- 您现在的位置：买卖IC网 > PDF目录15296 > LTC3838EUHF#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 38-QFN PDF资料下载
参数资料
| 型号： | LTC3838EUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/54页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 38-QFN |
| 标准包装： | 2,500 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
LTC3838
OPERATION (Refer to Functional Diagram)
Main Control Loop
The LTC3838 is a controlled on-time, valley current mode
step-down DC/DC dual controller with two channels
operating out of phase. Each channel drives both main
and synchronous N-channel MOSFETs. The two channels
can be either configured to two independently regulated
outputs, or combined into a single output.
The top MOSFET is turned on for a time interval determined
by a one-shot timer. The duration of the one-shot timer is
controlled to maintain a fixed switching frequency. As the
top MOSFET is turned off, the bottom MOSFET is turned
on after a small delay. The delay, or dead time, is to avoid
both top and bottom MOSFETs being on at the same time,
causing shoot-through current from V IN directly to power
ground. The next switching cycle is initiated when the cur-
rent comparator, I CMP , senses that inductor current falls
below the trip level set by voltages at the ITH and V RNG
pins. The bottom MOSFET is turned off immediately and
the top MOSFET on again, restarting the one-shot timer
and repeating the cycle. In order to avoid shoot-through
current, there is also a small dead-time delay before the
top MOSFET turns on. At this moment, the inductor cur-
rent hits its “valley” and starts to rise again.
Inductor current is determined by sensing the voltage
between SENSE + and SENSE – , either by using an explicit
resistor connected in series with the inductor or by implic-
itly sensing the inductor’s DC resistive (DCR) voltage drop
through an RC filter connected across the inductor. The
trip level of the current comparator, I CMP , is proportional
to the voltage at the ITH pin, with a zero-current threshold
corresponding to an ITH voltage of around 0.8V.
The error amplifier (EA) adjusts this ITH voltage by com-
paring the feedback signal to the internal 0.6V reference
voltage. On Channel 1, the difference amplifier (DIFFAMP)
converts the differential feedback signal (V OUTSENSE1+ –
V OUTSENSE1– ) to a single-ended input for the EA; Channel?2
uses V FB2 directly with respect to SGND. Output voltage is
regulated so that the feedback voltage is equal to the internal
0.6V reference. If the load current increases/decreases, it
causes a momentary drop/rise in the differential feedback
voltage relative to the reference. The EA then moves ITH
voltage, or inductor valley current setpoint, higher/lower
until the average inductor current again matches the load
current, so that the output voltage comes back to the
regulated voltage.
The LTC3838 features a detect transient (DTR) pin to detect
“load-release”, or a transient where the load current sud-
denly drops, by monitoring the first derivative of the ITH
voltage. When detected, the bottom gate (BG) is turned
off and inductor current flows through the body diode
in the bottom MOSFET, allowing the SW node voltage to
drop below PGND by the body diode’s forward-conduction
voltage. This creates a more negative differential voltage
(V SW – V OUT ) across the inductor, allowing the inductor
current to drop faster to zero, thus creating less overshoot
on V OUT . See Load-Release Transient Detection in Applica-
tions Information for details.
Differential Output Sensing
This dual controller’s first channel features differential
output voltage sensing. The output voltage is resistively
divided externally to create a feedback voltage for the con-
troller. The internal difference amplifier (DIFFAMP) senses
this feedback voltage with respect to the output’s remote
ground reference to create a differential feedback voltage.
This scheme eliminates any ground offsets between local
ground and remote output ground, resulting in a more
accurate output voltage. Channel 1 allows remote output
ground to deviate as much as ±500mV with respect to
local ground (SGND).
DRV CC /EXTV CC /INTV CC Power
DRV CC1,2 are the power for the bottom MOSFET drivers.
Normally the two DRV CC pins are shorted together on
the PCB, and decoupled to PGND with a minimum 4.7μF
ceramic capacitor, C DRVCC . The top MOSFET drivers are
biased from the floating bootstrap capacitors (C B1,2 )
which are recharged during each cycle through an external
Schottky diode when the top MOSFET turns off and the
SW pin swings down.
The DRV CC can be powered on two ways: an internal low-
dropout (LDO) linear voltage regulator that is powered
3838fa
14
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3856EUH#TRPBF | IC REG CTRLR BUCK PWM CM 38-QFN |
| SXR222M010ST | CAP ALUM 2200UF 10V 20% RADIAL |
| LTC3855EUJ#TRPBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| UCY2C121MHD | CAP ALUM 120UF 160V 20% RADIAL |
| LT1950IGN | IC REG CTRLR PWM CM 16-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3838IFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3838IFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3838IUHF#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3838IUHF#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3838IUHF-1#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 38QFN 制造商:Linear Technology 功能描述:BUCK DUAL CNTRL 4.5-38V 2MHZ 38QFN 制造商:Linear Technology 功能描述:BUCK, DUAL, CNTRL, 4.5-38V, 2MHZ, 38QFN 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Dual, Fast, Accurate Step-Down Controller with Differential 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, DUAL, BUCK, ADJ, QFN-38, Primary Input Voltage:38V, No. of Outputs:2, Output Current:25A, No. of Pins:38, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。