参数资料
| 型号： | XRT72L71IQ |
| 厂商： | Exar Corporation |
| 文件页数： | 7/102页 |
| 文件大小： | 0K |
| 描述： | IC FRAMER DS3 ATM UNI 160PQFP |
| 产品变化通告： | XRT72Lx Series Obsolescence 02/May/2012 |
| 标准包装： | 24 |
| 控制器类型： | DS3 ATM UNI，透明通道调帧器 |
| 电源电压： | 3.3V |
| 电流 - 电源： | 120mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 160-BQFP |
| 供应商设备封装： | 160-PQFP（28x28） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页
XRT72L71
á
DS3 ATM UNI/CLEAR CHANNEL FRAMER
REV. 1.1.0
8
28
LLOOP
O
Local Loop-back Output Pin (to the XRT7300 E3/DS3/STS-1 LIU IC): This
output pin is intended to be connected to the LLOOP input pin of the XRT7300
LIU IC. This input pin, along with “RLOOP” (pin 26) permits the user to config-
ure the XRT7300 LIU IC to operate in either of the following three (3) loop-
back modes.
Analog Local Loop-Back Mode
Digital Local Loop-Back Mode
Remote Loop-Back Mode.
Writing a “1” to bit 1 of the “Line Interface Drive Register” (Address = 0x72) will
cause this output pin to toggle “High”. Writing a “0” to this bit-field will cause
the RLOOP output to toggle “Low”.
NOTE: If the user is not using the XRT7300 DS3/E3/STS-1 LIU IC, then this
output pin can be used for other purposes.
29
Int
O
Interrupt Request Output: This open-drain, active-”Low” output signal will be
asserted when the UNI/Framer is requesting interrupt service from the local
microprocessor. This output pin should typically be connected to the “Interrupt
Request” input of the local microprocessor.
30
RxLCD
O
Loss of Cell Delineation Indicator: This active-"High" output pin will be
asserted whenever the Receive Cell Processor has experienced a “Loss of
Cell Delineation”. This pin will return “Low” once the Receive Cell Processor
has regained Cell Delineation.
NOTE: This output pin is only active if the XRT72L71 has been configured to
operate in the “ATM UNI” Mode.
31
GND
***
Ground Pin Signal
32
CS
I
Chip Select Input: This active-”Low” input signal selects the Microprocessor
Interface Section of the UNI/Framer and enables Read/Write operations
between the “local” microprocessor and the UNI/Framer on-chip registers and
RAM locations.
33
RD_DS
I
Read Data Strobe (Intel Mode): If the microprocessor interface is operating
in the Intel Mode, then this input will function as the RD (READ STROBE)
input signal from the local
P. Once this active-”Low” signal is asserted, then
the UNI/Framer will place the contents of the addressed registers (within the
UNI/Framer IC) on the Microprocessor Data Bus (D[15:0]). When this signal is
negated, the Data Bus will be tri-stated.
Data Strobe (Motorola Mode): If the microprocessor interface is operating in
the Motorola mode, then this pin will function as the active-”Low” Data Strobe
signal.
34
RxGFC
O
Receive GFC Nibble Field Serial Output pin: This pin, along with the RxG-
FCClk and the RxGFCMSB pins form the “Receive GFC Nibble-Field” serial
output port. This pin will serially output the contents of the GFC Nibble field of
each cell that is processed through the Receive Cell Processor. This data is
serially clocked out of this pin on the rising edge of the RxGFCClk signal. The
Most Significant Bit (MSB) of each GFC value is designated by a pulse at the
RxGFCMSB output pin.
NOTE: This output pin is only active if the XRT72L71 has been configured to
operate in the “ATM UNI” Mode.
PIN DESCRIPTION (CONTINUED)
PIN NO.
SYMBOL
TYPE
DESCRIPTION
相关PDF资料 |
PDF描述 |
|---|---|
| XRT73L02MIV-F | IC LIU E3/DS3/STS-1 2CH 100TQFP |
| XRT73L03BIV-F | IC LIU E3/DS3/STS-1 3CH 120LQFP |
| XRT73L04BIV-F | IC LIU E3/DS3/STS-1 4CH 144LQFP |
| XRT73L06IB-F | IC LIU E3/DS3/STS-1 6CH 217BGA |
| XRT73LC00AIV-F | IC LIU STS1/DS3/E3 SGL 44TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT72L71IQ-F | 功能描述:网络控制器与处理器 IC Single CH DS3 UNI (3.3V) RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| XRT72L73IB | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Telecommunication IC |
| XRT72L74IB | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Telecommunication IC |
| XRT7300 | 制造商:EXAR 制造商全称:EXAR 功能描述:E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT7300ES | 功能描述:网络控制器与处理器 IC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。