
TMS470R1VF336A, TMS470R1VF346A
16/32-BIT RISC FLASH MICROCONTROLLERS
SPNS079I – OCTOBER 2002 – REVISED SEPTEMBER 2006
24
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251-1443
electrical characteristics over recommended operating free-air temperature range, Q version
(unless otherwise noted)
Source currents (out of the device) are negative while sink currents (into the device) are positive.
This does not apply to the PORRST pin. For PORRST exceptions, see the RST and PORRST timings section on
page 31.§ These values help to determine the external RC network circuit. For more details, see the TMS470R1x System Module Reference Guide
(literature number SPNU189).
VOL and VOH are linear with respect to the amount of load current (IOL/IOH) applied.
# Parameter does not apply to input-only or output-only pins.
|| The 2 mA buffers on this device are called zero-dominant buffers. If two of these buffers are shorted together and one is outputting a low level
and the other is outputting a high level, the resulting value will always be low.
For flash banks/pumps in sleep mode.
I/O pins configured as inputs or outputs with no load. All pulldown inputs
≤ 0.2 V. All pullup inputs ≥ V
CCIO 0.2 V.
PARAMETER
TEST CONDITIONS
MIN
MAX
UNIT
Vhys
Input hysteresis
0.15
V
VIL
Low-level input voltage
All inputs except
OSCIN
0.3
0.8
V
OSCIN only
0.3
0.35 VCC
VIH
High-level input voltage
All inputs except OSCIN
2
VCCIO + 0.3
V
OSCIN only
0.65 VCC
VCC + 0.3
Vth
Input threshold voltage
AWD only
1.35
1.8
V
RDSON
Drain to source on
resistance
AWD only§
VOL = 0.35V @ IOL = 8mA
45
Ω
VOL
Low-level output voltage
IOL = IOL MAX
0.2 VCCIO
V
IOL = 50 μA
0.2
VOH
High-level output voltage
IOH = IOH MIN
0.8 VCCIO
V
IOH = 50 μAVCCIO 0.2
IIC
Input clamp current (I/O pins)#
VI < VSSIO 0.3 or VI > VCCIO + 0.3
22
mA
II
Input current (I/O pins)
IIL Pulldown
VI = VSS
11
μA
IIH Pulldown
VI = VCCIO
540
IIL Pullup
VI = VSS
–40
–5
IIH Pullup
VI = VCCIO
11
All other pins
No pullup or pulldown
11
IOL
Low-level output
current
CLKOUT, AWD, TDO
VOL = VOL MAX
8
mA
RST, SPI1CLK,
SPI1SOMI, SPI1SIMO,
SPI2CLK, SPI2SOMI,
SPI2SIMO
VOL = VOL MAX
4
All other
output pins||
VOL = VOL MAX
2
IOH
High-level output
current
CLKOUT, TDO
VOH = VOH MIN
8
mA
SPI1CLK, SPI1SOMI,
SPI1SIMO, SPI2CLK,
SPI2SOMI, SPI2SIMO
VOH = VOH MIN
4
All other output pins
except RST||
VOH = VOH MIN
2