- 您现在的位置：买卖IC网 > PDF目录16514 > XR17V252IM-0A-EVB (Exar Corporation)EVAL BOARD FOR XR17V252 100TQFP PDF资料下载
参数资料
| 型号： | XR17V252IM-0A-EVB |
| 厂商： | Exar Corporation |
| 文件页数： | 14/69页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR XR17V252 100TQFP |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页
XR17V252
21
REV. 1.0.2
66 MHZ PCI BUS DUAL UART WITH POWER MANAGEMENT SUPPORT
The 8-bit Sleep register enables each UART separately to enter Sleep mode. Sleep mode reduces power
consumption when the system needs to put the UART(s) to idle. The UART enters sleep mode when the
following conditions are satisfied after the sleep mode is enabled (LOW (default) is to disable and logic HIGH is
to enable sleep mode):
■ There is no pending interrupt
■ RX pin is idling at a HIGH in normal mode or a LOW in infrared mode
■ The modem inputs (CTS#, DSR#, CD# and RI#) are steady at either HIGH or LOW (MSR bits [3:0] =
0000)
When both UART channels are put to sleep, the on-chip oscillator shuts off to further conserve power. In this
case, the V252 is awakened by any of the following events occurring at any of the 2 UART channels:
■ A receive data start bit transition (HIGH to LOW in normal mode or from LOW to HIGH in infrared mode)
■ A data byte is loaded into the transmitter
■ A change of logic state on any of the modem inputs, i.e. any of the delta bits (MSR bits[7:4]) is set
The V252 is ready after 32 crystal clocks to ensure full functionality. Therefore, if the V252 is awakened by a
receive data start bit transition, that character (and the subsequent few characters) may not be received
correctly. Also, a special interrupt is generated with an indication of no pending interrupt. The V252 will return
to sleep mode automatically after all interrupting conditions have been serviced and cleared. It will stay in the
sleep mode of operation until it is disabled by resetting the SLEEP register bits.
1.6.7
Device Identification and Revision
There are two internal registers that provide device identification and revision, DVID and DREV registers. The
8-bit content in the DVID register provides device identification. A return value of 0x42 from this register
indicates the device is a XR17V252. The DREV register returns an 8-bit value of 0x01 for revision A with 0x02
equals to revision B and so on. This information is very useful to the software driver for identifying which device
it is communicating with and to keep up with revision changes.
DVID [15:8]
Device identification for the type of UART. The Device ID of the XR17V252 is 0x42.
DREV [7:0]
Revision number of the XR17V252. A 0x01 represents "revision-A" with 0x02 for rev-B and so on.
REGB [23:16] (default 0x00)
REGB register provides a control for simultaneous write to both UARTs configuration register or individually.
This is very useful for device initialization in the power up and reset routines. Also, the register provides a
facility to interface to the non-volatile memory device such as a 93C46 EEPROM. In embedded applications,
the user can use this facility to store proprietary data in an external EEPROM.
1.6.8
REGB Register
REGB[16](Read/Write)
LOW (default) write to each UART configuration registers individually.
HIGH enables simultaneous write to both UARTs configuration register.
REGB[19:17]
Reserved
REGB[20] (Write-Only)
Control the EECK, clock, output (pin 116) on the EEPROM interface.
REGB[21] (Write-Only)
Control the EECS, chips select, output (pin 115) to the EEPROM device.
REGB[22] (Write-Only)
EEDI (pin 114) data input. Write data to the EEPROM device.
REGB[23] (Read-Only)
EEDO (pin 113) data output. Read data from the EEPROM device.
相关PDF资料 |
PDF描述 |
|---|---|
| 6278890-4 | C/A 62.5 OFNR MTRJ-MTRJ RED SEC |
| 6374656-4 | C/A LC TO LC MM 2.0MM 4M |
| VE-J5R-EX | CONVERTER MOD DC/DC 7.5V 75W |
| RBC26DRXN | CONN EDGECARD 52POS DIP .100 SLD |
| RBM15DTMN | CONN EDGECARD 30POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XR17V252IM-F | 功能描述:UART 接口集成电路 66MHz Dual PCI UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| XR17V252IMTR-F | 制造商:Exar Corporation 功能描述:UART 2-CH 64Byte FIFO 3.3V 100-Pin TQFP T/R 制造商:Exar Corporation 功能描述:XR17V252IMTR-F |
| XR17V254 | 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT |
| XR17V254_08 | 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT |
| XR17V254IV | 制造商:EXAR 制造商全称:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT |
发布紧急采购，3分钟左右您将得到回复。