- 您现在的位置：买卖IC网 > Datasheet目录409 > DR-TRC105-450-EV (RFM)BOARD EVALUATION 450MHZ RFM RFIC Datasheet资料下载
参数资料
| 型号： | DR-TRC105-450-EV |
| 厂商： | RFM |
| 文件页数： | 8/67页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION 450MHZ RFM RFIC |
| 标准包装： | 1 |
| 类型： | 收发器 |
| 频率： | 447MHz ~ 451MHz |
| 适用于相关产品： | TRC105 |
| 已供物品： | 2 个板，天线，电池 |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页
OOK modulation is performed by switching on and off the power amplifier and its regulator. The rise and fall times
of the OOK signal can be configured in register MCFG05_PA_Ramp[7..6] , which controls the charge and dis-
charge time of the regulator. Figure 4 shows the time constants set by MCFG05_PA_Ramp[7..6]. Table 2 gives
typical values of the rise and fall times as defined in Figure 4 when the capacitance connected to the output of the
regulator is 0.047 μF.
Figure 4
2.3 Receiver
The TRC105 is set to receive mode when MCFG00_Chip_Mode[7..5] is set to 011. The receiver is based on a
double-conversion architecture. The front-end is composed of an LNA and a mixer whose gains are constant. The
mixer down-converts the RF signal to an intermediate frequency which is equal to 1/8 of the LO frequency, which
in turn is equal to 8/9 of the RF frequency. Behind this first mixer there is a variable gain IF amplifier that can be
programmed from maximum gain to 13.5 dB less in 4.5 dB steps with the MCFG01_IF_Gain[1..0] register.
After the variable gain IF amplifier, the signal is down-converted into two I and Q base-band signals by two quad-
rature mixers which are fed by reference signals at 1/8 the LO frequency. These I and Q signals are then filtered
and amplified before demodulation. The first filter is a second-order passive R-C filter whose bandwidth can be
programmed to 16 values with the register RXCFG10_LP_filt[7..4] . The second filter can be configured as either
a third-order Butterworth active filter which acts as a low-pass filter for the zero-IF FSK configuration, or as a pol-
yphase band-pass filter for the low-IF OOK configuration. To select Butterworth low-pass filter operation, bit
RXCFG12_PolyFilt_En[7] is set to 0. The bandwidth of the Butterworth filter can be programmed to 16 values
with the register RXCFG10_BW_Filt[3..0] . The low-IF configuration must be used for OOK modulation. This con-
figuration is enabled when the bit RXCFG12_PolyFilt_En[7] is set to 1. The center frequency of the polyphase
filter can be programmed to 16 values with the register RXCFG11_PolyFilt[7..4] . The bandwidth of the filter can
be programmed with the register RXCFG10_BW_Filt[3..0] . In OOK mode, the value of the low-IF is equal to the
deviation frequency defined in register MCFG02_Freq_dev . In addition to channel filtering, the function of the
polyphase filter is to reject the image. Figure 5 below shows the two configurations of the second IF filter. In the
Butterworth configuration, F CBW is the 3 dB cutoff frequency. In the polyphase band-pass configuration F OPP is the
center frequency given by RXCFG11_PolyFilt[7..4] , and F CPP is the upper 3 dB bandwidth of the filter whose off-
set, referenced to F OPP , is given by RXCFG10_BW_Filt[3..0].
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 8 of 67
TRC105 - 05/29/13
相关PDF资料 |
PDF描述 |
|---|---|
| DR-TXC100-433 | BOARD EVALUATION 433MHZ TXC100 |
| DR-WLS1273L-EV | KIT EVAL FOR WLS1273L |
| DR7000-DK | 3G DEVELOPMENT KIT 433.92MHZ |
| DR7001-DK | 3G DEVELOPMENT KIT 315 MHZ |
| DR7003-DK | 3G DEVELOPMENT KIT 303.825 MHZ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DRTU06D06 | 功能描述:时间延迟和计时继电器 180-240VAC/DC 1-60VDC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail |
| DRTU24A06 | 功能描述:时间延迟和计时继电器 180-240VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail |
| DRTU24A06R | 功能描述:时间延迟和计时继电器 90-140VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail |
| DRTU24B06 | 功能描述:时间延迟和计时继电器 90-140VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail |
| DRTU24B06R | 功能描述:时间延迟和计时继电器 2-24VAC/DC 24-280VAC 6A RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail |
发布紧急采购，3分钟左右您将得到回复。