- 您现在的位置：买卖IC网 > PDF目录296481 > MBM29LV160BE12PBT-E1 (SPANSION LLC) 2M X 8 FLASH 3V PROM, 120 ns, PBGA48 PDF资料下载
参数资料
| 型号： | MBM29LV160BE12PBT-E1 |
| 厂商： | SPANSION LLC |
| 元件分类： | PROM |
| 英文描述： | 2M X 8 FLASH 3V PROM, 120 ns, PBGA48 |
| 封装： | PLASTIC, FBGA-48 |
| 文件页数： | 14/59页 |
| 文件大小： | 759K |
| 代理商： | MBM29LV160BE12PBT-E1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页
MBM29LV160TE/BE-70/90/12
21
Extended Command
(1) Fast Mode
MBM29LV160TE/BE has Fast Mode function. This mode dispenses with the initial two unlock cycles required
in the standard program command sequence writing Fast Mode command into the command register. In this
mode, the required bus cycle for programming is two cycles instead of four bus cycles in standard program
command. (Do not write erase command in this mode.) The read operation is also executed after exiting this
mode. To exit this mode, it is necessary to write Fast Mode Reset command into the command register.
(Refer to the Figure 26 Extended algorithm.) The VCC active current is required even CE = VIH during Fast
Mode.
(2) Fast Programming
During Fast Mode, the programming can be executed with two bus cycles operation. The Embedded Program
Algorithm is executed by writing program set-up command (A0H) and data write cycles (PA/PD). (Refer to
the Figure 26 Extended algorithm.)
(3) Extended Sector Protection
In addition to normal sector protection, the MBM29LV160TE/BE has Extended Sector Protection as extended
function. This function enable to protect sector by forcing VID on RESET pin and write a commnad sequence.
Unlike conventional procedure, it is not necessary to force VID and control timing for control pins. The only
RESET pin requires VID for sector protection in this mode. The extended sector protect requires VID on RESET
pin. With this condition, the operation is initiated by writing the set-up command (60H) into the command
register. Then, the sector addresses pins (A19, A18, A17, A16, A15, A14, A13 and A12) and (A6, A1, A0) = (0, 1, 0)
should be set to the sector to be protected (recommend to set VIL for the other addresses pins), and write
extended sector protect command (60H). A sector is typically protected in 250
s. To verify programming of
the protection circuitry, the sector addresses pins (A19, A18, A17, A16, A15, A14, A13 and A12) and (A6, A1, A0) =
(0, 1, 0) should be set and write a command (40H). Following the command write, a logical “1” at device
output DQ0 will produce for protected sector in the read operation. If the output data is logical “0”, please
repeat to write extended sector protect command (60H) again. To terminate the operation, it is necessary
to set RESET pin to VIH.
(4) CFI (Common Flash Memory Interface)
The CFI (Common Flash Memory Interface) specification outlines device and host system software
interrogation handshake which allows specific vendor-specified software algorithms to be used for entire
families of devices. This allows device-independent, JEDEC ID-independent, and forward-and backward-
compatible software support for the specified flash device families. Refer to CFI specification in detail.
The operation is initiated by writing the query command (98H) into the command register. Following the
command write, a read cycle from specific address retrives device information. Please note that output data
of upper byte (DQ8 to DQ15) is “0” in word mode (16 bit) read. Refer to the CFI code table. To terminate
operation, it is necessary to write the read/reset command sequence into the register.
相关PDF资料 |
PDF描述 |
|---|---|
| MBM29LV200B-10PFTR | 256K X 8 FLASH 3V PROM, 100 ns, PDSO48 |
| MBM29LV800BE70TN | 512K X 16 FLASH 3V PROM, 70 ns, PDSO48 |
| MBPL1319B-1R2-KS | 1 ELEMENT, 1.2 uH, GENERAL PURPOSE INDUCTOR |
| MBPL1319B-R30-KS | 1 ELEMENT, 0.3 uH, GENERAL PURPOSE INDUCTOR |
| MBPL1319B-R90-KS | 1 ELEMENT, 0.9 uH, GENERAL PURPOSE INDUCTOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MBM29LV160BE12PCV | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:16M (2M X 8/1M X 16) BIT |
| MBM29LV160BE12TN | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:16M (2M X 8/1M X 16) BIT |
| MBM29LV160BE12TR | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:16M (2M X 8/1M X 16) BIT |
| MBM29LV160BE-70 | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:16M (2M X 8/1M X 16) BIT |
| MBM29LV160BE70PBT | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:16M (2M X 8/1M X 16) BIT |
发布紧急采购，3分钟左右您将得到回复。