参数资料
型号: ISL35822IK
厂商: Intersil
文件页数: 33/75页
文件大小: 0K
描述: IC CLOCK/DATA RECOVERY 192EBGA-B
标准包装: 90
类型: 时钟和数据恢复(CDR),多路复用器
PLL:
输入: CML
输出: CML,CMOS
电路数: 1
比率 - 输入:输出: 8:8
差分 - 输入:输出: 是/是
频率 - 最大: 3.1875Gbps
电源电压: 1.425 V ~ 1.575 V
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 192-EBGA
供应商设备封装: 192-EBGA-B(17x17)
包装: 托盘
39
IEEE PCS REGISTERS (3.0 TO 3.25/3.0019’H)
Note (1): This bit is not permitted to be a PCS loopback bit by IEEE 802.3ae-2002 subclause 45.2.3.1.2 in 10GBASE-X PCS devices. Intersil has submitted a
maintenance request (#1113) to allow that use of this bit. Many XENPAK hosts, however, expect this loopback (which is mandatory for 10GBASE-R PCS
devices). Setting the 3.C001’h.7 bit, (Table 64) will activate this loopback enable bit, but cause the ISL35822 to be non-conforming to the current 802.3
Note (1): This bit is latched low on a detected Fault condition. It is set high on being read.
Note (1): Although the 802.3ae specification describes this register as type R/W, this register cannot have any value other than that reflecting the 10GBASE-X PCS.
Thus writing any other value is ignored, and the register is in effect type RO.
Table 57. IEEE PCS CONTROL 1 REGISTER
MDIO REGISTER ADDRESS = 3.0 (3.0000’h)
BIT(S)
NAME
SETTING
DEFAULT
R/W
DESCRIPTION
3.0.15
1.0.15
4.0.15
Reset
1 = reset
0 = reset done, normal
operation
0’b
R/W SC Writing 1 to this bit will reset the whole chip,
including the MDIO registers.
3.0.14(1)
PCS_LB_EN
Optionally, enable PCS
Loopback, otherwise
reserved
0’b
R/W
If enabled by EN_PCS_LB (see bit 3.C001’h.7,
Table 64) perform PCS Loopback, and is a R/W bit;
otherwise, effectively a reserved RO 0’b bit (1).
3.0.13
Speed Select
1 = 10Gbps
1’b
RO
1 = bits 5:2 select speed
3.0.12
Reserved
00’h
3.0.11
LOPOWER
0 = Normal Power
0’b
R/W
No Low Power Mode, writes ignored
3.0.10:7
Reserved
3.0.6
Speed Select
1 = 10Gbps
1’b
RO
1 = bits 5:2 select speed
3.0.5:2
Speed Select
0000 = 10Gbps
0’h
RO
Operates at 10Gbps
3.0.1:0
Reserved
0’b
Table 58. IEEE PCS STATUS 1 REGISTER
MDIO REGISTER ADDRESS = 3.1 (3.0001’h)
BIT
NAME
SETTING
DEFAULT
R/W
DESCRIPTION
3.1.15:8
Reserved
00’h
3.1.7
Local Fault
1 = PCS Local Fault
0
RO
Derived from Register 3.0008’h
3.1.6:3
Reserved
0’h
3.1.2
Rx Link Up
1 = PCS Rx Link Up
0 = PCS Rx Link Down
1 (1)
RO LL(1)
‘Up’ means CX4/LX4 signal level is OK, Byte
Synch and Lane-Lane Alignment have all
occurred
3.1.1
LoPwrAble
Low Power Ability
0
RO
Device does not support a low power mode
3.1.0
Reserved
0
Table 59. IEEE PCS TYPE SELECT REGISTER
MDIO REGISTER ADDRESS = 3.7 (3.0007’h)
BIT
NAME
SETTING
DEFAULT
R/W
DESCRIPTION
3.7.15:2
Reserved
000’h
3.7.1:0
PCS Type
01 = 10GBASE-X
01b
RO(1)
Writes ignored
ISL35822
相关PDF资料
PDF描述
VI-22Y-MX-S CONVERTER MOD DC/DC 3.3V 49.5W
VI-22Y-MW-S CONVERTER MOD DC/DC 3.3V 66W
MS27474E16B55PA CONN RCPT 55POS JAM NUT W/PINS
V24A24M300BF3 CONVERTER MOD DC/DC 24V 300W
D38999/24KC4SA CONN RCPT 4POS JAM NUT W/SCKT
相关代理商/技术参数
参数描述
ISL35822LP 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Octal 2.488Gbps to 3.187Gbps/ Lane Retimer
ISL35822LPIK 功能描述:IC CLOCK/DATA RECOVERY 192EBGA-B RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 专用 系列:- 标准包装:1,500 系列:- 类型:时钟缓冲器/驱动器 PLL:是 主要目的:- 输入:- 输出:- 电路数:- 比率 - 输入:输出:- 差分 - 输入:输出:- 频率 - 最大:- 电源电压:3.3V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SSOP(0.209",5.30mm 宽) 供应商设备封装:28-SSOP 包装:带卷 (TR) 其它名称:93786AFT
ISL36111 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:11.1Gb/s Lane Extender
ISL36111DRZ-EVALZ 功能描述:EVAL BOARD FOR ISL36111DRZ RoHS:是 类别:编程器,开发系统 >> 评估演示板和套件 系列:* 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- 主要目的:电源管理,电池充电器 嵌入式:否 已用 IC / 零件:MAX8903A 主要属性:1 芯锂离子电池 次要属性:状态 LED 已供物品:板
ISL36111DRZ-T7 功能描述:IC EQUALIZER REC 11.1GBPS 16QFN RoHS:是 类别:集成电路 (IC) >> 接口 - 专用 系列:QLx™ 特色产品:NXP - I2C Interface 标准包装:1 系列:- 应用:2 通道 I²C 多路复用器 接口:I²C,SM 总线 电源电压:2.3 V ~ 5.5 V 封装/外壳:16-TSSOP(0.173",4.40mm 宽) 供应商设备封装:16-TSSOP 包装:剪切带 (CT) 安装类型:表面贴装 产品目录页面:825 (CN2011-ZH PDF) 其它名称:568-1854-1