参数资料
型号: MC33910G5AC
厂商: Freescale Semiconductor
文件页数: 29/90页
文件大小: 0K
描述: IC SYSTEM BASIS CHIP 32LQFP
标准包装: 250
应用: 系统基础芯片
电流 - 电源: 4.5mA
电源电压: 5.5 V ~ 27 V
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 32-LQFP
供应商设备封装: 32-LQFP(7x7)
包装: 托盘
MC33910G5AC/MC3433910G5AC
FUNCTIONAL DEVICE OPERATIONS
OPERATIONAL MODES
Table 6. Operating Modes Overview
Function
VDD
HVDD
HSx
Analog Mux
L1
LIN
Watchdog
Voltage Monitoring
Reset Mode
Full
-
-
-
-
-
-
V SUP /V DD
Normal Request Mode
Full
SPI (58)
SPI/PWM (59)
SPI
Input
Rx-Only
150 ms (typ.) timeout
V SUP /V DD
Normal Mode
Full
SPI
SPI/PWM
SPI
Input
Full/Rx-Only
On (62) /Off
V SUP /V DD
Stop Mode
Stop
-
Note (60)
-
Wake-up
Rx-Only/Wake-up
-
V DD
Sleep Mode
-
-
Note (61)
-
Wake-up
Wake-up
-
-
Notes
58.
59.
60.
61.
62.
Operation can be enabled/controlled by the SPI.
Operation can be controlled by the PWMIN input.
HSx switches can be configured for cyclic sense operation in Stop mode.
HSx switches can be configured for cyclic sense operation in Sleep mode.
Windowing operation when enabled by an external resistor.
INTERRUPTS
Interrupts are used to signal a microcontroller that a
peripheral needs to be serviced. The interrupts which can be
generated, change according to the operating mode. While in
Normal and Normal Request modes, the 33910 signals
through interrupts special conditions which may require a
MCU software action. Interrupts are not generated until all
pending wake-up sources are read in the Interrupt Source
Register (ISR).
While in Stop mode, interrupts are used to signal wake-up
events. Sleep mode does not use interrupts. Wake-up is
performed by powering-up the MCU. In Normal and Normal
Request mode the wake-up source can be read by SPI.
The interrupts are signaled to the MCU by a low logic level
of the IRQ pin, which will remain low until the interrupt is
acknowledged by a SPI read command of the ISR register.
The IRQ pin will then be driven high.
Interrupts are only asserted while in Normal, Normal
Request and Stop mode. Interrupts are not generated while
the RST pin is low.
The following is a list of the interrupt sources in Normal and
Normal Request modes. Some of these can be masked by
writing to the SPI - Interrupt Mask Register (IMR).
Low-voltage Interrupt:
Signals when the supply line (VS1) voltage drops below
the VSUV threshold ( V SUV ).
High-voltage Interrupt:
Signals when the supply line (VS1) voltage increases
above the VSOV threshold ( V SOV ).
Over-temperature Prewarning:
Signals when the 33910 temperature has reached the pre-
shutdown warning threshold. It is used to warn the MCU that
an over-temperature shutdown in the main 5.0 V regulator is
imminent.
LIN Over-temperature Shutdown / TXD Stuck At
Dominant / RXD Short-circuit:
These signal fault conditions within the LIN interface will
cause the LIN driver to be disabled. In order to restart the
operation, the fault must be removed and TXD must go
recessive.
High Side Over-temperature Shutdown:
Signals a shutdown in the high side outputs.
33910
Analog Integrated Circuit Device Data
Freescale Semiconductor
29
相关PDF资料
PDF描述
21020-0057 CABLE FLAT FLEX 4" .50MM 6 POS
VE-B5W-EW CONVERTER MOD DC/DC 5.5V 100W
A4973SB-T IC PWM MOTOR DVR FULL 16DIP
MC33910BACR2 IC SYSTEM BASIS CHIP 32LQFP
VE-B5V-EW CONVERTER MOD DC/DC 5.8V 100W
相关代理商/技术参数
参数描述
MC33910G5ACR2 功能描述:LIN 收发器 SBC LIN 2.5G Low end RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911BAC 功能描述:LIN 收发器 SBC LIN2G MEDIUM END RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911BACR2 功能描述:LIN 收发器 SBC LIN2G MEDIUM END RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911G5AC 功能描述:LIN 收发器 SBC LIN 2.5G Medium end RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911G5ACR2 功能描述:LIN 收发器 SBC LIN 2.5G Medium end RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8