- 您现在的位置：买卖IC网 > PDF目录20400 > DC1663A (Linear Technology)DEMO BOARD LTM4628 PDF资料下载
参数资料
| 型号： | DC1663A |
| 厂商： | Linear Technology |
| 文件页数： | 10/36页 |
| 文件大小： | 0K |
| 描述： | DEMO BOARD LTM4628 |
| 软件下载： | LTM4628 Spice Model |
| 设计资源： | LTM4628 Gerber Files DC1663A Design Files |
| 标准包装： | 1 |
| 系列： | µModule® |
| 主要目的： | DC/DC，步降 |
| 输出及类型： | 2，非隔离 |
| 输出电压： | 1.2V，1.5V |
| 电流 - 输出： | 8A，8A |
| 输入电压： | 4.5 ~ 26.5 V |
| 稳压器拓扑结构： | 降压 |
| 频率 - 开关： | 400kHz |
| 板类型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | LTM4628 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTM4628
OPERATION
Power Module Description
The LTM4628 is a dual-output standalone nonisolated
switching mode DC/DC power supply. It can provide two
8A outputs with few external input and output capacitors
and setup components. This module provides precisely
regulated output voltages programmable via external
resistors from 0.6V DC to 5V DC over 4.5V to 26.5V input
voltages. The typical application schematic is shown in
Figure 28.
The LTM4628 has dual integrated constant-frequency cur-
rent mode regulators and built-in power MOSFET devices
with fast switching speed. The typical switching frequency
is 550kHz. For switching-noise sensitive applications, it
can be externally synchronized from 400kHz to 780kHz.
A resistor can be used to program a free run frequency
on the f SET pin. See the Applications Information section.
With current mode control and internal feedback loop
compensation, the LTM4628 module has sufficient stabil-
ity margins and good transient performance with a wide
range of output capacitors, even with all ceramic output
capacitors.
Current mode control provides cycle-by-cycle fast current
limit and foldback current limit in an overcurrent condition.
Internal overvoltage and undervoltage comparators pull
the open-drain PGOOD outputs low if the output feedback
voltage exits a ±7.5% window around the regulation point.
If the output voltage exceeds 10% above its normal op-
erating point then the bottom power MOSFET will try to
clamp the output to protect it.
Pulling the RUN pins below 1.1V forces the regulators into
a shutdown state, by turning off both MOSFETs. The TRACK
pins are used for programming the output voltage ramp and
voltage tracking during start-up or used for soft-starting
the regulator. See the Applications Information section.
The LTM4628 is internally compensated to be stable over
all operating conditions. Table 2 provides a guideline
for input and output capacitances for several operating
conditions. LTpowerCAD? is available for transient and
stability analysis. The V FB pin is used to program the
output voltage with a single external resistor to ground.
A differential remote sense amplifier is available for sens-
ing the output voltage accurately on one of the outputs at
the load point, or in parallel operation sensing the output
voltage at the load point.
Multiphase operation can be easily employed with the
MODE_PLLIN, PHASMD, and CLKOUT pins. Up to 12
phases can be cascaded to run simultaneously with re-
spect to each other by programming the PHASMD pin to
different levels. See the Applications Information section.
High efficiency at light loads can be accomplished with
selectable Burst Mode operation or pulse-skipping
operation using the MODE_PLLIN pin. These light load
features will accommodate battery operation. Efficiency
graphs are provided for light load operation in the Typical
Performance Characteristics section. See the Applications
Information section for details.
A temperature diode is included inside the module to moni-
tor the temperature of the module. See the Applications
Information section for details.
The switch pins are available for functional operation
monitoring and a resistor-capacitor snubber circuit can
be carefully placed on the switch pin to ground to dampen
any high frequency ringing on the transition edges. See
the Applications Information section for details.
4628fe
10
For more information www.linear.com/LTM4628
相关PDF资料 |
PDF描述 |
|---|---|
| IFSC1008ABER220M01 | INDUCTOR POWER 22UH 0.5A SMD |
| GSC10DRYI | CONN EDGECARD 20POS DIP .100 SLD |
| AT24C08B-TH-T | IC EEPROM 8KBIT 1MHZ 8TSSOP |
| T95Z226K016LSAL | CAP TANT 22UF 16V 10% 2910 |
| 346-080-540-202 | CARDEDGE 80POS DUAL .125 GREEN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DC1666A | 功能描述:BOARD DEMO LED DRIVER LT3791 RoHS:否 类别:编程器，开发系统 >> 评估板 - LED 驱动器 系列:- 标准包装:1 系列:PowerWise® 电流 - 输出 / 通道:20mA 输出及类型:1，非隔离 输出电压:17V 特点:可调光 输入电压:2.7 ~ 5.5 V 已供物品:板 已用 IC / 零件:LM3508 相关产品:LM3508TLX-ND - IC LED DRVR WHT BCKLGT 9USMDLM3508TLDKR-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLCT-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLTR-ND - IC LED DRVR WHT BCKLGT 9MICROSMD |
| DC1667 | 制造商:INTRONICS 制造商全称:INTRONICS 功能描述:15 Watt Triple Output DC-DC Converters |
| DC1668 | 制造商:INTRONICS 制造商全称:INTRONICS 功能描述:15 Watt Triple Output DC-DC Converters |
| DC1669 | 制造商:INTRONICS 制造商全称:INTRONICS 功能描述:15 Watt Triple Output DC-DC Converters |
| DC1669A | 功能描述:BOARD EVAL LTM4627 RoHS:否 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:LTM®, uModule® 标准包装:1 系列:- 主要目的:DC/DC，步降 输出及类型:1，非隔离 功率 - 输出:- 输出电压:3.3V 电流 - 输出:3A 输入电压:4.5 V ~ 28 V 稳压器拓扑结构:降压 频率 - 开关:250kHz 板类型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名称:497-12113STEVAL-ISA094V1-ND |
发布紧急采购，3分钟左右您将得到回复。