参数资料
型号: WBLXT975BHCA8
厂商: CORTINA SYSTEMS INC
元件分类: 网络接口
英文描述: DATACOM, ETHERNET TRANSCEIVER, PQFP160
封装: ROHS COMPLIANT, PLASTIC, MS-002DD-1, HQFP-160
文件页数: 29/76页
文件大小: 1004K
代理商: WBLXT975BHCA8
Fast Ethernet 10/100 Quad Transceivers — LXT974/LXT975
Datasheet
35
2.5.5
PMA Sublayer
2.5.5.1
Link
The LXT974/975 supports a Standard link algorithm or Enhanced link algorithm, which can be set
via bit 16.1. Link is established when the symbol error rate is less than 64 errors out of 1024
symbols received. Once the link is established:
When standard link algorithm is selected (default, bit 16.1 = 0), the link goes down when the
symbol error rate becomes greater than 64 out of 1024.
When enhanced link algorithm is selected (bit 16.1 = 1), the link goes down if twelve idle
symbols in a row are not received within 1 to 2 ms. This mode makes it more difficult to bring the
link down.
In either mode, the LXT974/975 reports link failure via the MII status bits (1.2, 18.15, and 20.13)
and interrupt functions. If auto-negotiate is enabled, link failure causes the LXT974/975 to re-
negotiate.
2.5.5.2
Link Failure Override
The LXT974/975 normally transmits 100 Mbps data packets or Idle symbols only if it detects the
link is up, and transmits only FLP bursts if the link is not up. Setting bit 19.14 = 1 overrides this
function, allowing the LXT974/975 to transmit data packets even when the link is down. This
feature is provided as a diagnostic tool. Note that auto-negotiation must be disabled to transmit data
packets in the absence of link. If auto-negotiation is enabled, the LXT974/975 automatically
begins transmitting FLP bursts if the link goes down.
2.5.5.3
Carrier Sense (CRS)
For 100TX and 100FX links, a start of stream delimiter or /J/K symbol pair causes assertion of
carrier sense (CRS). An end-of-stream delimiter, or /T/R symbol pair causes de-assertion of CRS.
The PMA layer also de-asserts CRS if IDLE symbols are received without /T/R; however, in this
case RX_ER is asserted for one clock cycle when CRS is de-asserted.
For 10T links, CRS assertion is based on reception of valid preamble, and de-assertion on reception
of an end-of-frame (EOF) marker.
2.5.6
Twisted-Pair PMD Sublayer
The twisted-pair Physical Medium Dependent (PMD) layer provides the signal scrambling and
descrambling, line coding and decoding (MLT-3 for 100TX, Manchester for 10T), as well as
receiving, polarity correction, and baseline wander correction functions.
2.5.6.1
Scrambler/Descrambler (100TX Only)
The purpose of the scrambler is to spread the signal power spectrum and further reduce EMI using
an 11-bit, non-data-dependent polynomial. The receiver automatically decodes the polynomial
whenever IDLE symbols are received.
The scrambler/descrambler can be bypassed by either setting bit 19.3 = 1 or setting pin (BYPSCR)
High. The scrambler is automatically bypassed when the fiber port is enabled. Scramber bypass is
provided for diagnostic and test support.
相关PDF资料
PDF描述
WBLXT974BHCA8 DATACOM, ETHERNET TRANSCEIVER, PQFP160
WBLXT974BHCA8 DATACOM, ETHERNET TRANSCEIVER, PQFP160
WBLXT9785EHC.C2V DATACOM, INTERFACE CIRCUIT, PQFP208
WBLXT9785EHC.D0-865110 DATACOM, INTERFACE CIRCUIT, PQFP208
WBLXT9785EHC.D0-865111 DATACOM, INTERFACE CIRCUIT, PQFP208
相关代理商/技术参数
参数描述
WBLXT9785EHC.D0865110 功能描述:IC TXRX 8PORT ETHERNET 208-HQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
WBLXT9785EHC.D0-865110 制造商:Cortina Systems Inc 功能描述:PHY 8-CH 10Mbps/100Mbps 208-Pin PQFP
WBLXT9785EHC.D0-865111 制造商:Cortina Systems Inc 功能描述:PHY 8-CH 10Mbps/100Mbps 208-Pin PQFP
WBLXT9785HC.D0 功能描述:IC TXRX 8PORT ETHERNET 208-HQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
WBLXT9785HC.D0-865112 功能描述:TXRX ETH OCT LP COMM 208-HQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422,RS485 电源电压:4.75 V ~ 5.25 V 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 供应商设备封装:8-PDIP 包装:管件 产品目录页面:1402 (CN2011-ZH PDF)