- 您现在的位置：买卖IC网 > PDF目录272833 > TPS65073TRSLRQ1 (TEXAS INSTRUMENTS INC) POWER SUPPLY SUPPORT CKT, PQCC48 PDF资料下载
参数资料
| 型号： | TPS65073TRSLRQ1 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | POWER SUPPLY SUPPORT CKT, PQCC48 |
| 封装： | 6 X 6 MM, 0.4 MM PITCH, PLASTIC, QFN-48 |
| 文件页数： | 64/90页 |
| 文件大小： | 1375K |
| 代理商： | TPS65073TRSLRQ1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页当前第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页
www.ti.com
SLVSAP7 – JANUARY 2011
Other inductors, with lower or higher inductance values can be used. A higher inductance will cause a lower
inductor current ripple and therefore will provide higher efficiency. The boost converter will also stay in
continuous conduction mode over a wider load current range. The energy stored in an inductor is given by
E=1/2L × I2 where I is the peak inductor current. The maximum current in the inductor is limited by the internal
current limit of the device, so the maximum power is given by the minimum peak current limit (see electrical
specifications) times the inductance value. For highest output power, a large inductance value is needed. The
minimum inductor value possible is limited by the energy needed to supply the load. The limit for the minimum
inductor value is given during the on-time of the switch such that the current limit is not reached.
Example for the minimum inductor value:
Vin = 4.2 V, Vout = 19.7 V, Iout = 5 mA, Vsw =0.1 V
→ D = 79%
→ ton = 703 ns
During the on-time, the inductor current should not reach the current limit of 1.4 A.
With V… voltage across the inductor (V = Vin–Vsw)
→ L = V × dt/di = (4.2 V–0.1 V) × 703ns/1.4A = 2mH
Diode Selection
Due to the non-synchronous design of the boost converter, an external diode is needed. For best performance, a
Schottky diode with a voltage rating of 40V or above should be used. A diode such as the MBR0540 with an
average current rating of 0.5A is sufficient.
Output Capacitor Selection
A ceramic capacitor such as X5R or X7R type is required at the output. See Table 7 for reference.
Table 7. Tested Capacitor
TYPICAL VOLTAGE
LED
CAPACITOR
ACROSS OUTPUT
CAPACITOR TYPE
MANUFACTURER
CONFIGURATION
VALUE
SIZE
CAPACITOR
2x6LEDs or 1x6LEDs
21 V
4.7 mF / 50 V
1206
UMK316BJ475KL
Taiyo Yuden
1x10LEDs
35 V
4.7 mF / 50 V
1210
GRM32ER71H475KA
Murata
Input Capacitor Selection
A small ceramic input capacitor of 10 mF is needed at the input of the boost converter. If the inductor is directly
connected to the SYS output of , the capacitor can be shared. In this case the capacitance needs to be 22mF or
above. Only X5R or X7R ceramic capacitors should be used.
BATTERY CHARGER
Temperature Sensing
The battery charger integrated in has an over temperature protection for the Li-ion cell. The temperature is
sensed with a NTC located at the battery. Comparators in suspend charge at a temperature below 0°C and
above 45°C. The charger supports two different resistor values for the NTC. The default is internally programmed
to 10k. It is possible to change to a 100k NTC with the I2C interface.
Table 8. NTCs Supported
RESISTANCE AT 25°C
CURVE / B VALUE
RT2 NEEDED FOR
MANUFACTURER
LINEARIZATION
10k
Curve 2 / B=3477
75k
Several
100k
Curve 1 / B=3964
370k
Several
Copyright 2011, Texas Instruments Incorporated
67
相关PDF资料 |
PDF描述 |
|---|---|
| TC151A4924EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161B3514EOA723 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161B1717EOA713 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161A5520EOA713 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161A5825EOA713 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS650830EVM-095 | 功能描述:TPS650830 - Power Management, Special Purpose: Mobiles Evaluation Board 制造商:texas instruments 系列:- 零件状态:有效 主要用途:电源管理，专用型： 手机 嵌入式:- 使用的 IC/零件:TPS650830 主要属性:- 辅助属性:图形用户接口，I2C 接口 所含物品:板 标准包装:1 |
| TPS650830ZAJT | 功能描述:- Converter, Mobile PCs Voltage Regulator IC 8 Output 168-NFBGA (7x7) 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 应用:转换器，移动式个人电脑 电压 - 输入:5.4 V ~ 24 V 输出数:8 电压 - 输出:多重 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:168-TFBGA 供应商器件封装:168-NFBGA（7x7） 标准包装:1 |
| TPS650830ZCGT | 功能描述:- Converter, Mobile PCs Voltage Regulator IC 8 Output 159-NFBGA (9x9) 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 应用:转换器，移动式个人电脑 电压 - 输入:5.4 V ~ 24 V 输出数:8 电压 - 输出:多重 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:159-TFBGA 供应商器件封装:159-NFBGA(9x9) 标准包装:1 |
| TPS650860A0RSKT | 功能描述:D-CAP2? Controller, Multicore, CPU, FPGA, SOC’s Voltage Regulator IC 8 Output 64-QFN (8x8) 制造商:texas instruments 系列:D-CAP2?? 包装:剪切带（CT） 零件状态:有效 应用:控制器，多核，CPU，FPGA，SOC 应用 电压 - 输入:4.5 V ~ 21 V 输出数:8 电压 - 输出:多重 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:64-VFQFN 裸露焊盘 供应商器件封装:64-QFN（8x8） 标准包装:1 |
| TPS650860EVM-116 | 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件状态:在售 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。