- 您现在的位置：买卖IC网 > PDF目录3775 > PCA9698DGG,512 (NXP Semiconductors)IC I/O EXPANDER I2C 40B 56TSSOP PDF资料下载
参数资料
| 型号： | PCA9698DGG,512 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 39/48页 |
| 文件大小： | 0K |
| 描述： | IC I/O EXPANDER I2C 40B 56TSSOP |
| 产品培训模块： | I²C Bus Fundamentals |
| 特色产品： | NXP - I2C Interface |
| 标准包装： | 35 |
| 接口： | I²C |
| 输入/输出数： | 40 |
| 中断输出： | 是 |
| 频率 - 时钟： | 1MHz |
| 电源电压： | 2.3 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 56-TFSOP（0.240"，6.10mm 宽） |
| 供应商设备封装： | 56-TSSOP |
| 包装： | 管件 |
| 包括： | POR |
| 产品目录页面： | 826 (CN2011-ZH PDF) |
| 其它名称： | 568-3241-5 935278614512 PCA9698DGG |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页当前第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页
44
7810C–AVR–10/12
Atmel ATmega328P [Preliminary]
10. System Control and Reset
10.1
Resetting the AVR
During reset, all I/O Registers are set to their initial values, and the program starts execution
from the Reset Vector. For the ATmega328P, the instruction placed at the Reset Vector must be
an RJMP – Relative Jump – instruction to the reset handling routine. If the program never
enables an interrupt source, the Interrupt Vectors are not used, and regular program code can
be placed at these locations. This is also the case if the Reset Vector is in the Application sec-
tion while the Interrupt Vectors are in the Boot section. The circuit diagram in Figure 10-1 on
page 45 shows the reset logic. Table 28-4 on page 308 defines the electrical parameters of the
reset circuitry.
The I/O ports of the AVR are immediately reset to their initial state when a reset source goes
active. This does not require any clock source to be running.
After all reset sources have gone inactive, a delay counter is invoked, stretching the internal
reset. This allows the power to reach a stable level before normal operation starts. The time-out
period of the delay counter is defined by the user through the SUT and CKSEL Fuses. The dif-
ferent selections for the delay period are presented in “Clock Sources” on page 26.
10.2
Reset Sources
The ATmega328P has four sources of reset:
Power-on Reset. The MCU is reset when the supply voltage is below the Power-on Reset
threshold (V
POT).
External Reset. The MCU is reset when a low level is present on the RESET pin for longer than
the minimum pulse length.
Watchdog System Reset. The MCU is reset when the Watchdog Timer period expires and the
Watchdog System Reset mode is enabled.
Brown-out Reset. The MCU is reset when the supply voltage V
CC is below the Brown-out Reset
threshold (V
BOT) and the Brown-out Detector is enabled.
相关PDF资料 |
PDF描述 |
|---|---|
| PCA9506DGG,512 | IC I/O EXPANDER I2C 40B 56TSSOP |
| PCA9505DGG,112 | IC I/O EXPANDER I2C 40B 56TSSOP |
| ATTINY13-20MUR | IC MCU AVR 1K FLASH 10MHZ 20MLF |
| 5-530520-1 | CONT.HIGH CURRENT L.P. |
| 5-583875-6 | TWIN LEAF CONTACT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9698DGGS911,51 | 功能描述:I2C 接口集成电路 40-bit Fm I2C Bus I/O port w/Reset RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16 |
| PCA9698DGGT | 制造商:NXP Semiconductors 功能描述:I2C GPIO Expander 5.5V 56-Pin TSSOP T/R |
| PCA9698DGG-T | 制造商:NXP Semiconductors 功能描述:I2C GPIO Expander 5.5V 56-Pin TSSOP T/R |
| PCA96PWS911,118 | 功能描述:接口-I/O扩展器 8-BIT I2C FM QB RoHS:否 制造商:NXP Semiconductors 逻辑系列: 输入/输出端数量: 最大工作频率:100 kHz 工作电源电压:1.65 V to 5.5 V 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:HVQFN-16 封装:Reel |
| PCA9701D | 功能描述:寄存器 16BIT SPI 18V GPI INT -40 +125 RoHS:否 制造商:NXP Semiconductors 逻辑类型:CMOS 逻辑系列:HC 电路数量:1 最大时钟频率:36 MHz 传播延迟时间: 高电平输出电流:- 7.8 mA 低电平输出电流:7.8 mA 电源电压-最大:6 V 最大工作温度:+ 125 C 封装 / 箱体:SOT-38 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。