参数资料
型号: LTC1735CGN-1#TRPBF
厂商: Linear Technology
文件页数: 14/28页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 16-SSOP
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 335kHz
占空比: 99.4%
电源电压: 3.5 V ~ 30 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: 0°C ~ 85°C
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
包装: 带卷 (TR)
LTC1735-1
APPLICATIO S I FOR ATIO
Manufacturers such as Nichicon, United Chemicon and
Sanyo can be considered for high performance through-
hole capacitors. The OS-CON semiconductor dielectric
capacitor available from Sanyo has the lowest (ESR)(size)
product of any aluminum electrolytic at a somewhat
higher price. An additional ceramic capacitor in parallel
with OS-CON capacitors is recommended to reduce the
inductance effects.
In surface mount applications, multiple capacitors may
need to be used in parallel to meet the ESR, RMS current
handling and load step requirements of the application.
Aluminum electrolytic, dry tantalum and special polymer
capacitors are available in surface mount packages. Special
polymer surface mount capacitors offer very low ESR but
have much lower capacitive density per unit volume than
other capacitor types. These capacitors offer a very cost-
effective output capacitor solution and are an ideal choice
when combined with a controller having high loop
bandwidth. Tantalum capacitors offer the highest
capacitance density and are often used as output capacitors
for switching regulators having controlled soft-start.
Several excellent surge-tested choices are the AVX TPS,
AVX TPSV or the KEMET T510 series of surface mount
tantalums, available in case heights ranging from 2mm to
4mm. Aluminum electrolytic capacitors can be used in
cost-driven applications providing that consideration is
given to ripple current ratings, temperature and long-term
reliability. A typical application will require several to many
aluminum electrolytic capacitors in parallel. A combination
of the above mentioned capacitors will often result in
maximizing performance and minimizing overall cost.
Other capacitor types include Sanyo OS-CON, Nichicon PL
series and Sprague 595D series. Consult manufacturers
for other specific recommendations.
INTV CC Regulator
An internal P-channel low dropout regulator produces the
5.2V supply that powers the drivers and internal circuitry
within the LTC1735-1. The INTV CC pin can supply a
maximum RMS current of 50mA and must be bypassed
to ground with a minimum of 4.7 μ F tantalum, 10 μ F
special polymer or low ESR type electrolytic capacitor. A
1 μ F ceramic capacitor placed directly adjacent to the
14
INTV CC and PGND IC pins is highly recommended. Good
bypassing is required to supply the high transient cur-
rents required by the MOSFET gate drivers.
Higher input voltage applications in which large MOSFETs
are being driven at high frequencies may cause the maxi-
mum junction temperature rating for the LTC1735-1 to be
exceeded. The system supply current is normally domi-
nated by the gate charge current. Additional loading of
INTV CC also needs to be taken into account for the power
dissipation calculations. The total INTV CC current can be
supplied by either the 5.2V internal linear regulator or by
the EXTV CC input pin. When the voltage applied to the
EXTV CC pin is less than 4.7V, all of the INTV CC current is
supplied by the internal 5.2V linear regulator. Power
dissipation for the IC in this case is highest, (V IN )(I INTVCC ),
and overall efficiency is lowered. The gate charge current
is dependant on operating frequency as discussed in the
Efficiency Consideration section. The junction tempera-
ture can be estimated by using the equations given in Note
2 of the Electrical Characteristics. For example, the
LTC1735CS-1 is limited to less than 17mA from a 30V
supply when not using the EXTV CC pin as follows:
T J = 70 ° C + (17mA)(30V)(110 ° C/W) = 126 ° C
Use of the EXTV CC input pin reduces the junction tempera-
ture to:
T J = 70 ° C + (17mA)(5V)(110 ° C/W) = 79 ° C
To prevent maximum junction temperature from being
exceeded, the input supply current must be checked
operating in continuous mode at maximum V IN .
EXTV CC Connection
The LTC1735-1 contains an internal P-channel MOSFET
switch connected between the EXTV CC and INTV CC pins.
Whenever the EXTV CC pin is above 4.7V the internal 5.2V
regulator shuts off, the switch closes and INTV CC power is
supplied via EXTV CC until EXTV CC drops below 4.5V. This
allows the MOSFET gate drive and control power to be
derived from the output or other external source during
normal operation. When the output is out of regulation
(start-up, short circuit) power is supplied from the internal
regulator. Do not apply greater than 7V to the EXTV CC pin
and ensure that EXTV CC < V IN .
相关PDF资料
PDF描述
UPS2E470MHD CAP ALUM 47UF 250V 20% RADIAL
RBC20DRYI-S734 CONN EDGECARD 40POS DIP .100 SLD
UPM2E330MHD1TN CAP ALUM 33UF 250V 20% RADIAL
VI-2WD-EW-F2 CONVERTER MOD DC/DC 85V 100W
VI-JWN-EW-F4 CONVERTER MOD DC/DC 18.5V 100W
相关代理商/技术参数
参数描述
LTC1735CGNPBF 制造商:Linear Technology 功能描述:Regulator Synch Step Down LTC1735CGN
LTC1735CS 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC1735CS#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC1735CS#TR 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC1735CS#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)