- 您现在的位置：买卖IC网 > PDF目录16514 > XR17V252IM-0A-EVB (Exar Corporation)EVAL BOARD FOR XR17V252 100TQFP PDF资料下载
参数资料
| 型号： | XR17V252IM-0A-EVB |
| 厂商： | Exar Corporation |
| 文件页数： | 10/69页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR XR17V252 100TQFP |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页
XR17V252
18
66 MHZ PCI BUS DUAL UART WITH POWER MANAGEMENT SUPPORT
REV. 1.0.2
TIMERCNTL [7:0] Register
The bits [3:0] of this register are used to issue commands. The commands are self-clearing, so reading this
register does not show the last written command. Reading this register returns a value of 0x01 when the Timer
interrupt is enabled and there is a pending Timer interrupt. It returns a value of 0x00 at all other times. The
default settings of the Timer, upon power-up, a hardware reset or upon the issue of a ’Timer Reset’ command
are:
■ Timer Interrupt Disabled
■ Re-triggerable mode selected
■ Internal crystal oscillator outputs selcted as clock source
■ Timer output not routed to MPIO[0]
■ Timer stopped
TIMER OPERATION
The following paragraphs describe the operation of the 16-bit Timer/Counter. The following conventions will be
used in this discussion:
■ ’N’ is the 16-bit value programmed in the TIMER MSB, LSB registers
■ P +Q = N, where ’P’ and ’Q’ are approximately half of ’N’.
■ If N is even, P = Q = N/2.
■ If N is odd, P = (N – 1)/2 and Q = (N + 1)/2.
■ ‘N’ can take any value from 0x0002 to 0xFFFF.
Timer Operation in One-Shot Mode:
In the one-shot mode, the Timer output will stay HIGH when started (default state) and will continue to stay
HIGH until it times out (reaches the terminal count of ‘N’ clocks), at which time it will become LOW and stay
LOW. If the Timer is re-started before the Timer times out, the counter is reset and the Timer will wait for
another time-out period before setting its output LOW (See Figure 7). If the Timer times out, re-starting the
Timer does not have any effect and a ’Stop Timer’ command needs to be issued first which will set the Timer
output to its default HIGH state. The Timer must be programmed while it is stopped since the following
operations are blocked after the Timer has been started:
■ Any write to TIMER MSB, LSB registers
■ Issue of any command other than ’Start Timer’, ’Stop Timer’ and ’Reset Timer’
TABLE 10: TIMER CONTROL REGISTERS
TIMERCNTL [7:4]
Reserved
TIMERCNTL [3:0]
These bits are used to invoke a series of commands that control the function of the Timer/Counter.
The commands 1100 to 1111 are reserved.
0001: Enable Timer Interrupt
0010: Disable Timer Interrupt
0011: Select One-shot mode
0100: Select Re-triggerable mode
0101: Select Internal Crystal Oscillator output as clock input for the Timer
0110: Select External Clock input through the TMRCK pin for the Timer
0111: Route Timer output to MPIO[0] pin
1000: De-route Timer output from MPIO[0]
1001: Start Timer
1010: Stop Timer
1011: Reset Timer
相关PDF资料 |
PDF描述 |
|---|---|
| 6278890-4 | C/A 62.5 OFNR MTRJ-MTRJ RED SEC |
| 6374656-4 | C/A LC TO LC MM 2.0MM 4M |
| VE-J5R-EX | CONVERTER MOD DC/DC 7.5V 75W |
| RBC26DRXN | CONN EDGECARD 52POS DIP .100 SLD |
| RBM15DTMN | CONN EDGECARD 30POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR17V252IM-F | 功能描述:UART 接口集成电路 66MHz Dual PCI UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR17V252IMTR-F | 制造商:Exar Corporation 功能描述:UART 2-CH 64Byte FIFO 3.3V 100-Pin TQFP T/R 制造商:Exar Corporation 功能描述:XR17V252IMTR-F |
| XR17V254 | 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT |
| XR17V254_08 | 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT |
| XR17V254IV | 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT |
发布紧急采购，3分钟左右您将得到回复。