- 您现在的位置：买卖IC网 > PDF目录11763 > XRT94L31IB (Exar Corporation)IC MAPPER DS3/E3/STS-1 504TBGA PDF资料下载
参数资料
| 型号： | XRT94L31IB |
| 厂商： | Exar Corporation |
| 文件页数： | 102/133页 |
| 文件大小： | 0K |
| 描述： | IC MAPPER DS3/E3/STS-1 504TBGA |
| 标准包装： | 24 |
| 应用： | 网络切换 |
| 接口： | 总线 |
| 电源电压： | 3.14 V ~ 3.47 V |
| 封装/外壳： | 504-LBGA |
| 供应商设备封装： | 504-TBGA（35x35） |
| 包装： | 托盘 |
| 安装类型： | 表面贴装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页当前第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页
XRT94L31
70
3-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER IC
REV. 1.0.1
N27
RXUCLK/RXPCLK
I
TTL
For mapper applications, Please connect this pin to GND
A16
J23
AC13
EXTLOS_0
EXTLOS_1
EXTLOS_2
I
TTL
Receive LOS (Loss of Signal) Indicator Input (from an off-chip DS3/
E3/STS-1 LIU IC):
These input pins are intended to be connected to a corresponding RLOS
(Receive Loss of Signal) output pin of an off-chip DS3/E3/STS-1 LIU IC.
Through this connection, if a given LIU Channel declares the LOS defect
condition, it will (in-turn) drive the corresponding EXTLOS_n input pin (to
the XRT94L31) to the logic "High" level.
If the a given channel (within the XRT94L31) is configured to operate in
either the DS3 or E3 Mode, and if the off-chip LIU IC asserts the corre-
sponding EXTLOS_n input pin (by driving it to the logic "High" level),
then the DS3/E3 Framer block (within this particular channel) will auto-
matically declare the LOS defect condition (for the duration that this
input pin is driven to a logic "High".
If the LIU Channel toggles this input pin "Low", then the corresponding
DS3/E3 Framer block (within the XRT94L31) will MOST LIKELY clear
the LOS defect condition.
NOTES:
1. The DS3/E3 Framer block can be configured to declare and
clear the LOS defect condition based upon both the state of this
input pin and the content within the incoming DS3/E3 data-
stream.
However,
the
DS3/E3
Framer
block
will
UNCONDITIONALLY declare the LOS defect condition, if its
corresponding EXTLOS_n input pin is driven to the logic "High"
level.
2. These input pins are ignored if their corresponding Channel
has been configured to operate in the STS-1 Mode.
The
Receive STS-1 TOH Processor block will only declare and
clear the LOS defect condition based the number of
consecutive All Zero bytes that are detected within the
incoming STS-1 data-stream.
A14D
20AE
14
RxOOF_0RxOOF_1R
xOOF_2
O
CMOS
Receive STS-1/DS3/E3 Out of Frame IndicatorThe STS-1/DS3/E3
Receive DS3 Framer will assert this output signal whenever it has
declared an Out of Frame (OOF) condition with the incoming DS3
frames. This signal is negated when the framer correctly locates the F-
and M-bits and regains synchronization with the DS3 frame.
A15B
24AG
14
RxLOS_0RxLOS_1R
xLOS_2
O
CMOS
STS-1/DS3/E3 Framer - Loss of Signal Output Indicator:
This pin is asserted when the Receive Section of the channel encoun-
ters 180 consecutive 0's (for DS3 applications) or 32 consecutive 0's (for
E3 applications) via the RxPOS_n and RxNEG pins. For STS-1 applica-
tions, users can set the LOS threshold value in the Receive LOS Thresh-
old register. (RxSTOH_LOS_TH, Address Location: 0xN02E - 0xN02F)
This pin will be negated once the Receive DS3/E3 Framer has detected
at least 60 1s out of 180 consecutive bits (for DS3 applications) or has
detected at least four consecutive 32 bit strings of data that contain at
least 8 1s in the receive path.
PIN DESCRIPTION OF THE XRT94L31 (REV. B)
PIN #
SIGNAL NAME
I/O
TYPE
DESCRIPTION
相关PDF资料 |
PDF描述 |
|---|---|
| 413985-1 | CONN PLUG SMB RG-174 STR GOLD |
| VI-B4P-IW-F1 | CONVERTER MOD DC/DC 13.8V 100W |
| 413589-9 | CONN PLUG BNC RG-59 CRIMP GOLD |
| MS27473T20B1PB | CONN PLUG 79POS STRAIGHT W/PINS |
| 1408149-3 | CONN MMCX PLUG RT ANG RD-316 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT94L31IB-F | 功能描述:网络控制器与处理器 IC Demapper RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| XRT94L31IB-L | 功能描述:网络控制器与处理器 IC Mapper / Demapper RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| XRT94L33 | 制造商:EXAR 制造商全称:EXAR 功能描述:-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER - SONET REGISTERS |
| XRT94L33_06 | 制造商:EXAR 制造商全称:EXAR 功能描述:3-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER IC DATA SHEET |
| XRT94L33_07 | 制造商:EXAR 制造商全称:EXAR 功能描述:3-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER - ATM REGISTERS |
发布紧急采购，3分钟左右您将得到回复。