- 您现在的位置：买卖IC网 > PDF目录1809 > IR3514MTRPBF (International Rectifier)IC XPHASE3 CONTROL HYBRD 40-MLPQ PDF资料下载
参数资料
| 型号： | IR3514MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 28/46页 |
| 文件大小： | 0K |
| 描述： | IC XPHASE3 CONTROL HYBRD 40-MLPQ |
| 产品变化通告： | (EP) Parts Discontinuation 25/May/2012 |
| 标准包装： | 1 |
| 系列： | XPhase3™ |
| 应用： | 处理器 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-MLPQ |
| 供应商设备封装： | 40-MLPQ（6x6） |
| 包装： | 标准包装 |
| 产品目录页面： | 1383 (CN2011-ZH PDF) |
| 其它名称： | IR3514MTRPBFDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
IR3514
Over Voltage Protection (OVP)
Output over-voltage might occur due to a high side MOSFET short or if the output voltage sense path is
compromised. If the over-voltage protection comparators sense that either VOUT X pin voltage exceeds VDAC X by
125mV, the over voltage fault latch is set which pulls the error amplifier output low to turn off the converter power
stage. The IR3514 communicates an OVP condition to the system by raising the ROSC/OVP pin voltage to within
V(VCCL) – 1.2V. An OVP condition is also communicated to the phase ICs by forcing the IIN pin (which is tied to
the ISHARE bus and ISHARE pins of the phase ICs) to VCCL as shown in Figure 15. In each phase IC, the OVP
circuit overrides the normal PWM operation to ensure the low side MOSFET turn-on within approximately 150ns.
The low side MOSFET will remain on until the ISHARE pins fall below V(VCCL) - 800mV. An over voltage fault
condition is latched in the IR3514 and can only be cleared by cycling the power to VCCL. Output 2 OVP is disabled
in PVI mode.
During dynamic VID down at light to no load, false OVP triggering is prevented by increasing the OVP threshold to a
fixed 1.6V whenever a dynamic VID is detected and the difference between output voltage and the fast internal
VDAC is more than 50mV, as shown in Figure 16. The over-voltage threshold is changed back to VDAC+125mV if
the difference between output voltage and the fast internal VDAC is less than 50mV.
The overall system must be considered when designing for OVP. In many cases the over-current protection of the
AC-DC or DC-DC converter supplying the multiphase converter will be triggered thus providing effective protection
without damage as long as all PCB traces and components are sized to handle the worst-case maximum current. If
this is not possible, a fuse can be added in the input supply to the multiphase converter.
OUTPUT
VOLTAGE
(Vout)
IIN
(PHASE IC
ISHARE)
GATEH
(PHASE IC)
GATEL
(PHASE IC)
FAULT
LATCH
ERROR
AMPLIFIER
OUTPUT
(EAOUT)
OVP
THRESHOLD
VCCL-800 mV
VDAC
NORMAL OPERATION
OVP CONDITION
AFTER
OVP
Figure 15 - Over-voltage protection during normal operation
Page 28 of 46
10/30/2007
相关PDF资料 |
PDF描述 |
|---|---|
| IR3521MTRPBF | IC CTRL XPHASE3 SVID 32-MLPQ |
| IR3522MTRPBF | IC CTRL XPHASE3 DDR/VVT 32-MLPQ |
| IR3523MTRPBF | IC XPHASE3 CTLR VR11.1 40-MLPQ |
| IR3527MTRPBF | IC CTRL XPHASE3 DUAL 24-MLPQ |
| IR3529MTRPBF | IC CTRL XPHASE CPU/ASIC 20-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3515SPBF | 制造商:International Rectifier 功能描述:MOSFET, Power;N-Ch;VDSS 150V;RDS(ON) 0.045Ohm;ID 41A;D2Pak;PD 200W;VGS +/-30V |
| IR3519 | 制造商:IRF 制造商全称:International Rectifier 功能描述:Synchronous MOSFET GateDriver IC |
| IR3519MTRPBF | 功能描述:功率驱动器IC SYNC MOSFET GATE DRVR IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| IR3519STRPBF | 功能描述:功率驱动器IC SYNC FET Gate DRVR 15ms 3.3 and 5V 0.4 RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| IR3521 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM AMD SVID CONTROL IC |
发布紧急采购，3分钟左右您将得到回复。