- 您现在的位置：买卖IC网 > PDF目录11768 > AD9981KSTZ-80 (Analog Devices Inc)IC INTERFACE 10BIT ANALOG 80LQFP PDF资料下载
参数资料
| 型号： | AD9981KSTZ-80 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 44/44页 |
| 文件大小： | 0K |
| 描述： | IC INTERFACE 10BIT ANALOG 80LQFP |
| 标准包装： | 90 |
| 应用： | 视频 |
| 接口： | 模拟 |
| 电源电压： | 3.13 V ~ 3.47 V |
| 封装/外壳： | 80-LQFP |
| 供应商设备封装： | 80-LQFP（14x14） |
| 包装： | 管件 |
| 安装类型： | 表面贴装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页当前第44页
AD9981
Rev. 0 | Page 9 of 44
Pin
Description
REFLO
REFCM
REFHI
Input Amplifier Reference.
REFLO and REFHI are connected together through a 10 F capacitor; REFCM is connected through a 10 F capacitor to
ground. These are used for stability in the input PGA (programmable gain amplifier) circuitry. See Figure 4.
FILT
External Filter Connection.
For proper operation, the pixel clock generator PLL requires an external filter. Connect the filter shown in Figure 5to
this pin. For optimal performance, minimize noise and parasitics on this node. For more information, see the PCB
OUTPUTS
HSOUT
Horizontal Sync Output.
A reconstructed and phase-aligned version of the Hsync input. Both the polarity and duration of this output can be
programmed via serial bus registers. By maintaining alignment with DATACK and Data Output, data timing with
respect to Hsync can always be determined.
VSOUT/A0
Vertical Sync Output.
Pin shared with A0, serial port address. This can be either a separated Vsync from a composite signal or a direct pass
through of the Vsync signal. The polarity of this output can be controlled via a serial bus bit. The placement and
duration in all modes can be set by the graphics transmitter or the duration can be set by Register 0x14 and Register
0x15. This pin is shared with the A0 function, which does not affect Vsync Output functionality. For more details on
A0, see the description in the Serial Control Port section.
SOGOUT
Sync-On-Green Slicer Output.
This pin outputs one of four possible signals (controlled by Register 0x1D, Bits [1:0]): raw SOG, raw Hsync, regenerated
Hsync from the filter, or the filtered Hsync. See the sync processing block diagram (see Figure 8) to view how this pin
is connected. Other than slicing off SOG, the output from this pin gets no other additional processing on the AD9981.
Vsync separation is performed via the sync separator.
O/E FIELD
Odd/Even Field Bit for Interlaced Video. This output will identify whether the current field (in an interlaced signal) is
odd or even.
SERIAL PORT
SDA
Serial Port Data I/O.
SCL
Serial Port Data Clock.
VSOUT/A0
Serial Port Address Input 0.
Pin shared with VSOUT. This pin selects the LSB of the serial port device address, allowing two Analog Devices parts to
be on the same serial bus. A high impedance external pull-up resistor enables this pin to be read at power-up as 1, or
a high impedance, external pull-down resistor enables this pin to be read at power-up as a 0 and not interfere with
the VSOUT functionality. For more details on VSOUT, see the Data Outputs section in this table.
DATA OUTPUTS
RED [9:0]
Data Output, Red Channel.
GREEN [9:0]
Data Output, Green Channel.
BLUE [9:0]
Data Output, Blue Channel.
The main data outputs.
Bit 9 is the MSB. The delay from pixel sampling time to output is fixed. When the sampling time is changed by
adjusting the phase register, the output timing is shifted as well. The DATACK and HSOUT outputs are also moved, so
the timing relationship among the signals is maintained.
DATA CLOCK
OUTPUT
DATACK
Data Clock Output.
This is the main clock output signal used to strobe the output data and HSOUT into external logic. Four possible
output clocks can be selected with Register 0x20, Bits [7:6]. Three of these are related to the pixel clock (pixel clock,
90° phase-shifted pixel clock and 2× frequency pixel clock). They are produced either by the internal PLL clock
generator or EXTCLK and are synchronous with the pixel sampling clock. The fourth option for the data clock output is
an internally generated 40 MHz clock.
The sampling time of the internal pixel clock can be changed by adjusting the phase register (Register 0x04). When
this is changed, the pixel related DATACK timing is also shifted. The Data, DATACK, and HSOUT outputs are all moved
so that the timing relationship among the signals is maintained.
相关PDF资料 |
PDF描述 |
|---|---|
| PIC16LF1906-I/MV | MCU PIC 512B FLASH XLP 28-UQFN |
| VI-B41-IX-F1 | CONVERTER MOD DC/DC 12V 75W |
| MS27505E21B39P | CONN RCPT 39POS BOX MNT W/PINS |
| PIC16F721-I/P | MCU PIC 4K FLASH 20-DIP |
| 5227079-6 | CONN PLUG BNC RG55,223 CRIMP AU |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD9981KSTZ-95 | 功能描述:IC INTERFACE 10BIT ANALOG 80LQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 专用 系列:- 特色产品:NXP - I2C Interface 标准包装:1 系列:- 应用:2 通道 I²C 多路复用器 接口:I²C，SM 总线 电源电压:2.3 V ~ 5.5 V 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:剪切带 (CT) 安装类型:表面贴装 产品目录页面:825 (CN2011-ZH PDF) 其它名称:568-1854-1 |
| AD9981XSTZ-110 | 制造商:Analog Devices 功能描述:HIGH PERFORMANCE 10-BIT DISPLAY INTERFACE - Bulk |
| AD9983A | 制造商:AD 制造商全称:Analog Devices 功能描述:High Performance 8-Bit Display Interface |
| AD9983A/PCB | 制造商:AD 制造商全称:Analog Devices 功能描述:High Performance 8-Bit Display Interface |
| AD9983A/PCBZ | 功能描述:KIT EVALUATION AD9983A RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:Advantiv® 标准包装:1 系列:PCI Express® (PCIe) 主要目的:接口，收发器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要属性:- 次要属性:- 已供物品:板 |
发布紧急采购，3分钟左右您将得到回复。