- 您现在的位置：买卖IC网 > Datasheet目录368 > W9412G6JH-5I (Winbond Electronics)IC DDR SDRAM 128MBIT 66TSOPII Datasheet资料下载
参数资料
| 型号： | W9412G6JH-5I |
| 厂商： | Winbond Electronics |
| 文件页数： | 12/53页 |
| 文件大小： | 0K |
| 描述： | IC DDR SDRAM 128MBIT 66TSOPII |
| 标准包装： | 200 |
| 格式 - 存储器： | RAM |
| 存储器类型： | DDR SDRAM |
| 存储容量： | 128M（8Mx16） |
| 速度： | 200MHz |
| 接口： | 并联 |
| 电源电压： | 2.3 V ~ 2.7 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 66-TSSOP（0.400"，10.16mm 宽） |
| 供应商设备封装： | 66-TSOP II |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页
W9412G6JH
To allow for improved efficiency in scheduling and switching between tasks, some flexibility in the
absolute refresh interval is provided. A maximum of eight AUTO REFRESH commands can be
posted to any given DDR SDRAM, and the maximum absolute interval between any AUTO
REFRESH command and the next AUTO REFRESH command is 8 * t REFI .
8.2.14 Self Refresh Entry Command
( RAS = “L”, CAS = “L”, WE = “H”, CKE = “L”, BA0, BA1, A0 to A1 1 = Don’t Care)
The SELF REFRESH command can be used to retain data in the DDR SDRAM, even if the rest of
the system is powered down. When in the self refresh mode, the DDR SDRAM retains data
without external clocking. The SELF REFRESH command is initiated like an AUTO REFRESH
command except CKE is disabled (LOW). The DLL is automatically disabled upon entering SELF
REFRESH, and is automatically enabled upon exiting SELF REFRESH. Any time the DLL is
enabled a DLL Reset must follow and 200 clock cycles should occur before a READ command
can be issued. Input signals except CKE are “Don’t Care” during SELF REFRESH. Since CKE is a
SSTL_2 input, V REF must be maintained during SELF REFRESH .
8.2.15 Self Refresh Exit Command
(CKE = “H”, CS = “H” or CKE = “H”, RAS = “H”, CAS = “H”)
The procedure for exiting self refresh requires a sequence of commands. First, CLK must be
stable prior to CKE going back HIGH. Once CKE is HIGH, the DDR SDRAM must have NOP
commands issued for t XSNR because time is required for the completion of any internal refresh in
progress. A simple algorithm for meeting both refresh and DLL requirements is to apply NOPs for
200 clock cycles before applying any other command.
The use of SELF REFREH mode introduces the possibility that an internally timed event can be
missed when CKE is raised for exit from self refresh mode. Upon exit from SELF REFRESH an
extra auto refresh command is recommended .
8.2.16 Data Write Enable /Disable Command
(DM = “L/H” or LDM, UDM = “L/H”)
During a Write cycle, the DM or LDM, UDM signal functions as Data Mask and can control every
word of the input data. The LDM signal controls DQ0 to DQ7 and UDM signal controls DQ8 to
DQ15.
8.3
Read Operation
Issuing the Bank Activate command to the idle bank puts it into the active state. When the Read
command is issued after t RCD from the Bank Activate command, the data is read out sequentially,
synchronized with both edges of DQS (Burst Read operation). The initial read data becomes
available after CAS Latency from the issuing of the Read command. The CAS Latency must be set
in the Mode Register at power-up.
When the Precharge Operation is performed on a bank during a Burst Read and operation, the
Burst operation is terminated.
When the Read with Auto-precharge command is issued, the Precharge operation is performed
automatically after the Read cycle then the bank is switched to the idle state. This command
cannot be interrupted by any other commands. Refer to the diagrams for Read operation.
Publication Release Date: Jan. 14, 2014
- 12 -
Revision: A04
相关PDF资料 |
PDF描述 |
|---|---|
| W9425G6EH-5 | IC DDR-400 SDRAM 256MB 66TSSOPII |
| W9425G6JH-5I | IC DDR SDRAM 256MBIT 66TSOPII |
| W947D2HBJX5E | IC LPDDR SDRAM 128MBIT 90VFBGA |
| W948D2FBJX5E | IC LPDDR SDRAM 256MBIT 90VFBGA |
| W949D2CBJX5E | IC LPDDR SDRAM 512MBIT 90VFBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| W9412G6JH-5TR | 制造商:Winbond Electronics Corp 功能描述:128M DDR SDRAM X16 200MHZ, 65N |
| W942 | 制造商:Performance Tool 功能描述:6 Piece Hook and Pick Set 制造商:PERFORMANCE TOOLS 功能描述:6 PC HOOK AND PICK SET |
| W942508BH | 制造商:未知厂家 制造商全称:未知厂家 功能描述:DRAM |
| W942508CH | 制造商:WINBOND 制造商全称:Winbond 功能描述:8M x 4 BANKS x 8 BIT DDR SDRAM |
| W942508CH-5 | 制造商:WINBOND 制造商全称:Winbond 功能描述:8M x 4 BANKS x 8 BIT DDR SDRAM |
发布紧急采购，3分钟左右您将得到回复。