参数资料
型号: DR-TRC105-450-EV
厂商: RFM
文件页数: 6/67页
文件大小: 0K
描述: BOARD EVALUATION 450MHZ RFM RFIC
标准包装: 1
类型: 收发器
频率: 447MHz ~ 451MHz
适用于相关产品: TRC105
已供物品: 2 个板,天线,电池
?
?
A two-stage IF filter followed by an amplifier chain for both the I and Q channels. Limiters at the end of
each chain drive the I and Q inputs to the FSK demodulator function. An RSSI signal is also derived from
the I and Q IF amplifiers to drive the OOK detector. The second filter stage in each channel can be con-
figured as either a third-order Butterworth low-pass filter for FSK operation or an image reject polyphase
band-pass filter for OOK operation.
An FSK arctangent type demodulator driven from the I and Q limiter outputs, and an OOK demodulator
driven by the RSSI signal. Either detector can drive a data and clock recovery function that provides
matched filter enhancement of the demodulated data.
The transmitter chain is based on the same double-conversion architecture and uses the same intermediate fre-
quencies as the receiver chain. The main blocks include:
?
?
?
A digital waveform generator that provides the I and Q base-band signals. This block includes digital-to-
analog converters and anti-aliasing low-pass filters.
A compound image-rejection mixer to up convert the base-band signal to the first IF at 1/9th of the carrier
frequency, and a second image-rejection mixer to up-convert the IF signal to the RF frequency
Transmitter driver and power amplifier stages to drive the antenna port
The frequency synthesizer is based on an integer-N PLL having a typical frequency step size of 12.5 kHz. Two
programmable frequency dividers in the feedback loop of the PLL and one programmable divider on the reference
oscillator allow the LO frequency to be adjusted. The reference frequency is generated by a crystal oscillator run-
ning at 12.8 MHz.
The TRC105 is controlled by a digital block that includes registers to store the configuration settings of the radio.
These registers are accessed by a host microcontroller through an SPI style serial interface. The microcon troller’s
serial connections to the TRC105’s SDI, SDO and SCK pins are shown in Figure 2 (component values shown are
for 418.00-434.79 MHz operation; see Tables 57 and 58 for other frequency bands). On-chip regulators provide
stable supply voltages to sensitive blocks and allow the TRC105 to be used with supply voltages from 2.1 to
3.6 V. Most blocks are supplied with a voltage below 1.6 V.
C17
1.2 pF
C16
DNP
Figure 2
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 6 of 67
TRC105 - 05/29/13
相关PDF资料
PDF描述
DR-TXC100-433 BOARD EVALUATION 433MHZ TXC100
DR-WLS1273L-EV KIT EVAL FOR WLS1273L
DR7000-DK 3G DEVELOPMENT KIT 433.92MHZ
DR7001-DK 3G DEVELOPMENT KIT 315 MHZ
DR7003-DK 3G DEVELOPMENT KIT 303.825 MHZ
相关代理商/技术参数
参数描述
DRTU06D06 功能描述:时间延迟和计时继电器 180-240VAC/DC 1-60VDC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail
DRTU24A06 功能描述:时间延迟和计时继电器 180-240VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail
DRTU24A06R 功能描述:时间延迟和计时继电器 90-140VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail
DRTU24B06 功能描述:时间延迟和计时继电器 90-140VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail
DRTU24B06R 功能描述:时间延迟和计时继电器 2-24VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail