参数资料
型号: Q80C32-30SHXXX:RD
厂商: TEMIC SEMICONDUCTORS
元件分类: 微控制器/微处理器
英文描述: 8-BIT, 30 MHz, MICROCONTROLLER, CQFP44
文件页数: 35/83页
文件大小: 8336K
32
8021G–AVR–03/11
ATmega329P/3290P
When this Oscillator is used as the chip clock, the Watchdog Oscillator will still be used for the
Watchdog Timer and for the Reset Time-out. For more information on the pre-programmed cali-
bration value, see the section ”Calibration Byte” on page 299.
Notes:
1. The device is shipped with this option selected.
2. The frequency ranges are preliminary values.
3. If 8MHz frequency exceeds the specification of the device (depends on V
CC), the CKDIV8
Fuse can be programmed in order to divide the internal frequency by 8.
When this Oscillator is selected, start-up times are determined by the SUT Fuses as shown in
Note:
1. The device is shipped with this option selected
.
8.7
External Clock
To drive the device from an external clock source, XTAL1 should be driven as shown in Figure
8-3 on page 32. To run the device on an external clock, the CKSEL Fuses must be programmed
to “0000”.
Figure 8-3.
External Clock Drive Configuration
When this clock source is selected, start-up times are determined by the SUT Fuses as shown in
Table 8-9.
Internal Calibrated RC Oscillator Operating Modes
Frequency Range(2) (MHz)
CKSEL3...0
7.3 - 8.1
0010
Table 8-10.
Start-up times for the internal calibrated RC Oscillator clock selection
Power Conditions
Start-up Time from Power-
down and Power-save
Additional Delay from
Reset (VCC = 5.0V)
SUT1...0
BOD enabled
6 CK
14CK
00
Fast rising power
6 CK
14CK + 4.1 ms
01
Slowly rising power
6 CK
14CK + 65 ms(1)
10
Reserved
11
Table 8-11.
Crystal Oscillator Clock Frequency
CKSEL3...0
Frequency Range
ATmega329P/3290P
0000
0 - 20MHz
NC
EXTERNAL
CLOCK
SIGNAL
XTAL2
XTAL1
GND
相关PDF资料
PDF描述
Q80C32-36:R 8-BIT, 36 MHz, MICROCONTROLLER, CQFP44
Q80C32-36SHXXX:R 8-BIT, 36 MHz, MICROCONTROLLER, CQFP44
Q80C32-42:D 8-BIT, 42 MHz, MICROCONTROLLER, CQFP44
Q80C32-42:R 8-BIT, 42 MHz, MICROCONTROLLER, CQFP44
Q80C32-42SHXXX:D 8-BIT, 42 MHz, MICROCONTROLLER, CQFP44
相关代理商/技术参数
参数描述
Q80N-5 制造商:POWERBOX 制造商全称:Powerbox 功能描述:0.5 WATTS - 100 - 10KV SINGLE OUTPUT DC/DC INDUSTRIAL
Q-810 功能描述:交流电源插头和插座 NEMA L5-15P LOCKING DEVICE RoHS:否 制造商:Hirose Connector 产品:Plugs 系列: 电流额定值:3 A 电压额定值:30 V 安装角:Straight 安装风格:Cable 颜色: 端口数量:
Q81022511000000 制造商:Epson Electronics America Inc 功能描述:TF2-J4DB1 184.3200MHZ
Q811 制造商:Captive Fastener Corporation 功能描述:
Q-812 制造商:Qualtek Electronics Corporation 功能描述:NEMA TWIST-LOCK 制造商:Qualtek Electronics Corporation 功能描述:Nema St Blade Twist Lock