- 您现在的位置：买卖IC网 > PDF目录382625 > TMP86CH47IUG (Toshiba Corporation) Zener Diode; Application: General; Pd (mW): 500; Vz (V): 17.5 to 18.3; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 PDF资料下载
参数资料
| 型号： | TMP86CH47IUG |
| 厂商： | Toshiba Corporation |
| 英文描述： | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 17.5 to 18.3; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| 中文描述： | 8位微控制器 |
| 文件页数： | 26/160页 |
| 文件大小： | 1627K |
| 代理商： | TMP86CH47IUG |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页
Page 18
2. Operational Description
2.2 System Clock Controller
TMP86CH47IUG
Figure 2-8 Edge-sensitive Release Mode
STOP mode is released by the following sequence.
1. In the dual-clock mode, when returning to NORMAL2, both the high-frequency and low-
frequency clock oscillators are turned on; when returning to SLOW1 mode, only the low-
frequency clock oscillator is turned on. In the single-clock mode, only the high-frequency
clock oscillator is turned on.
2. A warm-up period is inserted to allow oscillation time to stabilize. During warm up, all
internal operations remain halted. Six different warm-up times can be selected with the
SYSCR1<WUT> in accordance with the resonator characteristics.
3. When the warm-up time has elapsed, normal operation resumes with the instruction follow-
ing the STOP mode start instruction.
Note 1: When the STOP mode is released, the start is made after the prescaler and the divider of the
timing generator are cleared to "0".
Note 2: STOP mode can also be released by inputting low level on the
RESET
pin, which immediately
performs the normal reset operation.
Note 3: When STOP mode is released with a low hold voltage, the following cautions must be observed.
The power supply voltage must be at the operating voltage level before releasing STOP mode.
The
RESET
pin input must also be “H” level, rising together with the power supply voltage. In this
case, if an external time constant circuit has been connected, the
RESET
pin input voltage will
increase at a slower pace than the power supply voltage. At this time, there is a danger that a
reset may occur if input voltage level of the
RESET
pin drops below the non-inverting high-level
input voltage (Hysteresis input).
Note 1: The warm-up time is obtained by dividing the basic clock by the divider. Therefore, the warm-up
time may include a certain amount of error if there is any fluctuation of the oscillation frequency
when STOP mode is released. Thus, the warm-up time must be considered as an approximate
value.
Table 2-2 Warm-up Time Example (at fc = 16.0 MHz, fs = 32.768 kHz)
WUT
Warm-up Time [ms]
Return to NORMAL Mode
Return to SLOW Mode
000
010
100
110
*01
*11
12.288
4.096
3.072
1.024
0.192
0.064
750
250
5.85
1.95
5.9
2.0
NORMAL
operation
NORMAL
operation
V
IH
STOP mode is released by the hardware at the rising
edge of STOP pin input.
Warm up
STOP mode started
by the program.
STOP
operation
STOP
operation
STOP pin
XOUT pin
相关PDF资料 |
PDF描述 |
|---|---|
| TMP86CH47SUG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 18.1 to 19.0; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CH49FG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 18.8 to 19.7; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CH72FG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 19.5 to 20.4; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CK74AFG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 20.2 to 21.1; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CM23AUG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 20.9 to 21.9; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TMP86CH47SUG | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:8 Bit Microcontroller |
| TMP86CH47U | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:CMOS 8 BIT MICROCONTROLLER |
| TMP86CH47UG | 制造商:Toshiba America Electronic Components 功能描述:MCU 8BIT TLCS-870 CISC 16KB ROM 5V 44PQFP - Rail/Tube |
| TMP86CH49FG | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:8 Bit Microcontroller |
| TMP86CH72FG | 制造商:Toshiba America Electronic Components 功能描述:TLCS870/C 16K ROM , VFT - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。