W28J800B/T
Publication Release Date: April 11, 2003
- 33 -
Revision A4
3) Data protection through #RESET
When the #RESET is kept low during read mode, the flash memory will be in reset mode, write
protecting all blocks. When the #RESET is kept low during power up and power down sequence
such as voltage transition, write operation on the flash memory is disabled, write protecting all
blocks. For the details of #RESET control, refer to the specification.
11. ELECTRICAL SPECIFICATIONS
Absolute Maximum Ratings*
Operating Temperature
During Read, Block Erase, Full Chip Erase, Word/Byte Write
and Lock-Bit Configuration ........................................................................................... -40
° C to +85° C (1)
......................................................................................................................................... 0
° C to +70° C (1)
Storage Temperature
During under Bias ............................................................................................................. -10
° C to +80° C
During non Bias .............................. ................................................................................... -65
° C to +125° C
Voltage On Any Pin
(except VDD and VPP) ......... ...................................................................................... .. -0.5V to VDD +0.5V (2)
VDD Supply Voltage......................... .............................................................................. ....... -0.2V to +4.6V (2)
VPP Supply Voltage..................................................................................................... .... -0.2V to +13.0V (2, 3)
Output Short Circuit Current............. ................................................................................................100 mA (4)
*WARNING: Stressing the device beyond the "Absolute Maximum Ratings" may cause permanent damage.
These are stress ratings only. Operation beyond the "Operating Conditions" is not recommended
and extended exposure beyond the "Operating Conditions" may affect device reliability.
Notes:
1. -40
° C to +85° C operating temperature is for extended temperature product defined by this specification.
(for W28J800BT/TT90L)
0
° C to +70° C operating temperature is for commercial temperature product defined by this specification.
(for W28J800BT/TT90C)
2. All specified voltages are with respect to VSS. Minimum DC voltage is -0.5V on input/output pins and -0.2V on VDD and VPP
pins. During transitions, this level may undershoot to -2.0V for periods <20 nS. Maximum DC voltage on input/output pins are
VDD +0.5V which, during transitions, may overshoot to VDD +2.0V for periods <20 nS.
3. Maximum DC voltage on VPP may overshoot to +13.0V for periods <20 nS. Applying 12V ±0.3V to VPP during erase/write can
only be done for a maximum of 1000 cycles on each block. VPP may be connected to 12V ±0.3V for a total of 80 hours
maximum.
4. Output shorted for no more than one second. No more than one output shorted at a time.
Operating Conditions
Temperature and VDD Operating Conditions
SYMBOL
PARAMETER
MIN.
MAX.
UNIT
TEST CONDITION
W28J800BT/TT90C
0
+70
TA
Operating Temperature
W28J800BT/TT90L
-40
+85
°C
Ambient
Temperature
VDD
VDD Supply Voltage (2.7V to 3.6V)
2.7
3.6
V