参数资料
| 型号： | XR16M698IQ100-F |
| 厂商： | Exar Corporation |
| 文件页数： | 21/58页 |
| 文件大小： | 0K |
| 描述： | IC UART FIFO 32B OCTAL 100QFP |
| 标准包装： | 66 |
| 特点： | * |
| 通道数： | 8 |
| FIFO's： | 32 字节 |
| 规程： | RS485 |
| 电源电压： | 1.62 V ~ 3.63 V |
| 带自动流量控制功能： | 是 |
| 带IrDA 编码器/解码器： | 是 |
| 带故障启动位检测功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 100-BQFP |
| 供应商设备封装： | 100-QFP（14x20） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页
TABLE 11: TIMER CONTROL COMMANDS
TIMERCNTL [7:4] Reserved
TIMERCNTL [3:0] These bits are used to invoke a series of commands that control the function of the Timer/Counter.
The commands 1011 to 1111 are reserved.
0001: Enable Timer Interrupt
0010: Disable Timer Interrupt (default)
0011: Select One-shot mode
0100: Select Re-triggerable mode (default)
0101: Select Internal Crystal Oscillator output as clock source for the Timer (default)
0110: Select External Clock source (through TMRCK pin) for the Timer
0111: Reserved
1000: Reserved
1001: Start Timer
1010: Stop Timer (default)
1011: Reset Timer
Upon power-up or reset, the default states are Timer interrupt disabled, Re-triggerable mode, Crystal
Oscillator as Timer clock source, and Timer stopped.
XR16M698
28
1.62V TO 3.63V HIGH PERFORMANCE OCTAL UART WITH 32-BYTE FIFO
REV. 1.0.0
TIMER OPERATION
The following paragraphs describe the operation of the 16-bit Timer/Counter. The following conventions will be
used in this discussion:
■ ’N’ is the 16-bit value programmed in the TIMER MSB, LSB registers
■ ‘N’ can take any value from 0x0002 to 0xFFFF.
Timer Interrupt
In the one-shot mode, the Timer will issue an interrupt ’N’ clocks after the Timer is started. This is the time
when the Timer times-out in the one-shot mode. In the re-triggerable mode, the Timer will keep issuing an
interrupt every ’N’ clocks. This is shown in Figure 15, where the time between successive time-outs (in re-
triggereble mode) is ’N’ clocks. The Timer interrupt can be cleared by reading the TIMERCNTL register. The
TIMERCNTL will read a value of 0x01 when there is an interrupt and a 0x00 at all other times.
FIGURE 14. TIMER/COUNTER CIRCUIT
Timer Interrupt
TMRCK
OSC. CLOCK
TIMERCNTL
COMMANDS
16-Bit
Timer/Counter
Start/Stop
Timer Interrupt Enable/ Disable
Single shot/Re-triggerable
TIMERMSB and TIMERLSB
(16-bit Value)
0
1
Clock Select
0
1
Timer Interrupt
No Interrupt
相关PDF资料 |
PDF描述 |
|---|---|
| XR16M770IL32-F | IC UART FIFO 64B 32QFN |
| XR16M780IM48-F | IC UART FIFO 64B 48TQFP |
| XR16M781IL32-F | IC UART FIFO 64B 32QFN |
| XR16M890IM48TR-F | IC UART TXRX 128 BYTE 48TQFP |
| XR16V2550IL-F | IC UART FIFO 16B DUAL 32QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR16M698IQ100TR-F | 制造商:Exar Corporation 功能描述:UART 8-CH 32Byte FIFO 1.8V/2.5V/3.3V 100-Pin PQFP T/R 制造商:Exar Corporation 功能描述:XR16M698IQ100TR-F |
| XR16M752 | 制造商:EXAR 制造商全称:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 64-BYTE FIFO |
| XR16M752_09 | 制造商:EXAR 制造商全称:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 64-BYTE FIFO |
| XR16M752IL-0B-EB | 功能描述:UART 接口集成电路 Supports 16M752 32L QFN, PCI Interface RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR16M752IL32 | 制造商:EXAR 制造商全称:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 64-BYTE FIFO |
发布紧急采购，3分钟左右您将得到回复。