- 您现在的位置：买卖IC网 > PDF目录15296 > LTC3838EUHF#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 38-QFN PDF资料下载
参数资料
| 型号： | LTC3838EUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 44/54页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 38-QFN |
| 标准包装： | 2,500 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页当前第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
LTC3838
APPLICATIONS INFORMATION
? The path formed by the top and bottom N-channel
MOSFETs, and the C IN capacitors should have short
leads and PCB trace. The (–) terminal of output capaci-
tors should be connected close to the (–) terminal of
C IN , but away from the loop described above. This is
to achieve an effect of Kevin (4-wire) connection to the
input ground so that the “chopped” switching current
will not flow through the path between the input ground
and the output ground, and cause common mode output
voltage ripple.
? Several smaller sized ceramic output capacitors, C OUT ,
can be placed close to the sense resistors and before
the rest bulk output capacitors.
? The filter capacitor between the SENSE + and SENSE – pins
should always be as close as possible to these pins.
Ensure accurate current sensing with Kevin (4-wire)
connections to the soldering pads from underneath
the sense resistors or inductor. A pair of sense traces
should be routed together with minimum spacing.
R SENSE , if used, should be connected to the inductor
on the noiseless output side, and its filter resistors
close to the SENSE + /SENSE – pins. For DCR sensing,
however, filter resistor should be placed close to the
inductor, and away from the SENSE + /SENSE – pins, as
its terminal is the SW node.
? Keep small-signal components connected noise-sensi-
tive pins (give priority to SENSE + /SENSE – , V OUTSENSE1+ /
V OUTSENSE1– , V FB2 , RT , ITH, V RNG pins) on the left hand
side of the IC as close to their respective pins as pos-
sible. This minimizes the possibility of noise coupling
into these pins. If the LTC3838 can be placed on the
bottom side of a multilayer board, use ground planes
to isolate from the major power components on the top
side of the board, and prevent noise coupling to noise
sensitive components on the bottom side.
? Place the resistor feedback divider R FB1 , R FB2 close to
V OUTSENSE1+ and V OUTSENSE1– pins for Channel 1, or
V FB2 pin for Channel 2, so that the feedback voltage
tapped from the resistor divider will not be disturbed by
noise sources. Route remote sense PCB traces (use a
pair of wires closely together for differential sensing in
Channel 1) directly to the terminals of output capacitors
for best output regulation.
? Place decoupling capacitors C ITH2 next to the ITH and
SGND pins with short, direct trace connections.
? Use sufficient isolation when routing a clock signal into
the MODE/PLLIN pin or out of the CLKOUT pin, so that
the clock does not couple into sensitive pins.
? Place the ceramic decoupling capacitor C INTVCC between
the INTV CC pin and SGND and as close as possible to
the IC.
? Place the ceramic decoupling capacitor C DRVCC close
to the IC, between the combined DRV CC1,2 pins and
PGND.
? Filter the V IN input to the LTC3838 with an RC filter.
Place the filter capacitor close to the V IN pin.
? If vias have to be used, use immediate vias to connect
components to the SGND and PGND planes of LTC3838.
Use multiple large vias for power components.
? Flood all unused areas on all layers with copper. Flooding
with copper will reduce the temperature rise of power
components. Connect the copper areas to DC rails only,
e.g., PGND.
PCB Layout Debugging
Only after each controller is checked for its individual
performance should both controllers be turned on at the
same time. It is helpful to use a current probe to monitor
the current in the inductor while testing the circuit. Monitor
the output switching node (SW pin) to synchronize the
oscilloscope to the internal oscillator output CLKOUT, or
external clock if used. Probe the actual output voltage as
well. Check for proper performance over the operating
voltage and current range expected in the application.
The frequency of operation should be maintained over
the input voltage range. The phase should be maintained
3838fa
44
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3856EUH#TRPBF | IC REG CTRLR BUCK PWM CM 38-QFN |
| SXR222M010ST | CAP ALUM 2200UF 10V 20% RADIAL |
| LTC3855EUJ#TRPBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| UCY2C121MHD | CAP ALUM 120UF 160V 20% RADIAL |
| LT1950IGN | IC REG CTRLR PWM CM 16-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3838IFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3838IFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3838IUHF#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3838IUHF#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3838IUHF-1#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 38QFN 制造商:Linear Technology 功能描述:BUCK DUAL CNTRL 4.5-38V 2MHZ 38QFN 制造商:Linear Technology 功能描述:BUCK, DUAL, CNTRL, 4.5-38V, 2MHZ, 38QFN 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Dual, Fast, Accurate Step-Down Controller with Differential 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, DUAL, BUCK, ADJ, QFN-38, Primary Input Voltage:38V, No. of Outputs:2, Output Current:25A, No. of Pins:38, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。