参数资料
型号: MC33910G5AC
厂商: Freescale Semiconductor
文件页数: 74/90页
文件大小: 0K
描述: IC SYSTEM BASIS CHIP 32LQFP
标准包装: 250
应用: 系统基础芯片
电流 - 电源: 4.5mA
电源电压: 5.5 V ~ 27 V
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 32-LQFP
供应商设备封装: 32-LQFP(7x7)
包装: 托盘
MC33910BAC / MC34910BAC
FUNCTIONAL DEVICE OPERATIONS
OPERATIONAL MODES
HVSE
Interrupt
Control
Module
PWMHSx
V DD
V DD
VS2
PWMIN
MOD1:2
HSx
HSxOP
HSxCL
Control
on/off
Status
High Side - Driver
charge pump
open load detection
current limitation
overtemperture shutdown (interrupt maskable)
high voltage shutdown (maskable)
HSx
Wakeup
Module
Figure 38. High Side Drivers HS1 and HS2
Open Load Detection
Each high side driver signals an open load condition if the
current through the high side is below the open load current
threshold.
The open load condition is indicated with the bits HS1OP
and HS2OP in the High Side Status Register (HSSR).
Current Limitation
Each high side driver has an output current limitation. In
combination with the over-temperature shutdown the high-
side drivers are protected against over-current and short-
circuit failures.
When the driver operates in the current limitation area, it is
indicated with the bits HS1CL and HS2CL in the HSSR.
Note: If the driver is operating in current limitation mode,
excessive power might be dissipated.
Over-temperature Protection (HS Interrupt)
Both high side drivers are protected against over-
temperature. In case of an over-temperature condition both
high side drivers are shut down and the event is latched in the
Interrupt Control Module. The shutdown is indicated as HS
Interrupt in the Interrupt Source Register (ISR).
A thermal shutdown of the high side drivers is indicated by
setting all HSxOP and HSxCL bits simultaneously.
If the bit HSM is set in the Interrupt Mask Register (IMR),
then an interrupt (IRQ) is generated.
A write to the High Side Control Register (HSCR), when
the over-temperature condition is gone, will re-enable the
high side drivers.
High-voltage Shutdown
In case of a high voltage condition and if the high voltage
shutdown is enabled (bit HVSE in the Mode Control Register
(MCR) is set) both high side drivers are shut down.
A write to the High Side Control Register (HSCR), when
the high voltage condition is gone, will re-enable the high side
drivers.
Sleep And Stop Mode
The high side driver can be enabled to operate in Sleep
and Stop mode for cyclic sensing. Also see Table 35,
33910
Analog Integrated Circuit Device Data
Freescale Semiconductor
74
相关PDF资料
PDF描述
21020-0057 CABLE FLAT FLEX 4" .50MM 6 POS
VE-B5W-EW CONVERTER MOD DC/DC 5.5V 100W
A4973SB-T IC PWM MOTOR DVR FULL 16DIP
MC33910BACR2 IC SYSTEM BASIS CHIP 32LQFP
VE-B5V-EW CONVERTER MOD DC/DC 5.8V 100W
相关代理商/技术参数
参数描述
MC33910G5ACR2 功能描述:LIN 收发器 SBC LIN 2.5G Low end RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911BAC 功能描述:LIN 收发器 SBC LIN2G MEDIUM END RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911BACR2 功能描述:LIN 收发器 SBC LIN2G MEDIUM END RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911G5AC 功能描述:LIN 收发器 SBC LIN 2.5G Medium end RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8
MC33911G5ACR2 功能描述:LIN 收发器 SBC LIN 2.5G Medium end RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8