参数资料
型号: WLA49VVA
厂商: National Semiconductor Corporation
元件分类: ADC
英文描述: Audio Sub-System with Dual-Mode Stereo Headphone and Mono High Efficiency Loudspeaker Amplifiers and Multi-Purpose ADC
中文描述: 音频子系统的双模单声道立体声耳机和扬声器放大器的高效率和多功能模数转换器
文件页数: 44/112页
文件大小: 5017K
代理商: WLA49VVA
12.0 Status & Control Registers (Continued)
12.16 MIC_1 CONFIGURATION REGISTER
This register is used to control the microphone configuration.
TABLE 16. MIC_1 (0x0Bh)
Bits
Field
Description
3:0
PREAMP_GAIN
Programs the gain applied to the microphone preamplifier if the AGC is not in use.
PREAMP_GAIN
Gain
0000
2
6dB
0001
2
8dB
0010
2
10 dB
0011
2
12 dB
0100
2 to 11002
14 dB to 30 dB
1101
2
32 dB
1110
2
34 dB
1111
2
36 dB
4
MIC_MUTE
If set the microphone preamplifier is muted.
5
INT_SE_DIFF
If set the internal microphone is assumed to be single ended and the negative connection is
connected to the ADC common mode point internally. This allows a single-ended internal
microphone to be used.
6
INT_EXT
If set the single ended external microphone is used and the negative microphone input is grounded
internally, otherwise internal microphone operation is assumed. (Note 19)
Note 19: On changing INT_EXT from internal to external note that the dc blocking cap will not be charged so some time should be taken (300 ms fora1F cap)
between the detection of an external headset and the switching of the output stages and ADC to that input to allow the DC points on either side of this cap to stabilize.
This can be accomplished by deselecting the microphone input from the audio outputs and ADC until the DC points stabilize.
An active MIC path to CPOUT or the ADC may result in the microphone DC blocking caps causing audio pops under the following situations:
1) Switching between internal and external microphone operation while in chip modes ’10’ or ’11’.
2) Toggling in and out of powerdown/standby modes.
3) Toggling between chip modes ’10’ and ’11’ whenever external microphone operation is selected.
4) The insertion/removal of a headset while in chip modes ’10’ or ’11’ whenever external microphone operation is selected.
To avoid these potential pop issues, it is recommended to deselect the microphone input from CPOUT and ADC until the DC points stabilize.
LM4935
www.national.com
37
相关PDF资料
PDF描述
WMS512K8-55CI 512Kx8 MONOLITHIC SRAM
WMS512K8-55CIA 512Kx8 MONOLITHIC SRAM
WMS512K8-55CLC 512Kx8 MONOLITHIC SRAM
WMS512K8-55CLI 512Kx8 MONOLITHIC SRAM
WMS512K8-55CLIA 512Kx8 MONOLITHIC SRAM
相关代理商/技术参数
参数描述
WL-A-7079B-12 制造商:WAMCO 功能描述:12V 40W AV REFL GG12A BAY15S 制造商:WAMCO 功能描述:12V 40W AV REFL GG12A BAY15s
WL-A-7079B-24 制造商:WAMCO 功能描述:28V 40W AV REFL GG12A BAY15S
WL-A-7512-12 制造商:WAMCO 功能描述:14V 26W AV REFL GG10 BAY15S
WL-A-7512-24 制造商:WAMCO 功能描述:28V 26W AV REFL GG10 BAY15S
WL-A-7796A-24 制造商:WAMCO 功能描述:28V 14W/40W AV REFL GG12A BAY15D DUAL FILAMENT