC outputs
become equal to the pre-set values in the registers. The three gains are simply
controlled by changing the values in the COARSE registers.
The signal supplied on pin HSYNC, may be selected active HIGH or active LOW. The
choice is done through the serial interface by setting bit ‘Hlevel’ in the control register
(active HIGH when bit Hlevel = 0).
This active part of the signal has to occur during the blanking period of the signal in
order not to interrupt the active video. Normally the horizontal synchronization signal,
provided by the video source, is connected to pin HSYNC.
The values loaded in the gain registers (COARSER, COARSEG, COARSEB) are
chosen among 68 values (see Table 6).
A ne correction is also used to nely tune the gain on the three channels and to
compensate the channel-to-channel gain mismatch. The ne correction is done using
the following principle: the three binary codes, stored in the three 5-bit registers
(FINER, FINEG and FINEB) are converted into three analog voltages (with three
DACs) and are independently added to the reference voltage (1
16Vref). Thus, three
different reference voltages are used for the gain calibration of the three channels.
When the COARSE registers are set at full-scale, the resolution of the ne registers
corresponds to 1
2 LSB peak-to-peak (see Equation 3).
8.2.2
Important recommendations
The clamping and the gain calibration requisite two external signals (pulses). One
signal is connected to pin CLP and the other is connected to pin HSYNC. It is very
important that:
The active part of these two signals occur during the blanking of the video signal,
in order not to interrupt or disturb the active video.
The active part of these two signals does not overlap on each other, in order to
perform correctly the gain calibration and the clamping. Normally the clamp pulse
is sent after the end of the horizontal synchronization pulse.
相关PDF资料 |
PDF描述 |
|---|---|
| TDA8757CHV/21 | 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP144 |
| TDA8757CHV/17 | 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP144 |
| TDA8758GPB | 2-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48 |
| TDA8758GP | 2-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP48 |
| TDA8760K/4A | 1-CH 10-BIT DELTA-SIGMA ADC, PARALLEL ACCESS, PQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TDA8757HL | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Triple 8-bit ADC 170 Msps |
| TDA8758 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:YC 8-bit low-power analog-to-digital video interface |
| TDA8758G | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:YC 8-bit low-power analog-to-digital video interface |
| TDA8759HV/8/C1 | 功能描述:模数转换器 - ADC 3X8-BITS VIDEO ADC 110MSPS RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| TDA8759HV/8/C1,551 | 功能描述:模数转换器 - ADC 3X8-BITS VIDEO RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
发布紧急采购，3分钟左右您将得到回复。