- 您现在的位置：买卖IC网 > PDF目录15296 > LTC3838EUHF#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 38-QFN PDF资料下载
参数资料
| 型号： | LTC3838EUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 36/54页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 38-QFN |
| 标准包装： | 2,500 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 2 |
| 频率 - 最大： | 2MHz |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
LTC3838
APPLICATIONS INFORMATION
to the inductor current setpoint. A load transient will
result in a quick change of this load current setpoint, i.e.,
a negative spike of the first derivative of the ITH voltage.
The LTC3838 uses a detect transient (DTR) pin to monitor
Note the internal 2.5μA pull-up current from the DTR pin
will generate an additional offset on top of the resistor
divider itself, making the total difference between the DC
bias voltage on the DTR pin and half INTV CC :
V DTR – 0.5V INTVCC = ?
– 0.5 ? ? 5.3V
thefirstderivativeoftheITHvoltage,anddetecttheload-
release transient. Referring to the Functional Diagram, the
DTR pin is the input of a DTR comparator, and the internal
? R ITH1
? (R ITH1 + R ITH2 )
?
?
reference voltage for the DTR comparator is half of INTV CC .
To use this pin for transient detection, ITH compensation
needs an additional R ITH resistor tied to INTV CC , and con-
nects the junction point of ITH compensation components
C ITH1 , R ITH1 and R ITH2 to the DTR pin as shown in the
Functional Diagram. The DTR pin is now proportional to
the first derivative of the inductor current setpoint, through
the highpass filter of C ITH1 and (R ITH1 //R ITH2 ).
The two R ITH resistors establish a voltage divider from
INTV CC to SGND, and bias the DC voltage on DTR pin (at
steady-state load or ITH voltage) slightly above half of
INTV CC . Compensation performance will be identical by
using the same C ITH1 and make R ITH1 //R ITH2 equal the
R ITH as used in conventional single resistor OPTI-LOOP
compensation. This will also provide the R-C time constant
needed for the DTR duration. The DTR sensitivity can be
adjusted by the DC bias voltage difference between DTR
and half INTV CC . This difference could be set as low as
200mV, as long as the ITH ripple voltage with DC load
current does not trigger the DTR.
SW
5V/DIV
+ 2.5μA ? ( R ITH1 / /R ITH2 )
As illustrated in Figure 12, when load current suddenly
drops, V OUT overshoots, and ITH drops quickly. The voltage
on the DTR pin will also drop quickly, since it is coupled
to the ITH pin through a capacitor. If the load transient
is fast enough that the DTR voltage drops below half of
INTV CC , a load release event is detected. The bottom gate
(BG) will be turned off, so that the inductor current flows
through the body diode in the bottom MOSFET. This al-
lows the SW node to drop below PGND by a voltage of
a forward-conducted silicon diode. This creates a more
negative differential voltage (V SW – V OUT ) across the
inductor, allowing the inductor current to drop at a faster
rate to zero, therefore creating less overshoot on V OUT .
The DTR comparator output is overridden by reverse
inductor current detection (I REV ) and overvoltage (OV)
condition. This means BG will be turned off when SENSE +
is higher than SENSE – (i.e., inductor current is positive),
SW
5V/DIV
BG
5V/DIV
BG
5V/DIV
BG REMAINS ON
DURING THE LOAD
DTR
1V/DIV
I L
10A/DIV
BG TURNS BACK ON, INDUCTOR
CURRENT (I L ) GOES NEGATIVE
ITH
1V/DIV
I L
10A/DIV
RELEASE EVENT
DTR DETECTS LOAD
RELEASE, TURNS OFF BG
FOR FASTER INDUCTOR
CURRENT (I L ) DECAY
5μs/DIV
LOAD RELEASE = 15A TO 0A
V IN = 5V
V OUT = 0.6V
LOAD RELEASE = 15A TO 0A
V IN = 5V
V OUT = 0.6V
5μs/DIV
3838 F12
(12a) DTR Enabled
(12b) DTR Disabled
Figure 12. Comparison of V OUT Overshoot with Detect Transient (DTR) Feature Enabled and Disabled
3838fa
36
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3856EUH#TRPBF | IC REG CTRLR BUCK PWM CM 38-QFN |
| SXR222M010ST | CAP ALUM 2200UF 10V 20% RADIAL |
| LTC3855EUJ#TRPBF | IC REG CTRLR BUCK PWM CM 40-QFN |
| UCY2C121MHD | CAP ALUM 120UF 160V 20% RADIAL |
| LT1950IGN | IC REG CTRLR PWM CM 16-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3838IFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3838IFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3838IUHF#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3838IUHF#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3838IUHF-1#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BUCK PWM CM 38QFN 制造商:Linear Technology 功能描述:BUCK DUAL CNTRL 4.5-38V 2MHZ 38QFN 制造商:Linear Technology 功能描述:BUCK, DUAL, CNTRL, 4.5-38V, 2MHZ, 38QFN 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Dual, Fast, Accurate Step-Down Controller with Differential 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, DUAL, BUCK, ADJ, QFN-38, Primary Input Voltage:38V, No. of Outputs:2, Output Current:25A, No. of Pins:38, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。