- 您现在的位置：买卖IC网 > PDF目录45595 > MX10EXAUI (MACRONIX INTERNATIONAL CO LTD) 16-BIT, FLASH, 30 MHz, MICROCONTROLLER, PQFP44 PDF资料下载
参数资料
| 型号： | MX10EXAUI |
| 厂商： | MACRONIX INTERNATIONAL CO LTD |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, FLASH, 30 MHz, MICROCONTROLLER, PQFP44 |
| 封装： | 10 X 10 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, LQFP-44 |
| 文件页数： | 17/55页 |
| 文件大小： | 476K |
| 代理商： | MX10EXAUI |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页
24
P/N:PM0625 Specifications subject to change without notice, contact your sales representatives for the most update information. REV. 1.0, JUL. 01, 2005
MX10EXA
New Enhanced Mode 0
For timers T0 or T1 the 13-bit count mode on the 80C51
(current Mode 0) has been replaced in the XA with a 16-
bit auto-reload mode. Four additional 8-bit data registers
(two per timer: RTHn and RTLn) are created to hold the
auto-reload values. In this mode, the TH overflow will set
the TF flag in the TCON register and cause both the TL
and TH counters to be loaded from the RTL and RTH
registers respectively.
These new SFRs will also be used to hold the TL reload
data in the 8-bit auto-reload mode (Mode 2) instead of
TH.
The overflow rate for Timer 0 or Timer 1 in Mode 0 may
be calculated as follows:
Timer_Rate = Osc/(N*(65536 - Timer_Reload_Value))
where N = the TCLK prescaler value: 4 (default), 16, or
64.
Mode 1
Mode 1 is the 16-bit non-auto reload mode.
Mode 2
Mode 2 configures the Timer register as an 8-bit Counter
(TLn) with automatic reload. Overflow from TLn not only
sets TFn, but also reloads TLn with the contents of RTLn,
which is preset by software. The reload leaves THn un-
changed.
Mode 2 operation is the same for Timer/Counter 0.
The overflow rate for Timer 0 or Timer 1 in Mode 2 may
be calculated as follows:
Timer_Rate = Osc/(N * (256 - Timer_Reload_Value))
where N = the TCLK prescaler value: 4, 16, or 64.
Mode 3
Timer 1 in Mode 3 simply holds its count. The effect is
the same as setting TR1 =0.
Timer 0 in Mode 3 establishes TL0 and TH0 as two sepa-
rate counters. TL0 uses the Timer 0 control bits: CIT;
GATE, TR0, INT0, and TF0. TH0 is locked into a timer
function and takes over the use of TR1 and TF1 from
Timer 1. Thus, TH0 now controls the "Timer 1" interrupt.
Mode 3 is provided for applications requiring an extra 8-
bit timer. When Timer 0 is in Mode 3, Timer 1 can be
turned on and off by switching it out of and into its own
Mode 3, or can still be used by the serial port as a baud
rate generator, or in fact, in any application not requiring
an interrupt.
TF1
TR1
TF0
TR0
IE1
MSB
LSB
IT1
IE0
IT0
Bit Addressable
Reset Value:00H
Address:410
TCON
BIT
SYMBOL FUNCTION
TCON.7
TF1
Timer 1 overflow flag. Set by hardware on Timer/Counter overflow.
This flag will not be set if T1OE(TSTAT.2) is set.
Cleared by hardware when processor vectors to interrupt routine, or by clearing the bit
in software.
TCON.6
TR1
Timer 1 Run control bit. Set/cleared by software to turn Timer/Counter 1 on/off.
TCON.5
TF0
Timer 0 overflow flag. Set by hardware on Timer/Counter overflow.
This flag will not be set if T0OE (TSTAT.0) is set.
Cleared by hardware when processor vectors to interrupt routine, or by clearing the bit
in software.
TCON.4
TR0
Timer 0 Run control bit. Set/cleared by software to turn Timer/Counter 0 on/off.
TCON.3
IE1
Interrupt 1 Edge flag. Set by hardware when external interrupt edge detected.
Cleared when interrupt processed.
TCON.2
IT1
Interrupt 1 type control bit. Set/cleared by software to specify falling edge/low level
triggered external interrupts.
TCON.2
IE0
Interrupt 0 Edge flag. Set by hardware when external interrupt edge detected.
Cleared when interrupt processed.
TCON.0
IT0
Interrupt 0 Type control bit. Set/cleared by software to specify falling edge/tow level
triggered external interrupts.
Figure 7. Timer/Counter(TCON) Register
相关PDF资料 |
PDF描述 |
|---|---|
| MX836818 | 1 TIMER(S), REAL TIME CLOCK, PDIP24 |
| MZ4617RL2 | 2.4 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH |
| MZ4616RL2 | 2.2 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH |
| MZ4625TA2 | 5.1 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH |
| MZ4626RL | 5.6 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MX10F201FC | 制造商:MCNIX 制造商全称:Macronix International 功能描述:High-Performance and Low Power Microcontroller designed for Use Many Applications |
| MX10FMAXDPC | 制造商:MCNIX 制造商全称:Macronix International 功能描述:SINGLE-CHIP 8-BIT MICROCONTROLLER |
| MX10FMAXDQC | 制造商:MCNIX 制造商全称:Macronix International 功能描述:SINGLE-CHIP 8-BIT MICROCONTROLLER |
| MX-10G | 制造商:未知厂家 制造商全称:未知厂家 功能描述:MX |
| MX-10GC | 制造商:未知厂家 制造商全称:未知厂家 功能描述:MX |
发布紧急采购，3分钟左右您将得到回复。