参数资料
型号: PM73487-PI
厂商: PMC-SIERRA INC
元件分类: 数字传输电路
英文描述: 622 Mbps ATM Traffic Management Device
中文描述: ATM/SONET/SDH SUPPORT CIRCUIT, PBGA503
封装: EPBGA-503
文件页数: 57/251页
文件大小: 3126K
代理商: PM73487-PI
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页当前第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页第161页第162页第163页第164页第165页第166页第167页第168页第169页第170页第171页第172页第173页第174页第175页第176页第177页第178页第179页第180页第181页第182页第183页第184页第185页第186页第187页第188页第189页第190页第191页第192页第193页第194页第195页第196页第197页第198页第199页第200页第201页第202页第203页第204页第205页第206页第207页第208页第209页第210页第211页第212页第213页第214页第215页第216页第217页第218页第219页第220页第221页第222页第223页第224页第225页第226页第227页第228页第229页第230页第231页第232页第233页第234页第235页第236页第237页第238页第239页第240页第241页第242页第243页第244页第245页第246页第247页第248页第249页第250页第251页
PM73487 QRT
PMC-Sierra, Inc.
PMC-980618
Issue 3
622 Mbps ATMTraffic Management Device
Released
Datasheet
45
3.1.2
Switch Fabric Interface
The switch fabric interface of the QRT has four nibble-wide, 50 or 66 MHz interfaces with back-
pressure to interface to QSEs (PM73488s). The device can avoid head-of-line blocking by receiv-
ing two forms of negative acknowledgment from the switch fabric. One form of negative
acknowledgment indicates congestion that is likely to be resolved on the next cell time. This is
termed a Mid-switch NACK (or Medium Negative ACKnowledgment - MNACK). When the
QRT receives an MNACK, it resends the same cell. The other form of negative acknowledgment
indicates congestion that is not likely to be resolved on the next cell time. This is termed Output
Negative ACKnowledgment (ONACK). When the QRT receives an ONACK, it skips to another
channel and sends a cell from that different channel.
3.2
The data transfers internally between the various RAMs and between the QRT and the QSE are
checked by the following mechanisms:
Memory parity checking
UTOPIA interface fault detection and recovery mechanisms
Switch fabric fault detection and recovery mechanisms
Fault Detection and Isolation
3.2.1
Memory Parity Checking
The receive and transmit buffer SDRAMs are checked by multibit parity.
All external SRAMs have parity checking. The parity conditions are checked. There are
two kinds of flags (sticky and non-sticky) set for each of these parity error conditions. The
sticky error bits are set by the error and are cleared by the processor. The corresponding
non-sticky bits are used for debugging purposes.
3.2.2
UTOPIA Interface Fault Detection and Recovery Mechanisms
The QRT uses several mechanisms to ensure cell integrity through the UTOPIA interface and to
expediently detect, isolate, and rectify fault conditions.
3.2.2.1
Header Error Check (HEC)
The receive or ingress UTOPIA interface can be configured to perform a HEC calculation
using the CHK_HEC bit in the UTOPIA_CONFIG register (refer to
section 7.2.11
“UTOPIA_CONFIG” starting on page 117
). When a HEC failure is detected and checking
is enabled, an interrupt is signaled at the processor interface and the cell is dropped at the
UTOPIA interface. Some Segmentation And Reassembly (SAR) and Physical layer
(PHY) devices do not produce the correct HEC or use the HEC for other purposes. To
connect the QRT to these devices, clear the CHK_HEC bit.
3.2.2.2
Start Of Cell (SOC) Recovery
The receive UTOPIA interface is flexible when dealing with the SOC signal sent from the
PHY layer device to the QRT. The QRT can accept a delay of up to four ATM clock
cycles in the aligned SOC and data signals after assertion of the Receive UTOPIA ATM
相关PDF资料
PDF描述
PM73487 622 Mbps ATM Traffic Management Device
PM73488-PI 5 Gbit/s ATM Switch Fabric Element
PM73488 5 Gbit/s ATM Switch Fabric Element
PM7349 Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
PM7350 Dual Serial Link, PHY Multiplexer
相关代理商/技术参数
参数描述
PM73488 制造商:PMC 制造商全称:PMC 功能描述:5 Gbit/s ATM Switch Fabric Element
PM73488PI 制造商:未知厂家 制造商全称:未知厂家 功能描述:Telecommunication IC
PM73488-PI 制造商:Rochester Electronics LLC 功能描述: 制造商:PMC-Sierra 功能描述:
PM7349 制造商:PMC 制造商全称:PMC 功能描述:Quad J2, E3 and DS-3 Framer