- 您现在的位置：买卖IC网 > PDF目录13288 > ZL2004ALNNT1 (Intersil)IC REG CTRLR BUCK SYNC ADJ 32QFN PDF资料下载
参数资料
| 型号： | ZL2004ALNNT1 |
| 厂商： | Intersil |
| 文件页数： | 36/42页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK SYNC ADJ 32QFN |
| 标准包装： | 1,000 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | * |
| 占空比： | 95% |
| 电源电压： | 4.5 V ~ 14 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页
ZL2004
6.16 Phase Adding/Dropping
The ZL2004 allows multiple power converters to be
connected in parallel to supply higher load currents
V REFERENCE
V MEMBER
-R
-R
than can be addressed using a single-phase design. In
doing so, the power converter is optimized at a load
current range that requires all phases to be operational.
During periods of light loading, it may be beneficial to
disable one or more phases in order to eliminate the
current drain and switching losses associated with
those phases, resulting in higher efficiency.
The ZL2004 offers the ability to add and drop phases
I MEMBER
I OUT
I REFERENCE
using a simple command in response to an observed
load current change, enabling the system to
Figure 20. Active Current Sharing
slopes, the member voltage is increased towards the
reference voltage which closes the gap between the
inductor currents.
The relation between reference and member current
and voltage is given by the following equation:
continuously optimize overall efficiency across a wide
load range. All phases in a current share rail are
considered active prior to the current sharing rail ramp
to power-good.
Phases can be dropped after power-good is reached.
Any member of the current sharing rail can be
dropped. If the reference device is dropped, the
remaining active device with the lowest member
position will become the new reference.
V member
V OUT
R
I REFERENCE I MEMBER
Additionally, any change to the number of members of
6.17 Monitoring via I C/SMBus
where R is the value of the droop resistance.
The ISHARE_CONFIG command is used to configure
the device for active current sharing. The default
setting is a stand-alone non-current sharing device. A
current sharing rail can be part of a system sequencing
group.
For fault configuration, the current share rail is
configured in a quasi-redundant mode. In this mode,
when a member device fails, the remaining members
will continue to operate and attempt to maintain
regulation. The device with the lowest member
position will become the reference. If fault spreading is
enabled, the current share rail failure is not broadcast
until the entire current share rail fails.
Up to eight (8) devices can be configured in a given
current sharing rail.
36
a current sharing rail will precipitate autonomous phase
distribution within the rail where all active phases
realign their phase position based on their order within
the number of active members.
If the members of a current sharing rail are forced to
shut down due to an observed fault, all members of the
rail will attempt to re-start simultaneously after the
fault has cleared.
2
A system controller can monitor a wide variety of
different ZL2004 system parameters through the
I 2 C/SMBus interface. The device can monitor for fault
conditions by monitoring the SALRT pin, which will
be asserted when any number of pre-configured fault
conditions occur.
FN6846.3
February 15, 2011
相关PDF资料 |
PDF描述 |
|---|---|
| RGM31DTKT | CONN EDGECARD 62POS DIP .156 SLD |
| VI-J73-EX-F3 | CONVERTER MOD DC/DC 24V 75W |
| RSC19DRYI-S734 | CONN EDGECARD 38POS DIP .100 SLD |
| ZL2004ALNNT-01 | IC REG CTRLR BUCK SYNC ADJ 32QFN |
| RYM31DTKS | CONN EDGECARD 62POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ZL2004ALNNT1-01 | 功能描述:IC REG CTRLR BUCK SYNC ADJ 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ZL2004EVK1 | 功能描述:KIT EVAL FOR ZL2004 RoHS:否 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:* 标准包装:1 系列:- 主要目的:DC/DC，步降 输出及类型:1，非隔离 功率 - 输出:- 输出电压:3.3V 电流 - 输出:3A 输入电压:4.5 V ~ 28 V 稳压器拓扑结构:降压 频率 - 开关:250kHz 板类型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名称:497-12113STEVAL-ISA094V1-ND |
| ZL2005 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Digital-DC? Integrated Power Management and Conversion IC |
| ZL2005ALNF | 制造商:Intersil Corporation 功能描述:DIGITAL DC-DC CONTROLLER W/ DRIVERS - TRAY100 - Trays 制造商:Intersil Corporation 功能描述:IC REG CNTRLR BUCK PWM 36-QFN 制造商:Intersil Corporation 功能描述:Digital DC-DC Controller w/ Drivers - BULK 50 |
| ZL2005ALNFT | 功能描述:电压模式 PWM 控制器 DIGTL DC-DC CNTRLR W/DRVRS TR100 RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。