参数资料
型号: LTC1735CGN-1#TRPBF
厂商: Linear Technology
文件页数: 17/28页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 16-SSOP
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 335kHz
占空比: 99.4%
电源电压: 3.5 V ~ 30 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: 0°C ~ 85°C
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
包装: 带卷 (TR)
LTC1735-1
APPLICATIO S I FOR ATIO
I SC =
+ ? I L ( SC )
current, C SS is used as a short-circuit timer. If the output
voltage falls to less than 70% of its nominal output voltage
after C SS reaches 4.1V, the assumption is made that the
output is in a severe overcurrent and/or short-circuit
condition and C SS begins discharging. If the condition
lasts for a long enough period as determined by the size of
C SS , the controller will be shut down until the RUN/SS pin
voltage is recycled.
This built-in latchoff can be overridden by providing a
current > 5 μ A at a compliance of 5V to the RUN/SS pin as
shown in Figure 5a. This current shortens the soft-start
period but also prevents net discharge of the RUN/SS
capacitor during a severe overcurrent and/or short-circuit
conditions. When deriving the 5 μ A current from V IN as in
Figure 5a, current latchoff is always defeated. The diode
connecting this pull-up resistor to INTV CC , as in Figure 5b,
eliminates any extra supply current during shutdown
while eliminating the INTV CC loading from preventing
controller start-up. If the voltage on C SS does not exceed
4.1V, the overcurrent latch is not armed and the function
is disabled.
Why should you defeat current latchoff? During the
prototyping stage of a design, there may be a problem with
noise pickup or poor layout causing the protection circuit
to latch off. Defeating this feature will easily allow trouble-
shooting of the circuit and PC layout. The internal short
circuit and foldback current limiting still remains active,
thereby protecting the power supply system from failure.
After the design is complete, a decision can be made
whether to enable the latchoff feature.
The value of the soft-start capacitor C SS will need to be
scaled with output current, output capacitance and load
current characteristics. The minimum soft-start capaci-
tance is given by:
C SS > (C OUT )(V OUT ) (10 –4 ) (R SENSE )
The minimum recommended soft-start capacitor of
C SS = 0.1 μ F will be sufficient for most applications.
Fault Conditions: Current Limit and Current Foldback
The LTC1735-1 current comparator has a maximum sense
voltage of 75mV resulting in a maximum MOSFET current
of 75mV/R SENSE .
The LTC1735-1 includes current foldback to help further
limit load current when the output is shorted to ground. If
the output falls by more than half, then the maximum
sense voltage is progressively lowered from 75mV to
30mV. Under short-circuit conditions with very low duty
cycles, the LTC1735-1 will begin cycle skipping in order to
limit the short-circuit current. In this situation the bottom
MOSFET will be conducting the peak current. The short-
circuit ripple current is determined by the minimum on-
time t ON(MIN) of the LTC1735-1 (less than 200ns), the
input voltage, and inductor value:
? I L(SC) = t ON(MIN) (V IN /L)
The resulting short circuit-current is:
30 mV 1
R SENSE 2
The current foldback function is always active and is not
effected by the current latchoff function.
Fault Conditions: Output Overvoltage Protection
(Crowbar)
The output overvoltage crowbar is designed to blow a
system fuse in the input lead when the output of the
regulator rises much higher than nominal levels. This
condition causes huge currents to flow, much greater than
in normal operation. This feature is designed to protect
against a shorted top MOSFET; it does not protect against
a failure of the controller itself.
The comparator (OV in the Functional Diagram) detects
overvoltage faults greater than 7.5% above the nominal
output voltage. When this condition is sensed the top
MOSFET is turned off and the bottom MOSFET is forced
on. The bottom MOSFET remains on continuously for as
long as the OV condition persists; if V OUT returns to a safe
level, normal operation automatically resumes. Note that
dynamically changing the output voltage may cause over-
voltage protection to be momentarily activated during
output voltage decreases. This will not cause permanent
latchoff nor will it disrupt the desired voltage change.
With soft-latch overvoltage protection, dynamically chang-
ing the output voltage is allowed and the overvoltage
protection tracks the newly programmed output voltage,
always protecting the load (CPU).
17
相关PDF资料
PDF描述
UPS2E470MHD CAP ALUM 47UF 250V 20% RADIAL
RBC20DRYI-S734 CONN EDGECARD 40POS DIP .100 SLD
UPM2E330MHD1TN CAP ALUM 33UF 250V 20% RADIAL
VI-2WD-EW-F2 CONVERTER MOD DC/DC 85V 100W
VI-JWN-EW-F4 CONVERTER MOD DC/DC 18.5V 100W
相关代理商/技术参数
参数描述
LTC1735CGNPBF 制造商:Linear Technology 功能描述:Regulator Synch Step Down LTC1735CGN
LTC1735CS 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC1735CS#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC1735CS#TR 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC1735CS#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)