- 您现在的位置：买卖IC网 > PDF目录45186 > MB89PV630C-SH 8-BIT, 10 MHz, MICROCONTROLLER, CDIP64 PDF资料下载
参数资料
| 型号： | MB89PV630C-SH |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 10 MHz, MICROCONTROLLER, CDIP64 |
| 封装： | CERAMIC, MDIP-64 |
| 文件页数： | 70/153页 |
| 文件大小： | 7326K |
| 代理商： | MB89PV630C-SH |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页当前第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页
MB89630 SERIES HARDWARE MANUAL
1-16
1.7 HANDLING DEVICES
(1) Prevention of latch-up
In the CMOS IC, latch-up may occur when a voltage higher than VCC or lower than VSS is applied to
other than the middle- or high-voltage resistant input or output pins, or when voltage exceeding the
Absolute Maximum Ratings is applied between VCC and VSS pins.
When latch-up occurs, the supply current increases rapidly, sometimes resulting in overheating and
destruc tion. Therefore, no voltage exceeding the Absolute Maximum Ratings should be used.
(2) Unused input pins
Leaving unused input pins open may cause a malfunction. Therefore, these pins should be pulled up or
down with optional resistors in the Input/Output circuits. If the Input/Output circuit has no optional resis-
tor, an exter nal resistor should be used.
(3) Non-Connected pins which have internal-connection (N.C.)
Non-Connected pins which have internal-connection (N.C.) must be open when the device is used.
(4) Variations in supply voltage
Some malfunction may be caused by an abrupt change of the power supply voltage even though the
voltage is in the guaranteed range. For this reason, the power supply to the device should be stabilized.
For the stabi lization, it is recommended to keep the power supply for the VCC ripple voltage regulation
(peak-to-peak) to less than 10% of the typical VCC at the commercial frequency (50 to 60 Hz), and the
coefficient of transitional variation should be less than 0.1 V/ms at a sudden supply voltage change (e.g.
voltage switching).
(5) Precautions for external clock
It may take a little time to stabilize the clock oscillation. The stabilization time should also be considered
for an external clock during resets because all internal circuits in the device need to be initialized. So, an
external clock should be input just after power-on reset (option selection) and cancellation of stop mode.
(6) Pin processing performed when A/D converter not used
When the A/D converter is not used, the pins should be connected to be AV CC = VCC, and AVSS = AVR =
AVSS.
(7) Recommended screening conditions
The OTPROM product should be screened by high-temperature aging before mounting.
Yield of preprogrammed product
The programming test cannot be performed for all bits of the preprogrammed OTPROM product due to its
characteristics. Consequently, 100% yield of programming cannot be ensured.
相关PDF资料 |
PDF描述 |
|---|---|
| MB89P637-SH | 8-BIT, OTPROM, 10 MHz, MICROCONTROLLER, PDIP64 |
| MB89636RP-SH | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PDIP64 |
| MB89635RP-SH | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PDIP64 |
| MB89635RPF | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP64 |
| MB89PV950CF | 8-BIT, 5 MHz, MICROCONTROLLER, CQFP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MB89PV640CF | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PV650A | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PV650ACF | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PV670A | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PV670ACF | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
发布紧急采购，3分钟左右您将得到回复。