- 您现在的位置：买卖IC网 > PDF目录1915 > DS31256+ (Maxim Integrated Products)IC CTRLR HDLC 256-CHANNEL 256BGA PDF资料下载
参数资料
| 型号： | DS31256+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 179/183页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR HDLC 256-CHANNEL 256BGA |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 40 |
| 控制器类型： | HDLC 控制器 |
| 接口： | 串行 |
| 电源电压： | 3 V ~ 3.6 V |
| 电流 - 电源： | 500mA |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 256-BBGA |
| 供应商设备封装： | 256-BGA（27x27） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页第161页第162页第163页第164页第165页第166页第167页第168页第169页第170页第171页第172页第173页第174页第175页第176页第177页第178页当前第179页第180页第181页第182页第183页
DS31256 256-Channel, High-Throughput HDLC Controller
95 of 183
Status/Interrupts
On each read of the free queue by the DMA, the DMA sets either the status bit for receive DMA large
buffer read (RLBR) or the status bit for receive DMA small buffer read (RSBR) in the status register for
DMA (SDMA). The DMA also checks the receive free-queue large-buffer host write pointer and the
receive free-queue small-buffer host write pointer to ensure that an underflow does not occur. If it does
occur, the DMA sets either the status bit for receive DMA large buffer read error (RLBRE) or the status
bit for receive DMA small buffer read error (RSBRE) in the status register for DMA (SDMA), and it
does not read the free queue nor does it increment the read pointer. In such a scenario, the receive FIFO
can overflow if the host does not provide free-queue descriptors. Each of the status bits can also (if
enabled) cause a hardware interrupt to occur. See Section 5 for more details.
Free-Queue Burst Reading
The DMA can read the free queue in bursts, which allows for a more efficient use of the PCI bus. The
DMA can grab messages from the free queue in groups rather than one at a time, freeing up the PCI bus
for more time-critical functions.
An internal FIFO stores up to 16 free-queue descriptors (32 dwords, as each descriptor occupies two
dwords). The free queue can either opeate in dual or singular circular queue mode. It can be divided into
large buffer and small buffer. The LBSA (large buffer starting address) and the LBEA (large buffer
ending address) form the large buffer queue, and the SBSA (small buffer starting address) and the
RFQEA (receive free-queue end address) form the small buffer queue. When the SBSA is not equal to
and greater than the RFQEA, the free queue is set up in a dual circular mode. If the SBSA is equal to the
FRQEA, the free queue is operating in a single queue mode. When the free queue is operated as a dual
circular queue supporting both large and small buffers, then the FIFO is cut into two 8-message FIFOs. If
the free queue is operated as a single circular queu supporting only the large buffers, then the FIFO is set
up as a single 16-descriptor FIFO. The host must configure the free-queue FIFO for proper operation
through the receive DMA queues control (RDMAQ) register (see the following).
When enabled through the receive free-queue FIFO-enable (RFQFE) bit, the free-queue FIFO does not
read the free queue until it reaches the low watermark. When the FIFO reaches the low watermark
(which is two descriptors in the dual mode or four descriptors in the single mode), it attempts to fill the
FIFO with additional descriptors by burst reading the free queue. Before it reads the free queue, it checks
(by examining the receive free-queue host write pointer) to ensure the free queue contains enough
descriptors to fill the free-queue FIFO. If the free queue does not have enough descriptors to fill the
FIFO, it only reads enough to keep from underflowing the free queue. If the FIFO detects that there are
no free-queue descriptors available for it to read, then it sets either the status bit for the receive DMA
large buffer read error (RLBRE) or the status bit for the receive DMA small buffer read error (RSBRE)
in the status register for DMA (SDMA); it does not read the free queue nor does it increment the read
pointer. In such a scenario, the receive FIFO can overflow if the host does not provide free-queue
descriptors. If the free-queue FIFO can read descriptors from the free queue, it burst reads them,
increments the read pointer, and sets either the status bit for receive DMA large buffer read (RLBR) or
the status bit for the receive DMA small buffer read (RSBR) in the status register for DMA (SDMA).
See Section 5 for more details on status bits.
相关PDF资料 |
PDF描述 |
|---|---|
| DS3141+ | IC FRAMER DS3/E3 SNGL 144CSBGA |
| DS31412N | IC 12CH DS3/3 FRAMER 349-BGA |
| DS3150TN | IC LIU T3/E3/STS-1 IND 48-TQFP |
| DS3154N+ | IC LIU DS3/E3/STS-1 QD 144CSBGA |
| DS3164+ | IC ATM/PACKET PHY QUAD 400-BGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS31256+ | 功能描述:输入/输出控制器接口集成电路 256Ch High Thruput HDLC Cntlr RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
| DS31256B | 功能描述:输入/输出控制器接口集成电路 256Ch High Thruput HDLC Cntlr RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
| DS31256DK | 功能描述:网络开发工具 RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
| DS31256-W+ | 制造商:Maxim Integrated Products 功能描述:ENVOY 256 CHANNEL HDLC - WAIVER - Rail/Tube |
| DS312BNC | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Industrial Control IC |
发布紧急采购，3分钟左右您将得到回复。